30 July 2013 in IEEE Journal of Solid-State Circuits
Flicker noise up-conversion in voltage-biased oscillators can be effectively suppressed by inserting resistances in series to the drain of the transconductor MOSFETs. This solution avoids the degradation of the start-up margin and the adoption of area-demanding resonant filters with proper tuning. This paper presents a detailed theoretical analysis of 1/f noise up-conversion and quantitatively addresses the impact of two major contributions, namely the Groszkowski effect and the loop delay caused by stray capacitances at the drain node of the transistors. A simple flow for the design of an oscillator with suppressed flicker noise up-conversion is presented which is based on first-order closed-form formulas. Finally , theoretical estimates are compared to experimental results on a 65-nm CMOS VCO covering the 3.0-3.6 GHz band.
20 May 2020 in IEEE Journal of Solid-State Circuits
This article analyses and demonstrates a 22.5-27.7-GHz fast-lock low-phase-noise bang-bang digital phase-locked loop (PLL) for millimeter-wave (mm-wave) communication. A discrete-time PLL model, together with theoretical transfer functions, gives insight on the functionality of the automatic bandwidth control, on the effect of the gear-shift algorithm for fast lock and on the different noise contributions. The proposed gear-shift algorithm scales up the PLL bandwidth for faster acquisition and orderly reduces it for jitter performance. The PLL contains a digitally controlled oscillator (DCO) based on transformer feedback with a tunable source-bridged capacitor, which allows for a low phase noise (PN) over a wide tuning range (FoM of -184 dBc/Hz and FoMT of -191 dBc/Hz) and for a fine frequency resolution. The PLL occupies 0.09-mm² core area and exhibits 220 fs rms jitter while consuming 25 mW, giving FoMRMS of -239 dB. Its frequency acquisition time improves from 780 to 45 μs with the gear-shift algorithm. For 60-GHz communication, with a frequency multiplication factor of 2.5, this PLL covers all six channels' frequencies of IEEE-802.11ad, allows a transmitter (TX) error vector magnitude (EVM) down to -35.9 dB assuming a TX signal to the noise-plus-distortion ratio (SNDR) of 40 dB, and, thus, is capable of supporting 256 quadrature amplitude modulation (QAM).
23 January 2012 in IEEE Transactions on Circuits and Systems I: Regular Papers
Harmonic content modulation of the oscillator output voltage can contribute to flicker noise up-conversion in LC-tuned oscillators. The paper reports a quantitative analysis of the effect in Van der Pol oscillators using the framework of the impulse sensitivity function (ISF). It is shown that most of the up-conversion efficiency results from the first harmonic of the ISF, which is not perfectly in quadrature to the output voltage waveform, and from the first harmonic of the transistor current, which is slightly lagging the voltage waveform. A closed-form expression of 1/f3 phase noise in voltage-limited LC-tuned oscillator is derived that is in good agreement with circuit simulations. The paper also shows that the values of both phase shifts are determined by the non-linearity of the active element and are linked to the relevant oscillator parameters, i.e., excess gain and tank quality factor.
3 May 2013 in IEEE Transactions on Microwave Theory and Techniques
Traditional design of voltage-controlled oscillators (VCOs) can lead to unacceptable degradation of the $1/f^3$ phase-noise component when a broad tuning range is required. In this paper, the flicker noise up-conversion mechanisms in a voltage-biased topology are deeply investigated, providing general design guidelines for its mitigation. An improved VCO architecture is then introduced, where a segmented transconductor tailors the excess gain depending on the operating range to ensure that $1/f$ noise up-conversion remains minimal over the tuning range. The solution covers both fourth-generation and WiMAX 2.5-GHz bands and leads to a 10-dB reduction of the $1/f^3$ phase noise with respect to a traditional design without impairing the $1/f^2$ phase-noise performance.
27 October 2016 in IEEE Transactions on Circuits and Systems I: Regular Papers
We present a rigorous phase noise analysis of a generic harmonic oscillator where the active core can be modeled as a transconductor. Phase noise equations are derived without any specific assumption on the nature of the resonator in the oscillator; furthermore, we provide closed-form 1/f2 phase noise equations when the resonator consists of an arbitrary number of cascaded LC tanks, each tuned at a different harmonic of the oscillation frequency. We also show that the phase noise caused by transconductor white noise is always proportional to the phase noise caused by resonator losses, and that no flicker noise from the transconductor is up-converted into phase noise in an oscillator with an odd-symmetric voltage waveform. The phase noise for a number of different oscillators/resonators has been simulated, always obtaining an exceedingly good agreement between theoretical predictions and numerical results.
17 August 2012 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief describes a simple method to compute the impulse sensitivity function (ISF) of oscillators by means of the periodic transfer function analysis that is available in most of the commercial circuit simulators. The proposed calculation method, relying on linear-time variant simulations, is at least an order of magnitude more efficient than a conventional direct computation of the ISF based on transient analysis.