27 April 2016 in IEEE Transactions on Electron Devices
This paper reports an experimental demonstration of the time-dependent failure of GaN-on-Si power high-electron-mobility transistors with p-GaN gate, submitted to a forward gate stress. By means of combined dc, optical analysis, and 2-D simulations, we demonstrate the following original results: 1) when submitted to a positive voltage stress (in the range of 7-9 V), the transistors show a time-dependent failure, which leads to a sudden increase in the gate current; 2) the time-to-failure (TTF) is exponentially dependent on the stress voltage and Weibull-distributed; 3) the TTF depends on the initial gate leakage current, i.e., on the initial defectiveness of the devices; 4) during/after stress, the devices show a localized luminescence signal (hot spots); the spectral investigation mainly reveals a peak corresponding to yellow luminescence and a broadband related to bremsstrahlung radiation; and 5) 2-D simulations were carried out to clarify the origin of the degradation process. The results support the hypothesis that the electric field in the AlGaN has a negligible impact on the device failure; on the contrary, the electric field in the SiN and in the p-GaN gate can play an important role in favoring the failure, which is possibly due to a defect generation/percolation process.
2 August 2017 in IEEE Transactions on Electron Devices
This paper reports on the impact of soft- and hard-switching conditions on the dynamic ON-resistance of AlGaN/GaN high-electron mobility transistors. For this study, we used a special double pulse setup, which controls the overlapping of the drain and gate waveforms (thus inducing soft and hard switching), while measuring the corresponding impact on the ON-resistance, drain current, and electroluminescence (EL). The results demonstrate that the analyzed devices do not suffer from dynamic R ON increase when they are submitted to soft switching up to V DS = 600 V. On the contrary, hard-switching conditions lead to a measurable increase in the dynamic ON-resistance (dynamic-R ON ). The increase in dynamic R ON induced by hard switching is ascribed to hot-electrons effects: during each switching event, the electrons in the channel are accelerated by the high electric field and subsequently trapped in the AlGaN/GaN heterostructure or at the surface. This hypothesis is supported by the following results: 1) the increase in R ON is correlated with the EL signal measured under hard-switching conditions and 2) the impact of hard switching on dynamic R ON becomes weaker at high-temperature levels, as the average energy of hot electrons decreases due to the increase scattering with the lattice.
27 July 2017 in IEEE Transactions on Electron Devices
This paper demonstrates and investigates the time-dependent vertical breakdown of GaN-on-Si power transistors. The study is based on electrical characterization, dc stress tests and electroluminescence measurements. We demonstrate the following original results: 1) when submitted to two-terminal (drain-to-substrate) stress, the AlGaN/GaN transistors show a time-dependent degradation process, which leads to the catastrophic failure of the devices; 2) time-to-failure follows a Weibull distribution and is exponentially dependent on stress voltage; 3) the degradation mechanism is strongly field dependent and weakly thermally activated, with an activation energy of 0.25 eV; and 4) emission microscopy suggests that vertical current flows under the whole drain area, possibly through extended defects. The catastrophic failure occurs at random positions under the drain contact. The time-dependent failure is ascribed to a percolation process activated by the high-electric field that leads to the generation of localized shunt paths between drain and substrate.
13 September 2016 in IEEE Electron Device Letters
This letter demonstrates that GaN-based MIS-HEMTs submitted to stress with high-temperature, high drain bias, and constant source current (HTSC stress) may show degradation modes that are not detectable during standard high temperature reverse bias (HTRB) stress. Based on a number of stress/recovery experiments, we demonstrate the following novel results: 1) the combined presence of high drain bias and constant drain-source current (HTSC stress) can lead to a significant increase in ON-resistance (RON) that is not detected under conventional HTRB stress; 2) RON increases without changes in the threshold voltage, indicating that charge trapping takes place in the access regions, and not under the gate; 3) the RON increase has a monotonic dependence on the source current flowing during stress; and 4) for the same stress current level, the RON increase has a negative dependence on temperature. The strong correlation between RON increase and source current and the negative temperature coefficient strongly support the hypothesis that trapping originates from the injection of hot electrons toward the gate-drain access region.
30 January 2017 in IEEE Electron Device Letters
In this letter, we investigate the time-dependent breakdown mechanisms in edge terminated AlGaN/GaN lateral Schottky diodes under high-temperature reverse bias (HTRB) tests. Thanks to a combined experimental/simulation analysis, we ascribe the device failure to two distinct time-sequential breakdown mechanisms caused by a localized electric field peak at the edge termination corner. In particular, the combined effect of high electric field and temperature causes a first breakdown of the plasma-enhanced atomic layer deposition (PEALD)-Si 3 N 4 followed by a second one in the AlGaN barrier. To validate this hypothesis, a 2-D TCAD simulator was used, and the breakdown path in Si 3 N 4 was modeled by an inclusion of a narrow metal filament. The electrical simulations well reproduce the characteristics of the fresh and degraded GaN diodes. Finally, we demonstrate that the diode reliability under HTRB tests can be significantly improved by using a metalorganic chemical vapor deposition (MOCVD)-Si 3 N 4 dielectric in the edge termination. This reliability improvement is related to a better material quality of MOCVD-Si 3 N 4 , showing a higher breakdown field compared with the PEALD-Si 3 N 4 .
15 November 2016 in IEEE Transactions on Electron Devices
This paper reports on an extensive analysis of the breakdown of GaN-based Schottky-gated HEMTs submitted to high-voltage stress. The analysis was carried out on transistors with different lengths of the drain-side gatehead (L GH ), corresponding to different levels of electric field across the SiN passivation. Based on dc measurements, 2-D simulations, and optical analysis, we demonstrate the following original results: 1) when submitted to high drain voltages (in the OFF-state ), the transistors can show catastrophic failure; 2) electroluminescence microscopy indicates the presence of hot-spots on the drain-side of the gate; 2-D simulations support the hypothesis that failure occurs in correspondence of the gate-head, on the drainside edge, where the electric field in the silicon nitride passivation has its maximum; 3) this hypothesis is confirmed by the results of transmission electron microscope failure analysis that demonstrate the generation of a leakage path between the gate metal and the channel, 4) and by the dependence of the destructive voltage on the L GH value. 5) in addition, we propose and demonstrate an approach for improving the reliability of the devices, i.e., using a graded SiN passivation with increased thickness. The results described in this paper provide important information for the device optimization of Schottky-gated HEMTs.