1 October 2015 in Physics of Plasmas
An experiment with exploding foils was carried out at a current density of 0.7 × 108 A/cm2 through the foil with a current density rise rate of about 1015 A/cm2 s. To record the strata arising during the foil explosions, a two-frame radiographic system was used that allowed tracing the dynamics of strata formation within one shot. The original striation wavelength was 20–26 μm. It was observed that as the energy deposition to a foil stopped, the striation wavelength increased at a rate of ∼(5–9) × 103 cm/s. It is supposed that the most probable reason for the stratification is the thermal instability that develops due to an increase in the resistivity of the metal with temperature.
1 June 2016 in Physics of Plasmas
The effect of an axial magnetic field Bz on an imploding metallic gas-puff Z-pinch was studied using 2D time-gated visible self-emission imaging. Experiments were performed on the IMRI-5 generator (450 kA, 450 ns). The ambient field Bz was varied from 0.15 to 1.35 T. It was found that the initial density profile of a metallic gas-puff Z-pinch can be approximated by a power law. Time-gated images showed that the magneto-Rayleigh–Taylor instabilities were suppressed during the run-in phase both without axial magnetic field and with axial magnetic field. Helical instability structures were detected during the stagnation phase for Bz < 1.1 T. For Bz = 1.35 T, the pinch plasma boundary was observed to be stable in both run-in and stagnation phases. When a magnetic field of 0.3 T was applied to the pinch, the soft x-ray energy was about twice that generated without axial magnetic field, mostly due to longer dwell time at stagnation.
1 December 2017 in Physics of Plasmas
We show that vacuum arc plasma discharges with a current of several kiloamperes and duration of a few microseconds can generate multiply charged metal ions with charge states greater than 10+. The physical mechanism behind this is discussed, suggesting an optimum arc current for higher charge states depending on the pulse duration and cathode material. Measurements of ion mass-to-charge ratio and images taken with nanosecond resolution suggest that, higher charge state ions are produced at characteristic distances of ∼10 mm from the cathode as the arc current peaks, and the process responsible for their generation is additional ionization as the discharge is pinched by its self-magnetic field. The maximum and mean ion charge states reveal a considerable increase for the all cathode materials studied: magnesium, aluminum, zirconium, tin, tantalum, gold, lead, and bismuth. For bismuth ions, the maximum charge state reaches a record-breaking value of 17+ and the mean of the charge state distribution is 12.6+. The results obtained are of interest for vacuum arc discharge physics and for ion beam technologies.
6 February 2018 in Plasma Physics and Controlled Fusion
At present Z-pinch has evolved into a powerful plasma source of soft x-ray. This paper considers the energy balance in a radiating metallic gas-puff Z pinch. In this type of Z pinch, a power-law density distribution is realized, promoting suppression of Rayleigh–Taylor (RT) instabilities that occur in the pinch plasma during compression. The energy coupled into the pinch plasma, is determined as the difference between the total energy delivered to the load from the generator and the magnetic energy of the load inductance. A calibrated voltage divider and a Rogowski coil were used to determine the coupled energy and the load inductance. Time-gated optical imaging of the pinch plasma showed its stable compression up to the stagnation phase. The pinch implosion was simulated using a 1D two-temperature radiative magnetohydrodynamic code. Comparison of the experimental and simulation results has shown that the simulation adequately describes the pinch dynamics for conditions in which RT instability is suppressed. It has been found that the proportion of the Ohmic heating in the energy balance of a Z pinch with suppressed RT instability is determined by Spitzer resistance and makes no more than ten percent.
23 July 2018 in IEEE Transactions on Plasma Science
The structure of the plasma jet of a vacuum arc discharge was investigated using different experimental arrangements for jet formation. To examine the external shape and internal structure of the plasma jet, optical imaging and pulsed X-ray radiography were used. The latter is the most informative method for investigating the density distribution in a dense plasma jet. This diagnostic, combined with a step wedge, provides a way of analyzing quantitatively the plasma jet structure. As the X-ray source for radiography, an X-pinch was used. The measured surface density of an aluminum plasma jet ranged up to $340~\mu \text{g}$ /cm 2 . The arc discharge current and the plasma jet current were measured with Rogowski coils. The experiment has shown that in the case of a plasma gun with return current posts; a pinch effect arises which provides for the formation of a confined plasma jet.
1 July 2014 in Instruments and Experimental Techniques
The efficiency of the X-ray point-projection radiography technique has been demonstrated on a terawatt pulse power generator using a detached compact current generator driving an X-pinch load. This te