This paper presents the results of a laboratory investigation on the performances and mixture combination parameters of railway asphalt concrete (RAC) for supporting high-speed railway slab track. To apply the RAC effectively to high-speed railway infrastructures, modified highway asphalt pavement material tests are conducted to verify mixture parameters. A suitable gradation is recommended based on the test results. The air voids of the material RAC-25 used for railway infrastructure should be controlled from 1 to 3%. The results presented in the paper demonstrate that asphalt content can be determined based on modified mixture parameters. To verify the performance and analyze the mechanistic response of RAC infrastructure, full-scale laboratory dynamic models are established under different environmental temperatures and loading levels. Based on model testing, the reinforced RAC foundation with a 12 cm deep graded gravel layer replaced by RAC-25 shows much better performance compared with the traditional design.
1 January 2023 in Journal of Materials in Civil Engineering
Antiaging effects of two inorganic nanoparticles [4% nano-titanium oxide ( ) and nano-zinc oxide (nano-ZnO)] on asphalt were investigated by liquid-state nuclear magnetic resonance (NMR) spectroscopy, multiple stress creep recovery (MSCR) tests, and linear amplitude sweep (LAS) tests. The rheology test results showed that rutting and fatigue performance of asphalt binder increased with the addition of nano-oxides, and the addition of nano-ZnO showed improved rutting resistance and fatigue life compared with . NMR spectroscopy shows that the aromatic hydrogen ratios and branchiness index (BI) of asphalt decrease significantly after aging. It indicated that some isomerization and dehydrogenation occurred during the aging process. After adding nano-oxides into asphalt binder, the aromatic hydrogen content and the number of branched chains in asphalt susceptible to oxidation are further reduced, which slows the aging degree of asphalt. NMR spectroscopy shows that the content of aromatic carbon is the key factor affecting asphalt aging. After original asphalt aging, the aromatic carbon ratios decreased, and adding nano-oxides into asphalt binder, whereas two kinds of nano-oxide-modified asphalt have different trends of aromatic carbon ratios. The antioxidant mechanism of is to inhibit the loss of aromatic carbon, whereas the oxidation of nano-ZnO-modified asphalt either inhibits the reaction of aging or causes sufficient aromatization to offset the influence of different degrees of asphalt aging.
In this paper, the rice husk ash and crumb rubber powder were used as a combined modifier for asphalt. The impact of the aging on the physical and rheological properties of crumb rubber powder, rice husk ash, and the combined modified asphalt was studied through the rolling thin film oven (RTFO) simulations. A Fourier-transform infrared Spectroscopy (FTIR) test was used to study the aging mechanisms of the combined crumb-rubber-powder- and rice-husk-ash-modified asphalt before and after aging through the changes in functional groups. Impacts of the combined, crumb rubber powder, and rice husk ash modifiers on the anti-aging characteristic of the asphalt binder were analyzed through different aging indices and the variations in intensity of the absorption peaks. According to the combined results, the addition of the combined crumb rubber powder, and rice husk ash could enhance the thermal oxidative aging resistance binder. Moreover, the optimal content of composite modified asphalt was (7% rice husk ash + 10% crumb rubber powder). In addition, the combined modified asphalt binder had all the peaks of neat asphalt, rice-husk-ash-modified asphalt, and crumb-rubber-powder-modified asphalt and no appearance of new peaks. A scanning electron microscope (SEM) test was carried out to observe the microstructure of the combined crumb-rubber-powder- and rice-husk-ash-modified asphalt binders. The obtained result demonstrated that different SEM images showed that the combined crumb rubber powder, and rice husk ash modifiers were uniformly dispersed inside the asphalt binder and consequently leading to format a homogeneous blended binder.
The skid resistance of asphalt pavement is an important factor affecting road safety. However, few studies have characterized the contribution of the macro- and micro-texture to the skid resistance of asphalt pavement. In this paper, the generalized extreme studentized deviate (GESD) and neighboring-region interpolation algorithm (NRIA) were used to identify and replace outliers, and median filters were used to suppress noise in texture data to reconstruct textures. On this basis, the separation of the macro- and micro-texture and the Monte Carlo algorithm were used to characterize the skid resistance of asphalt pavement. The results show that the GESD method can accurately identify outliers in the texture, and the median filtering can eliminate burrs in texture data while retaining more original detail information. The contribution of the macro-texture on the skid resistance is mainly attributed to the frictional resistance caused by the adhesion and elastic hysteresis, and the main contribution of the micro-texture is a micro-bulge cutting part in the friction mechanism. This investigation can provide inspiration for the interior mechanism and the specific relationship between the pavement textures and the skid resistance of asphalt pavement.
There is currently no mature calculation theory to accurately predict the settlement of high-fill subgrade. This paper developed an intelligent monitoring system to accurately predict the settlement of high-fill subgrade based on on-site experiments, and the back-propagation (BP) neural network model was used to predict the settlement of high-fill subgrade. The results show that multiple data preprocessing methods built into intelligent systems can automatically generate multi-point and correlation curves, and the system can identify and distinguish various influencing factors to improve the accuracy and reliability of monitoring data. There will be a certain initial settlement of subgrade in the initial stage after filling construction is completed, and the settlement rate at this stage is relatively fast. Afterwards, the soil enters a rapid consolidation stage, and the settlement rate of subgrade gradually slows down. Finally, the filling soil consolidation becomes stable, and the rate of subgrade settlement enters a relatively stable stage. In addition, the BP neural network model is a good method for predicting the settlement of high-fill subgrade. The research findings can provide inspiration for developing an intelligent monitoring system to accurately predict the settlement of high-fill subgrade.