1 June 2023 in International Journal of Power Electronics and Drive Systems (IJPEDS)
The power generation system with hybrid system grid connected (HSGC) technology is an energy-saving technology that is able to compensate for electricity loads in an energy-efficient manner in today's technological advances. Electrical transient analyzer power (ETAP) simulation software is implemented so that the modeling will have an impact on the development of hybrid systems. Testing the reliability of the system is simulated at the load of school buildings, laboratories, mosques, and kindergarten schools. parameters obtained by evaluating the ratio of the voltage drop before and after the addition of photovoltaic. The value of the voltage drops decreases with the integration of hybrid photovoltaic. The school building panels experienced a voltage drop of 0.15%, reduced after the addition of photovoltaics and wind turbines. Then on the Laboratory panel, a voltage drops of 0.05% was obtained, on the mosque panel the voltage drop reached 0.11%, and on the kindergarten building panel the voltage drop reached 0.09% after the addition of photovoltaic hybrid. From this comparison it can be said that PV and wind turbines can affect the voltage drop and reduce the consumption of electricity loads from the grid caused by adding power from the hybrid photovoltaic hybrid to each load.
14 February 2021 in CIRCUIT: Jurnal Ilmiah Pendidikan Teknik Elektro
The accelerated development of the technological world cannot be separated from the materials of electronic components. Vocational schools are the most dominant schools in discussing electronics, but there are still many students who have abilities below the graduation standards that have been set in the subject of electronics basics. One of the causes of low learning outcomes is due to the lack of involvement of students in the learning process. Therefore it is necessary to think pair share method to spur student activeness and creativity during learning. The technique in doing this method is by students thinking, discussing and sharing material concepts directly with their classmates controlled by the teacher in material supervision. In addition, by using this method students are able to solve problems during the learning process well. This type of research is a Quasi Experiment with Posttest Only Control Design. The subjects of this study were students of class X SMK Negeri 1 Pariaman which consisted of two classes, namely X TITL-1 and X TITL-2. From these two classes were selected randomly where class X TITIL-1 was the experimental class and class X TITL-2 was the control class. To see students' initial abilities, an analysis of the posttest was carried out in the subject of Understanding the Basics of Electronics. Collecting data in this study using a learning outcome test (posttest) in the form of objective questions of 25 items. The data were analyzed using the two-mean difference test (t-test). Based on the results of the study, the posttest mean percentage of the experimental class was 77.14% and the control class was 55.14%. The results of this study indicate that there is a significant increase in student learning outcomes with a comparison of the think pair share method which is better than the conventional method.
1 June 2023 in International Journal of Electrical and Computer Engineering (IJECE)
The high sunlight intensity in tropical and equatorial regions makes the potential for installing photovoltaic (PV) panels. However, the initial design of PV installations must be analyzed. Their implementation is carried out in buildings with load power for household electricity scale. For this reason, the panel reliability system could be efficient by designing the initial PV requirements using systematic measurements. Collecting data on fluctuating sunlight intensity (unpredictable weather) conditions needs the use of manual measuring tools, namely digital light meters and PV data with sensor integration. The research sample consists of three fluctuating hot weather conditions, namely hot-sunny, hot-cloudy and hot-rainy conditions. These weather conditions were taken because the climate of West Sumatra tends to shift clouds which sometimes cover the sun's rays. The peak PV output for direct current (DC) power generated during hot- sunny conditions reaches 1827.17 W, in sunny-cloudy weather it reaches around 1626.85 W and during sunny-rainy weather conditions the resulting output is 1161.81 W. From daily measurements, the results show that the efficiency of the PV system is strongly influenced by the prevailing weather climate.
1 December 2023 in Bulletin of Electrical Engineering and Informatics
In a competitive environment, the ability to rapidly and successfully scale up new business models is critical. However, research shows that many new business models fail. This research looks at hybrid methods for minimizing constraints and maximizing opportunities in large data sets by examining the multivariable that arise in user behavior. E-metric data is being used as assessment material. The analytical hierarchy process (AHP) is used in the multi-criteria decision making (MCDM) approach to identify problems, compile references, evaluate alternatives, and determine the best alternative. The multi-objectives genetic algorithm (MOGA) role analyzes and predicts data. The method is being implemented to expand the information base of the strategic planning process. This research examines business sustainability along two critical dimensions. First, consider the importance of economic, environmental, and social evaluation metrics. Second, the difficulty of gathering information will be used as a predictor for making long-term business decisions. The results show that by incorporating the complexity features of input optimization, uncertainty optimization, and output value optimization, the complexity prediction model (MPK) achieves an accuracy of 89%. So that it can be used to forecast future business needs by taking into account aspects of change and adaptive behavior toward the economy, environment, and social factors.
1 June 2023 in Indonesian Journal of Electrical Engineering and Computer Science
Medan Area University is one of the private universities in North Sumatra that is also involved in the development of renewable energy technology. This technological development has initiated the University's efforts to develop an electrical system by developing a smart grid system in order to reduce the University's operational costs. However, in its realization, it has its own challenges, such as power flow stability and transient stability. Both problems can be analyzed using ETAP 12.6 software. In one of the cases analyzed, the smart grid system can reduce the use of the active power of the transformer by 11 kW and a current of 19.7 Amp. Meanwhile, in the Indonesian State Electricity Company (PLN) off condition, the smart grid system has not been able to supply the load because the availability of renewable energy sources is not sufficient for the load requirement. As well as the results of the voltage and frequency analysis, the highest voltage is 376.4 Volts, the lowest is 375.9 Volts, which is still in the stable category of 380 Volt voltage deviation because it is not +5% and -10%, and the overall frequency of the cases discussed is consistent stable at nominal 50 Hz.
1 December 2023 in Bulletin of Electrical Engineering and Informatics
Utilization of elevation angles and azimuth angles is a very important part in maximizing solar energy into electrical energy in photovoltaic (PV). One way to maximize PV power output is to design a single axis tracker system and take into account the azimuth and elevation angles of the sun using the sun position calculator application. The single axis tracker system is set based on the position of the angle of inclination of the surface of the PV 45°, then the angle of 90° and the angle of inclination of 135°. The test results show that the single axis tracker PV system design can work based on the angle settings that have been programmed. Then the use of a battery control system to support the PV reliability system automatically cuts off electricity when the battery voltage drops below 12 V during cloudy weather conditions and excessive battery usage. The integration of the PZEM-017 module with the battery will support monitoring of battery power usage in real time. PV energy data conversion performance uses single axis tracker technology for maximum power reaching 631.72 Watt DC at 12.00 pm and the lowest power reaching 56.02 Watt DC at 6.00 pm.