27 July 2022 in IEEE Transactions on Dielectrics and Electrical Insulation
Functionally graded materials (FGM) application with graded permittivity and conductivity is promising as an effective technique for electric field relaxation in SF6 gas around HVDC gas insulated switchgear (GIS)/gas insulated transmission line (GIL) spacers. To approach the practical application of FGM to HVDC GIS/GIL spacers, this article investigates the electric field reduction effect given by permittivity and conductivity graded materials ( $\varepsilon /\sigma $ -FGM) based on actual measured permittivity ( $\varepsilon $ ) characteristics of SrTiO3-filled epoxy composites and conductivity ( $\sigma $ ) characteristics of SiC-filled epoxy composites. In addition, theoretical discharge inception voltage (TDIV) of $\varepsilon /\sigma $ -FGM spacer is calculated under standard lightning impulse (LI) voltage based on the volume–time theory. The results show that the $\varepsilon /\sigma $ -FGM spacer with grading to lower permittivity (GLP) ( $\varepsilon _{r}$ from 12.7 to 4) containing 0–26.9-vol% SrTiO3-filled epoxy composite and U-shaped graded conductivity containing 5–10-vol% SiC-filled epoxy composite is effective for electric field relaxation under DC steady state (DC-SS) and LI voltage where both resistive and capacitive fields present. It is attributed to the higher $\varepsilon $ and $\sigma $ of FGM spacer near the HV conductor/spacer interface. TDIV under LI voltage is also estimated to be 26% higher at 0.5 MPa-abs, compared with the conventional spacer without $\varepsilon /\sigma $ grading.
11 June 2007 in IEEE Transactions on Dielectrics and Electrical Insulation
An improvement in dielectric strength is required in vacuum circuit breakers (VCBs) intended for use in higher voltage systems. In order to develop higher voltage VCBs, it is important to improve the dielectric strength in a vacuum based on consideration of the vacuum breakdown mechanism. Particularly for gaps longer than 10 mm, little is known about the breakdown mechanisms and their quantitative analyses in a vacuum. This paper discusses the breakdown conditioning characteristics of long gap electrodes, under a non-uniform electric field in a vacuum. We treat gap lengths of up to 50 mm in this paper. The conditioning characteristics are investigated under impulse voltage applications. A negative standard lightning impulse voltage was applied to rod-plane electrodes made of Cu-Cr and SUS304 for different tip radii and gap distances until the conditioning effect was completed. We observed illumination spots on electrodes at each breakdown during the conditioning process and calculated the corresponding breakdown field strengths. Experimental results revealed that the tendency of breakdowns associated with long gaps is different from that for the short gaps. As a result, we clarified that the breakdown field strengths are nearly constant at 110-120 kV/mm at the distances longer than 10 mm, and the breakdown field strength is at its maximum when the gap distance is about 5 mm.
1 January 1999 in IEEE Transactions on Dielectrics and Electrical Insulation
1 January 2005 in IEEJ Transactions on Power and Energy
1 January 1995 in IEEJ Transactions on Power and Energy
1 January 1998 in IEEJ Transactions on Power and Energy