Kham Man Niang

Kham Man Niang

Auto-generated profile, based on publicly available information

Kham Man Niang

Department of Engineering, University of Cambridge, Cambridge, United Kingdom

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 July 2019 in Advanced Materials
Verified
Journal Article
Open access
PDF file
RSRadu A. Sporea
Radu A. Sporea
KNKham M. Niang
Kham M. Niang
AFAndrew J. Flewitt
Andrew J. Flewitt
S. Ravi P. SilvaS. Ravi P. Silva
S. Ravi P. Silva
Thin insulating layers are used to modulate a depletion region at the source of a thin‐film transistor. Bottom contact, staggered‐electrode indium gallium zinc oxide transistors with a 3 nm Al2O3 layer between the semiconductor and Ni source/drain contacts, show behaviors typical of source‐gated transistors (SGTs): low saturation voltage (VD_SAT ≈ 3 V), change in VD_SAT with a gate voltage of only 0.12 V V−1, and flat saturated output characteristics (small dependence of drain current on drain voltage). The transistors show high tolerance to geometry: the saturated current changes only 0.15× for 2–50 µm channels and 2× for 9‐45 µm source‐gate overlaps. A higher than expected (5×) increase in drain current for a 30 K change in temperature, similar to Schottky‐contact SGTs, underlines a more complex device operation than previously theorized. Optimization for increasing intrinsic gain and reducing temperature effects is discussed. These devices complete the portfolio of contact‐controlled transistors, comprising devices with Schottky contacts, bulk barrier, or heterojunctions, and now, tunneling insulating layers. The findings should also apply to nanowire transistors, leading to new low‐power, robust design approaches as large‐scale fabrication techniques with sub‐nanometer control mature.

29 July 2020 in IEEE Sensors Journal
Verified
Journal Article
Open access
EBEva Bestelink
Eva Bestelink
KNKham M. Niang
Kham M. Niang
GBGeorgios Bairaktaris
Georgios Bairaktaris
Luca MaioloLuca Maiolo
Luca Maiolo
FMFrancesco Maita
Francesco Maita
RSRadu A. Sporea
Radu A. Sporea
Silicon-based digital electronics have evolved over decades through an aggressive scaling process following Moore’s law with increasingly complex device structures. Simultaneously, large-area electronics have continued to rely on the same field-effect transistor structure with minimal evolution. This limitation has resulted in less than ideal circuit designs, with increased complexity to account for shortcomings in material properties and process control. At present, this situation is holding back the development of novel systems required for printed and flexible electronic applications beyond the Internet of Things. In this work we demonstrate the opportunity offered by the source-gated transistor’s unique properties for low-cost, highly functional large-area applications in two extremely compact circuit blocks. Polysilicon common-source amplifiers show 49 dB gain, the highest reported for a twotransistor unipolar circuit. Current mirrors fabricated in polysilicon and InGaZnO have, in addition to excellent current copying performance, the ability to control the temperature dependence (degrees of positive, neutral or negative) of output current solely by choice of relative transistor geometry, giving further flexibility to the design engineer. Application examples are proposed, including local amplification of sensor output for improved signal integrity, as well as temperature-regulated delay stages and timing circuits for homeostatic operation in future wearables. Numerous applications will benefit from these highly competitive compact circuit designs with robust performance, improved energy efficiency and tolerance to geometrical variations: sensor front-ends, temperature sensors, pixel drivers, bias analog blocks and high-gain amplifiers.

13 April 2023 in Journal of Materials Chemistry C
Verified
Journal Article
Open access
PDF file
DGDaisy E. Gomersall
Daisy E. Gomersall
KNKham M. Niang
Kham M. Niang
JPJames David Parish
James David Parish
ZSZhuotong Sun
Zhuotong Sun
AJAndrew Johnson
Andrew Johnson
AFAndrew J. Flewitt
Andrew J. Flewitt
This work demonstrates p-type SnO thin film transistors, where the SnO active layers were deposited with atomic layer deposition (ALD) using the Sn(II) alkoxide precursor, Sn(II) bis(tert-butoxide). The deposition optimisation explores the use of multiple Sn pulses per ALD cycle and the use of an exposure mode (where the pump extraction is paused before the Sn precursor purge) to increase the residence time and allow for more effective saturation of the surface. The fabricated devices required post deposition annealing of the active layer, with device performance further improved by back-channel passivation using ALD Al2O3. The performance of devices deposited using the varying precursor delivery modes has also been compared, with the devices utilizing deposition with multiple Sn pulses and a post deposition anneal at 250°C achieving an on/off ratio of ∼4×104 and field effect mobility (μFE) of 0.6 cm2(Vs)-1. The growth processes present during deposition with the different precursor delivery modes was investigated using fractal geometry and topographical scaling methods, with the poor device performance for the single Sn pulse deposition attributed to 2D lateral island growth.

1 January 2021 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
LBLin Bao
Lin Bao
ZWZongwei Wang
Zongwei Wang
BWBowen Wang
Bowen Wang
KLKeqin Liu
Keqin Liu
GBGuandong Bai
Guandong Bai
RHRu Huang
Ru Huang
Compressed sensing with a tunable random sampling strategy has great potential in reducing the energy/time consumption during the constant acquisition of external information, thereby it is considered one of the most promising sensing strategies in edge-terminal. In this paper, a novel tunable stochastic oscillator (TSO) based on the VO2/TaOx structure was proposed and employed as the core controlling device for compressed sensing. The TSO is jointly governed by the metal-insulator-transition (IMT) based threshold switching of the VO2 layer and the stochastic resistive switching by the TaOx layer. The tunable memristor/resistor in series can modulate the oscillation frequency of the TSO. The orthogonal matching pursuit (OMP) algorithm is implemented to reconstruct the compressed sparse signals, demonstrating a good performance of TSO in compressed sensing.

25 January 2017 in Physica Status Solidi (a)
Verified
Journal Article
Closed access
PDF file
KNKham M. Niang
Kham M. Niang
JCJunhee Cho
Junhee Cho
ASAditya Sadhanala
Aditya Sadhanala
WMWilliam I. Milne
William I. Milne
RFRichard H. Friend
Richard H. Friend
AFAndrew J. Flewitt
Andrew J. Flewitt

1 December 2024 in Nano Futures
Verified
Journal Article
Open access
EBEva Bestelink
Eva Bestelink
GGGiulio Galderisi
Giulio Galderisi
PGPatryk Golec
Patryk Golec
YHYi Han
Yi Han
BIBenjamin Iniguez
Benjamin Iniguez
LCLaurie E Calvet
Laurie E Calvet
In this roadmap we consider the status and challenges of technologies that use the properties of a rectifying metal-semiconductor interface, known as a Schottky barrier (SB), as an asset for device functionality. We discuss source gated transistors, which allow for excellent electronic characteristics for low power, low frequency environmentally friendly circuits. We also consider reconfigurable field effect transistors. In such devices, two or more independent gate electrodes can be used to program different functionalities at the device level, enabling ultra-secure embedded devices. Both types of transistors can be used for neuromorphic systems, notably by combining them with ferroelectric SB transistors which enable a large number of analog states. At cryogenic temperatures SB transistors can advantageously serve for the control electronics in quantum computing devices. If the source/drain of the metallic contact becomes superconducting, Josephson junctions with a tunable phase can be realized for scalable quantum computing applications. Developing applications using SB devices requires physics-based and compact models that can be used for circuit simulations, which are also discussed. The roadmap reveals that the main challenges for these technologies are improving processing, access to industrial technologies and modeling tools for circuit simulations.