Igor V. Mishin

Igor V. Mishin

Auto-generated profile, based on publicly available information

Igor V. Mishin

N.D. Zelinsky Institute of Organic Chemistry, Russian Academy of Sciences, Moscow, Russia

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 May 2023 in Catalysts
Verified
Journal Article
Open access
PDF file
MIMaria Igonina
Maria Igonina
MTMarina Tedeeva
Marina Tedeeva
KKKonstantin Kalmykov
Konstantin Kalmykov
GKGennadiy Ivanovich Kapustin
Gennadiy Ivanovich Kapustin
VNVera Nissenbaum
Vera Nissenbaum
AKAlexander L Kustov
Alexander L Kustov
Propylene is an important raw material for the production of many valuable compounds, especially polypropylene, the consumption of which continues to grow every year. The reaction of oxidative dehydrogenation of propane, where carbon dioxide is used as a mild oxidant, is a promising method for producing propylene. At the same time, the problem of utilization of greenhouse gas CO2 is partially solved. The synthesis and analysis of the physicochemical properties of mesoporous silicate MCM-41 and supported catalysts CrOx/MCM-41 prepared on its basis were carried out. These catalysts were prepared using incipient wetness impregnation. The support and catalysts were characterized by the methods of low-temperature nitrogen adsorption, TG-DTA, XRD, SEM, TPR-H2, UV/Vis diffuse reflectance spectroscopy, and small-angle X-ray scattering. It is shown that chromium is present in the samples simultaneously in the form of Cr3+ and Cr6+. The catalytic tests were performed in the range of 550–700 °C. The highest selectivity for propylene was observed for the 5%Cr/MCM-41 catalyst and was 76% at a temperature of 650 °C with a propane conversion of 20%. The deposited catalysts Cr/MCM-41 and Cr/SiO2 (Acros) were compared. The propylene selectivity for the MCM-41-supported catalyst was ~1.5 times higher than that for the SiO2-supported catalyst.

1 July 2005 in Adsorption
Verified
Journal Article
Closed access
PDF file
IMI. V. Mishin
I. V. Mishin
TBT. R. Brueva
T. R. Brueva
GKG. I. Kapustin
G. I. Kapustin

4 March 2023 in Nanomaterials
Verified
Journal Article
Open access
PDF file
KKKristina Kartavova
Kristina Kartavova
MMMikhail Yu. Mashkin
Mikhail Yu. Mashkin
MKMikhail Yu. Kostin
Mikhail Yu. Kostin
EFElena Finashina
Elena Finashina
KKKonstantin B. Kalmykov
Konstantin B. Kalmykov
AKAlexander L Kustov
Alexander L Kustov
Because of the growing demand for high-quality fuels, the light cycle oil fraction improvement including cetane number improvement is important. The main way to reach this improvement is the ring opening of cyclic hydrocarbons, and a highly effective catalyst should be found. Cyclohexane ring openings are a possible option to investigate the catalyst activity. In this work, we investigated rhodium-loaded catalysts prepared using the commercially available industrial supports: single-component ones, SiO2 and Al2O3; and mixed oxides CaO + MgO + Al2O3 and Na2O + SiO2 + Al2O3. The catalysts were prepared by incipient wetness impregnation and investigated by N2 low-temperature adsorption-desorption, XRD, XPS, DRS UV-Vis and DRIFT spectroscopy, SEM, and TEM with EDX. The catalytic tests were performed in cyclohexane ring opening in the range of 275–325 °C. The best result was demonstrated by the sample 1Rh/CaMgAlO: the selectivity to n-hexane was about 75% while the cyclohexane conversion was about 25% at 275 °C. The space-time yield was up to 12 mmoln-hexane gcat−1h−1.

12 August 2022 in Molecules
Verified
Journal Article
Open access
PDF file
Olga A. KirichenkoOlga A. Kirichenko
Olga A. Kirichenko
GKGennadiy Ivanovich Kapustin
Gennadiy Ivanovich Kapustin
IMIgor Mishin
Igor Mishin
VNVera Nissenbaum
Vera Nissenbaum
ESElena Shuvalova
Elena Shuvalova
Leonid KustovLeonid Kustov
Leonid Kustov
Development of novel Cu-based catalysts has become one of the frontiers in the catalytic production of platform chemicals and in environment protection. However, the known methods of their synthesis are too complicated and result in materials that cannot be used instantly as commercial catalysts. In the present work, a novel material has been synthesized by the facile method of deposition–precipitation using thermal hydrolysis of urea. The conditions for Cu phyllosilicate formation have been revealed (molar ratio urea:copper = 10, 92 °C, 8–11 h). The prepared Cu-based materials were studied by TG–DTA, SEM, TEM, XRD, N2 adsorption and TPR-H2 methods, and it was found that the material involves nanoparticles of micro-mesoporous copper phyllosilicate phase with a chrysocolla-like structure inside the pores of a commercial meso-macroporous silica carrier. The chrysocolla-like phase is first shown to be catalytically active in the selective reduction of the nitro-group in trinitrobenzene to an amino-group with molecular hydrogen. Complete conversion of trinitrobenzene with a high yield of amines has been achieved in short time under relatively mild conditions (170 °C, 1.3 MPa) of nitroarene hydrogenation over a copper catalyst.

31 March 2021 in Molecules
Verified
Journal Article
Open access
PDF file
AKAlexander L Kustov
Alexander L Kustov
ATAndrey L. Tarasov
Andrey L. Tarasov
OTOlga Tkachenko
Olga Tkachenko
IMIgor V. Mishin
Igor V. Mishin
GKGennadiy Ivanovich Kapustin
Gennadiy Ivanovich Kapustin
Leonid KustovLeonid Kustov
Leonid Kustov
The nonoxidative conversion of ethanol to acetaldehyde under thermal and microwave heating was studied on mixed oxide ZnO-CuO-SiO2 catalysts modified with additives of tungsten carbide nanoparticles. The results revealed that the WC-modified catalyst exhibited superior activity and selectivity under microwave heating conditions. It is assumed that when microwave heating is used, hot zones can appear at the contact points of WC nanoparticles and active centers of the mixed oxide ZnO-CuO-SiO2 catalyst, which intensively absorb microwave energy, allowing the more efficient formation of acetaldehyde at moderate temperatures. Thermodynamic calculations of equilibrium concentrations of reagents and products allowed us to identify the optimal conditions for effective acetaldehyde production. The initial catalyst and the catalyst prepared by the coprecipitation of the oxides with the addition of WC were characterized by physicochemical methods (TPR-H2, XRD, DRIFTS of adsorbed CO). The active centers of the oxide catalyst can be Cu+ cations.

26 April 2025 in Molecules
Verified
Journal Article
Open access
PDF file
ERElena Redina
Elena Redina
IIInna Ivanova
Inna Ivanova
OTOlga Tkachenko
Olga Tkachenko
GKGennadiy Ivanovich Kapustin
Gennadiy Ivanovich Kapustin
IMIgor Mishin
Igor Mishin
Leonid KustovLeonid Kustov
Leonid Kustov
Amines and hydroxylamines are essential compounds in the synthesis of pharmaceuticals and other functionalized molecules. However, the synthesis of primary amines and particularly hydroxylamines remains a challenging task. The most common way to obtain amines and hydroxylamines involves the reduction of substances containing C-N bonds, such as nitro compounds, nitriles, and oximes. Among these, oximes are the most readily accessible substrates easily derived from ketones and aldehydes. However, oximes are much harder to reduce compared to nitro compounds and nitriles. The catalytic heterogeneous hydrogenation of oximes often requires harsh conditions and catalysts with high precious metal loadings, while hydroxylamines are hard to be obtained by this method. In this work, we showed that Pt supported on a porous ceria–zirconia solid solution enables the selective and atom-efficient synthesis of both hydroxylamines and amines through the hydrogenation of oximes, achieving yields of up to 99% under ambient reaction conditions in a “green” THF:H2O solvent system. The high activity of the 1% Pt/CeO2-ZrO2 catalyst (TOF > 500 h−1) is due to low-temperature hydrogen activation on Pt nanoparticles with the formation of a hydride, Pt-H. The strong influence of electron-donating and electron-withdrawing groups on the hydrogenation of aromatic oximes implies the nucleophilic attack of hydridic hydrogen from Pt to the electrophilic carbon of protonated oximes.