As a result of energy assessment of a pneumatic sieve separator for agricultural crops it was determined that the specific energy consumption of the experimental pneumatic sieve separator was 0.18 kW·year·t −1 . It is lower than in case of its domestic and foreign equivalents. For instance, the specific energy consumption of the separator of preliminary grain purification called SPO-50 (Ukraine) is 0.31 kW·year·t −1 , and that of the machine of preliminary grain purification called MPO-50 (Russia) is 0.38 kW·year·t −1 . Specific energy consumption of a pneumatic sieve separator is 1.72-2.11 times lower than in case of its domestic and foreign counterparts.
27 February 2022 in Eastern-European Journal of Enterprise Technologies
This paper reports a study into the features of the phase composition and microstructure of a master alloy obtained by using the reduction melting of oxide man-made waste. That was necessary to define those technological indicators that provide for an increase in the degree of extraction of alloying elements during the recycling of anthropogenic raw materials and the subsequent use of the alloying material. It has been determined that the phase composition of the alloy at a Si:C ratio in the charge of 0.11 mainly consisted of a solid solution of elements in α-Fe, as well as carbides Fe3C and Fe3W3C. At the Si:C ratios in the charge of 0.28 and 0.52, along with a solid solution of the elements in α-Fe, Fe8Si2C, Fe5Si3, and FeSiC, FeSi2 manifested themselves, respectively. The microstructure of the alloy demonstrated a clear manifestation of several phases with different content of alloying elements. Changing a Si:C ratio in the charge from 0.11 to 0.28 and 0.52 led to an increase in the residual silicon content (wt %) in the studied areas, from 0.00–0.25 to 0.12–1.79 and 0.20–2.11, respectively. At the same time, the carbon content (wt %) in the examined areas varied from 0.25–2.12 to 0.24–2.52 and 0.45–2.68, respectively. The content of alloying elements in the investigated areas varied within (wt %): W – 0.00–43.06, Mo – 0.00–32.72, V – 0.19–20.72, Cr – 0.69–33.94, Co – 0.00–3.96. Analysis of the study’s results reveals that the most acceptable ratio of Si:C in the charge is 0.52. In this case, there is a certain content of residual silicon along with carbon in the form of carbosilicide and silicide compounds. Such indicators of the alloy provide sufficient reducing capacity of the alloy when used. The properties of the alloy make it possible, when smelting steels, to replace part of those standard ferroalloys that do not have strict carbon restrictions.
1 January 2019 in Scientific papers OF DMYTRO MOTORNYI TAVRIA STATE AGROTECHNOLOGICAL UNIVERSITY (ECONOMIC SCIENCES)