In this letter, we propose a novel activation treatment using supercritical CO 2 fluid (SCCO 2 ) to improve the comprehensive performance of all-carbon-nanotube thin-film transistors (TFTs) at low temperature. After the treatment, the subthreshold swing, the threshold voltage, and the leakage current of the devices are decreased. Meanwhile, the mobility and on/off current ratio of the device are improved significantly. We verify the passivation mechanism of the SCCO 2 treatment by X-ray photoelectron spectroscopy and Fourier transform infrared spectroscopy analysis. The result shows that the SCCO 2 treatment improves the oxidation level, passivates the defects in the dielectric layer, and removes the impurity molecules adsorbed by carbon nanotubes. The SCCO 2 treatment performs component modification for the device by its excellent penetrating and dissolving capabilities without causing the structural damage. It has a great potential to be generally applied to activate TFTs with processing temperature limitation.
Low dimensional materials (LDMs) have drawn world-wide attention as potential candidates applied in flexible and wearable electronics. It is an attractive research topic to systematically integrate all-LDMs to realize flexible electronics. However, it is difficult to pattern LDMs by conventional photolithography and plasma etching without harming the other overlapped analogous components. Here, we propose and realize independent-operation all-LDM flexible transistors integrated into a 2-inch substrate using the proposed photolithography incorporated filtration (PIF) platform. The transistors consisting of only one-dimensional carbon nanotubes and two-dimensional graphene oxide show an ultralow operating voltage of less than −1 V, an extraordinary subthreshold swing (SS) of 170 mV dec−1, a low threshold voltage (Vth) of −0.3 V and a high carrier mobility up to 105 cm2 V−1 s−1. Moreover, the device shows a small bending radius of 1 mm and a transistor transparency of 94%. The full room-temperature process further demonstrates the great potential of applying the proposed devices and the PIF platform to future high-performance flexible transparent electronics. This work provides a novel route to tackle the difficulty in integrating solution processed LDMs.
Amorphous indium gallium zinc oxide (a-IGZO) thin film transistors (TFTs) with high mobility are highly desirable to achieve high-speed operation in active-matrix displays and largearea sensors. Only a few works provided potential solutions. In this work, we have embedded carbon nanotubes (CNTs) into sputtered a-IGZO film to form a-IGZO/CNT/a-IGZO (ACA) sandwiched channel. In the ACA channel, the CNT percolation networks connected by the a-IGZO film work as high-speed carrier paths to enable faster transport of carriers during the on state while it does not degrade the leakage performance during the off state. The type and the embedding location of the CNT percolation network are critical to determine the ACA device performance, which is analyzed and verified by experiment and simulation. The optimum ACA design has approximately doubled the mobility and the on current density of the TFT. The design owns relatively better uniformity and provides a high-speed TFT solution for the advanced electronics.
30 September 2019 in IEEE Transactions on Nanotechnology
Well-aligned Carbon nanotube (CNT) arrays are expected by flexible and stretchable devices. In this paper, an asymmetric Langmuir-Blodgett (LB) method and inorganic hydrophilization method have been proposed, with which well-aligned CNT arrays on soft substrates like polyethylene naphthalate, polyimide and polydimethylsiloxane have been realized. After depositing 50 nm SiO2 for hydrophilization, the water contact angle has been significantly reduced for different substrates. The surface roughness and flexibility have also been characterized to analyze their effect on device performance. The nanotube density in the arrays can be controlled to 10-25 tubes/μm $^2$ , 25-35 tubes/μm $^2$ or 35-45 tubes/μm $^2$ by tuning the surface pressure during the LB process. With aligned semiconducting CNT arrays as channel and anisotropic metallic CNT network as gate/source/drain electrodes, a kind of all-carbon transistor on PI substrate has been fabricated for demonstration. The fabricated device shows an on/off ratio 4.51×10 $^2$ , a subthreshold swing of 92.9 mV/dec, and a carrier mobility of 15.32 cm $^2$ /Vs. More importantly, with 50 nm thick gate dielectric, the changes of threshold voltage, and carrier mobility are within 16.62% and 28.78%, respectively, even after bending 1000 times under a curvature radius of 3.66 mm.