Scaling down of semiconductor devices requires high- k dielectric materials to continue lowering the operating voltage of field-effect transistors (FETs) and storing sufficient charge on a smaller area. Here, we investigate the dielectric properties of epitaxial BaHf 0.6 Ti 0.4 O 3 (BHTO), an alloy of perovskite oxide barium hafnate (BaHfO 3 ) and barium titanate (BaTiO 3 ). We found the dielectric constant, the breakdown field, and the leakage current to be 150, 5.0 megavolts per centimeter (MV cm −1 ), and 10 −4 amperes per square centimeter at 2 MV cm −1 , respectively. The results suggest that two-dimensional (2D) carrier density of more than n2D = 10 14 per square centimeter (cm −2 ) could be modulated by the BHTO gate oxide. We demonstrate an n-type accumulation mode FET and direct suppression of more than n2D = 10 14 cm −2 via an n-type depletion-mode FET. We attribute the large dielectric constant, high breakdown field, and low leakage current of BHTO to the nanometer scale stoichiometric modulation of hafnium and titanium.
We outline a method to synthesize (ATiO3)nAO Ruddlesden–Popper phases with high-n, where the A-site is a mixture of barium and strontium, by molecular-beam epitaxy. The precision and consistency of the method described is demonstrated by the growth of an unprecedented (SrTiO3)50SrO epitaxial film. We proceed to investigate barium incorporation into the Ruddlesden–Popper structure, which is limited to a few percent in bulk, and we find that the amount of barium that can be incorporated depends on both the substrate temperature and the strain state of the film. At the optimal growth temperature, we demonstrate that as much as 33% barium can homogeneously populate the A-site when films are grown on SrTiO3 (001) substrates, whereas up to 60% barium can be accommodated in films grown on TbScO3 (110) substrates, which we attribute to the difference in strain. This detailed synthetic study of high n, metastable Ruddlesden–Popper phases is pertinent to a variety of fields from quantum materials to tunable dielectrics.
This work reports the impact of gamma-ray (γ-ray) irradiation-induced degradation based on the trap behaviors in amorphous indium-gallium-zinc-oxide (a-IGZO) thin-film transistors. By employing multiple measurement configurations via low-frequency noise and direct current I–V characterization, we quantitatively investigated the energetic distribution of subgap density-of-states in the a-IGZO channel and the spatial distribution of oxide traps (Not) in the gate insulator, respectively. Also, the qualitative analysis was performed to determine the oxygen-related defects after γ-ray irradiation using x-ray photoelectron spectroscopy. Furthermore, the validity of our results was additionally confirmed by measuring the breakdown voltage and applying positive-bias stress to the fabricated devices exposed to radiation for accelerated tests.
We demonstrate a recess-type Ge on Si WGAPD receiver with 106Gb/s PAM4 overload >0dBm and unstressed/stressed sensitivities of -18.9/18dBm, which provides about 19dB dynamic range for 100Gb/s per lane applications.