Although lithium-ion batteries (LIBs) are extensively used as secondary storage energy devices, they also pose a significant fire and explosion hazard. Subsequently, thermal stability studies for LiPF6- and LiFSI-type electrolytes have been conducted extensively. However, the thermal characteristics of these electrolytes with thermally stable additives in a full cell assembly have yet to be explored. This study presents a comprehensive accelerating rate calorimetry (ARC) study. First, 1.2-Ah cells were prepared using a control commercial LiPF6 electrolyte and LiFSI with a specific succinonitrile additive and ethyl-methyl carbonate as a thermally stable electrolyte additive. The kinetic parameters involved in heat generation and their effects on the thermal properties of the ARC module were analyzed from the heat-wait-seek (HWS), self-heating (SH), and thermal runaway (TR) stages. The results indicate that the addition of a succinonitrile additive to the LiFSI electrolyte lowers the decomposition temperatures of the solid electrolyte interface (SEI) owing to polymerization with Li at the anode, while simultaneously increasing the activation energy of reaction temperatures at SEI between the separator and the electrolyte. The maximum thermal-runaway temperature decreased from 417 °C (ΔH = 5.26 kJ) (LiPF6) to 285 °C (ΔH = 2.068 kJ) (LiFSI + succinonitrile). This study provides key insights to the thermal characteristics of LiPF6 and LiFSI during the self-heating and thermal runaway stages and indicates a practical method for achieving thermally stable LIBs.
Silicon sub oxides (SiOx) materials are considered as potential anode materials for next-generation high-energy lithium-ion batteries (LIBs) because of their high specific capacity and improved cyclic performance with the advantage of low operating voltage. Many parameters influence the performance anode material in lithium ion batteries, such as nano-size material, high surface area and crystalline structure. Especially crystallinity of Si is a significant factor for obtaining better performance because it directly affect the structural stability of Si anode during the electrochemical reactions. Crystallinity is directly controlled by the reaction temperature. Here we compared the effect of heat absorbent inner salt KCl and NaCl on the Si crystallinity. Crystallinity controlled D-SiOx anode material has been prepared by partial magnesiothermic reduction process using heat regulating inert salts KCl and NaCl for enhanced electrochemical properties. Anode prepared using KCl assisted shows low crystallinity of Si with remarkably improved reversible capacity and excellent cyclic stability as compared with NaCl assisted high crystalline Si. KCl assisted D-SiOx exhibited initial discharge and charge capacities of 2243 and 1862 mA h g-1, respectively, with an ICE of 83%. Moreover, it showed a stable cycle performance, maintaining a high capacity retention of up to 90% even after 200 cycles at 0.5C. Figure 1