In this study, we demonstrate the preparation and characterization of small palladium nanoparticles (Pd NPs) on modified ceria support (Pd/CeO₂) using wet impregnation and further reduction in an H₂/Ar flow. The obtained particles had a good dispersion, but their small size made it difficult to analyze them by conventional techniques such as transmission electron microscopy (TEM) and X-ray powder diffraction (XRPD). The material demonstrated a high catalytic activity in the CO oxidation reaction: the 100% of CO conversion was achieved at ~50 °C, whereas for most of the cited literature, such a high conversion usually was observed near 100 °C or higher for Pd NPs. Diffuse reflectance infrared Fourier-transform (DRIFT) spectroscopy in combination with CO probe molecules was used to investigate the size and morphology of NPs and the ceria support. On the basis of the area ratio under the peaks attributed to bridged (B) and linear (L) carbonyls, high-dispersion Pd NPs was corroborated. Obtained results were in good agreement with data of X-ray absorption near edge structure analysis (XANES) and CO chemisorption measurements.

The effect of the nature of the metals (Cu, Ni, and Fe) deposited on carbon materials (coals) and the methods of preparation (conventional and microwave heating) of the most active Fe/C samples on their efficiency in the reaction of CO₂-assisted conversion of coal into carbon monoxide is estimated.

The nonoxidative conversion of ethanol to acetaldehyde under thermal and microwave heating was studied on mixed oxide ZnO-CuO-SiO₂ catalysts modified with additives of tungsten carbide nanoparticles. The results revealed that the WC-modified catalyst exhibited superior activity and selectivity under microwave heating conditions. It is assumed that when microwave heating is used, hot zones can appear at the contact points of WC nanoparticles and active centers of the mixed oxide ZnO-CuO-SiO₂ catalyst, which intensively absorb microwave energy, allowing the more efficient formation of acetaldehyde at moderate temperatures. Thermodynamic calculations of equilibrium concentrations of reagents and products allowed us to identify the optimal conditions for effective acetaldehyde production. The initial catalyst and the catalyst prepared by the coprecipitation of the oxides with the addition of WC were characterized by physicochemical methods (TPR-H₂, XRD, DRIFTS of adsorbed CO). The active centers of the oxide catalyst can be Cu⁺ cations.

The effect of the nature of zeolite catalysts H-ZSM-5, H-BETA, and SAPO-34 on the activity and selectivity in the conversion of glycerol into aromatic hydrocarbons, acrolein, and oxygenates...

The hydroconversion of asphaltenes into light hydrocarbons catalyzed by supported and free-standing non-noble metal nanoparticles was studied. The activity of Ni or Co immobilized on microspherical oxide carriers and Co nanoparticles dispersed in a hydrocarbon solution of asphaltene was found to be higher than that of a comparative Pt-Pd/Al₂O₃ catalyst. The yield of light products (C₅₊) reached up to 91% on cobalt nanoparticles supported onto alumina microspheres.

The effect the nature of a metal has on the activity and selectivity of the catalysts in hydrogenation of carbon dioxide into carbon oxide and hydrocarbons under high pressure is studied for...