The research is concerned with the use of double walls filled with aluminium foam for an open wagon in order to decrease the dynamic stresses during the operational modes. The research presents the strength calculation for the bearing structure of an open wagon with consideration of the engineering solutions proposed. It was found that the maximum equivalent stresses appeared in the bottom section of the centre sill behind the back support; they amounted to about 315 MPa and did not exceed the allowable values. The maximum displacements were detected in the middle section of the centre sill and amounted to 9.6 mm. The maximum deformations were 1.17 × 10−2. The research also presents the strength calculation for a weld joint in the maximum loaded zones of the bearing structure of an open wagon and gives the results of a modal analysis of the bearing structure of the improved open wagon. It was found that the critical oscillation frequencies did not exceed the allowable values. The results of the research may be useful for those who are concerned about designing innovative rolling stock units and improving the operational efficiency of railway transport.
The study deals with an application of aluminum foam as an energy-absorbing material for the carrying structure of a rail car. The material is particularly recommended for circular tube carrying structures. The authors conducted mathematical modeling of dynamic loads on the carrying structure of an open wagon that faces shunting impacts with consideration of the center sill filled with aluminum foam. It was established that the maximum accelerations on the carrying structure of an open wagon were 35.7 m/s2, which was 3.5% lower in comparison with those for a circular tube structure without a filler. The results obtained were proved by computer modeling. The strength of the carrying structure of an open wagon was also calculated. It was established that aluminum foam applied as a filler for the center sill decreased the maximum equivalent stresses in the carrying structure of an open wagon by about 5% and displacements by 12% in comparison with those involving the circular tube carrying structure of an open wagon without a filler. The natural frequencies and the oscillation modes of the carrying structure of an open wagon were defined. The designed models of the dynamic loading of the carrying structure of an open wagon were verified with an F-test.
The article discusses the problem and importance of the study of the parameters of interaction between the wheel and the rail. The analysis of the test rig equipment for conducting research was carried out. Conventionally, the methods of condu...
The paper considers the question of slipping and skidding occurrence probability decreasing by means of the friction controlling in the wheel-braking pad and wheel-rail contacts. One of the methods of stabilization of the friction in the pairs...
17 July 2013 in Journal of Mechanical Science and Technology
The article reviews and analyzes available theoretical and experimental studies aimed at improving the tractive and dynamic characteristics of locomotives. Based on the information received, the authors formulated the following tasks of further research to increase and stabilize traction and coupling qualities of the locomotive.