1 May 2016 in Journal of Materials in Civil Engineering
This paper presents the results of a laboratory investigation on the performances and mixture combination parameters of railway asphalt concrete (RAC) for supporting high-speed railway slab track. To apply the RAC effectively to high-speed railway infrastructures, modified highway asphalt pavement material tests are conducted to verify mixture parameters. A suitable gradation is recommended based on the test results. The air voids of the material RAC-25 used for railway infrastructure should be controlled from 1 to 3%. The results presented in the paper demonstrate that asphalt content can be determined based on modified mixture parameters. To verify the performance and analyze the mechanistic response of RAC infrastructure, full-scale laboratory dynamic models are established under different environmental temperatures and loading levels. Based on model testing, the reinforced RAC foundation with a 12 cm deep graded gravel layer replaced by RAC-25 shows much better performance compared with the traditional design.
1 October 2024 in Geosynthetics International
Field observations and centrifuge tests indicate that progressive column bending failure accompanies most instabilities of rigid-column-supported and geosynthetic-reinforced (RCGR) embankments. However, recognized guidelines specifically for evaluating the overall stability of such systems featuring bending failure remain limited. A general methodology to calculate the factor of safety (FS) for RCGR embankments using the limit equilibrium method is presented in this article. The focus is on deep-seated slope failures, wherein rigid columns progressively fracture due to subsoil overstressing. The concentric arches model, along with tensioned geosynthetic analysis, informs the determination of vertical and horizontal loads on the column heads. The column's resisting moment stems from its flexural and compression resistance. A mobilization factor for the net thrust on each column is defined to capture the progressive failure. The methodology involves an iterative computational procedure to identify the critical slip surface and the FS using the Fellenius' method. The solution was validated using three case studies, including both centrifuge models and field tests, as well as finite-element analysis. The results indicate that the soil mass contributes the most to resisting sliding and overall stability, followed by columns and geosynthetics. In addition, axial force mainly provides the resisting moment of columns.
1 November 2022 in Journal of Zhejiang University-SCIENCE A
Physical modelling of cantilever retaining walls with and without backfill reinforcement was conducted on a 1g shaking table to evaluate the mitigation eff
13 January 2020 in Mathematical Problems in Engineering
Hydraulic conductivity measurement through a fixed wall permeameter is a common practice to obtain the fluid transmissibility characteristics of soil matrix; however, sidewall leakage due to rigid wall effect may significantly influence the observed values for coarse-grained soils. In this study, the boundary flow error was identified through characterizing the geometrical properties of voids adjacent to the sidewall, and a parameter known as the boundary void ratio () was proposed to account for this effect. The findings suggest that a fixed wall cell containing coarse soils would unavoidably generate extra voids at the interface between soil grains and inner rigid wall, contributing to a larger at the wall than void ratio within the soil bed; the measured hydraulic conductivity is increased primarily due to the apparatus-induced error. A two-dimensional geometric model was then established to estimate the value for uniformly sized coarse soils confined by a rigid permeameter wall, based on which a method was obtained for eliminating the boundary flow error from a fixed wall cell. The mathematical method was finally validated against experimental data from existing literature. It can be concluded that the boundary condition at sidewall featuring unwanted gaps lead to overestimation of the coefficient of permeability; however, the proposed correction method could adequately eliminate the boundary flow error for uniformly sized coarse-grained soils tested within a rigid wall cell.
13 November 2014 in Science China Technological Sciences