1 May 2014 in Journal of Materials Processing Technology
10 December 2024 in Nature Communications
Although recycling secondary aluminum can lead to energy consumption reduction compared to primary aluminum manufacturing, products produced by traditional melt-based recycling processes are inherently limited in terms of alloy composition and microstructure, and thus final properties. To overcome the constraints associated with melting, we have developed a solid-phase recycling and simultaneous alloying method. This innovative process enables the alloying of 6063 aluminum scrap with copper, zinc, and magnesium to form a nanocluster-strengthened high-performance aluminum alloy with a composition and properties akin to 7075 aluminum alloy. The unique nanostructure with a high density of Guinier-Preston zones and uniformly precipitated nanoscale η‘/Mg(CuZn)2 strengthening phases enhances both yield and ultimate tensile strength by >200%. By delivering high-performance products from scrap that are not just recycled but upcycled, this scalable manufacturing approach provides a model for metal reuse, with the option for on-demand upcycling of a variety of metallic materials from scrap sources.
1 November 2017 in Science and Technology of Welding and Joining
In recent years, interest has been increasing in application of Nickel alloys in the oil industry. For subsea engineering, the possibility to weld high-strength materials in an effective manner is essential. Friction Stir Welding (FSW) is alternative to join several materials retaining their properties or even improving them. This fact is relevant for Corrosion-Resistant Alloys (CRA) used in deep-water exploitation of hydrocarbons. Publications up to now have focused on FSW of Inconel® series as alloy 600, 625, and 718. To provide a solid basis for development, this review discusses the crucial points for FSW. The tool materials are described, as well as the joint microstructure and properties achieved. Furthermore, the basics of the corrosion resistance and the early corrosion studies of FSW joints are presented. It is concluded that FSW is a promising process for Ni alloys, but depends on upcoming research regarding tool technology and corrosion investigations.
17 January 2023 in The International Journal of Advanced Manufacturing Technology
Friction surfacing (FS) is a solid-state layer deposition process for metallic materials at temperatures below their melting point. While the bonding of the deposited layers to the substrate is proven suitable for coating applications, so far the mechanical properties of additively manufactured stacks have not been systematically investigated. In particular, the effect of successive deposited FS layers, i.e., repetitive thermo-mechanical loading, on the interface properties as well as anisotropy and strength of the deposited stack is unknown. For this purpose, the mechanical properties of FS deposited multi-layer stacks from dissimilar aluminum alloys have been investigated, characterizing layer-to-layer as well as layer-to-substrate bonding interfaces via micro-flat tensile testing. Furthermore, directional dependencies in the stack and failure mechanisms are analyzed. The results show a homogeneous, fine-grained microstructure with average grain sizes between 4.2 and 4.6 μ m within the deposited material. The resulting tensile properties with no significant directional dependency present an ultimate tensile strength between 320 and 326 MPa exceeding the strength of the AA5083 H112 consumable base material. No difference was obtained in terms of layer-to-layer or layer-to-substrate interface strength. Furthermore, homogeneous hardness was observed within the deposited structure, which is in the range of AA5083 base material’s hardness of 91 HV. The results indicate that the FS process in conjunction with the material used is suitable for additively generated structures and highlight the potential of this solid-state layer deposition technology.
28 September 2018 in Fatigue & Fracture of Engineering Materials & Structures