Additive manufacture (AM) appears to be the most suitable technology to produce sophisticated, high quality, lightweight parts from Ti6Al4V alloy. However, the fatigue life of AM parts is of concern. In our study, we focused on a comparison of two techniques of additive manufacture—selective laser melting (SLM) and electron beam melting (EBM)—in terms of the mechanical properties during both static and dynamic loading. All of the samples were untreated to focus on the influence of surface condition inherent to SLM and EBM. The EBM samples were studied in the as-built state, while SLM was followed by heat treatment. The resulting similarity of microstructures led to comparable mechanical properties in tension, but, due to differences in surface roughness and specific internal defects, the fatigue strength of the EBM samples reached only half the value of the SLM samples. Higher surface roughness that is inherent to EBM contributed to multiple initiations of fatigue cracks, while only one crack initiated on the SLM surface. Also, facets that were formed by an intergranular cleavage fracture were observed in the EBM samples.
Ductile cast irons are often used for turbocharged diesel engine components. These components are usually subjected to cyclic thermo-mechanical loading during their lifetime due to variable service conditions. A reliable damage assessment is required to guarantee service function, safety or light weight of the products. The first objective of this paper is to introduce the new test stand designed for uniaxial Low Cycle Fatigue (LCF) and Thermo-Mechanical Fatigue (TMF) tests. The second objective of the paper is to assess the lifetime of SiMo (Silicon Molybdenum) cast iron. Based on the experimental results, an appropriate energy-based fatigue criterion is proposed for predicting the LCF/TMF of complex engineering components. Reasonable correlation was achieved between the observed results and the predicted results.
24 May 2016 in Fatigue & Fracture of Engineering Materials & Structures
This article focuses on the development of a carbon composite bicycle frame using various experimental methods of structural analysis. Two types of frame specimen were used. The complete frame specimen was tested in accordance with ISO test load cases with the addition of an ergometer test in order to refine the operational strain envelope of such a frame. Resistive strain gauges and optical Fiber Bragg Grating (FBG) sensors were used for this analysis. The FBG sensors were embedded inside the head tube joints during the manufacturing process. The head connection was designed as a geometrically precise form–connection of wound composite tubes, reinforced with a wrap of high-strength unidirectional carbon tapes and carbon fabrics. Additional structural strength laboratory tests were conducted using simplified frame specimens, in order to evaluate the range of the limit case strain ranges. The digital image correlation method was used for the evaluation of the strain distribution in the head tube area. Resistive strain gauges were used for local strain analysis in critical areas. The acoustic emission method was used to detect structural defects before they could influence the stiffness response of the frame. It was found that the joints of the frame tubes are crucial for the strength and safety of the frame. Therefore, attention was also focused on the strengthening of the head tube joint, and on its experimental verification. A positive effect on the strength of the reinforced frame was found by doubling the thickness of the carbon fabric in the head tube joint area.