Hydrogen is the alternative renewable energy source for addressing the energy crisis, global warming, and climate change. Hydrogen is mostly obtained in the industrial process by steam reforming of natural gas. In the present work, CuCrO2 particles were attached to the surfaces of electrospun CeO2 nanofibers to form CeO2-CuCrO2 nanofibers. However, the CuCrO2 particles did not readily adhere to the surfaces of the CeO2 nanofibers, so a trace amount of SiO2 was added to the surfaces to make them hydrophilic. After the SiO2 modification, the CeO2 nanofibers were immersed in Cu-Cr-O precursor and annealed in a vacuum atmosphere to form CeO2-CuCrO2 nanofibers. The CuCrO2, CeO2, and CeO2-CuCrO2 nanofibers were examined by X-ray diffraction analysis, transmission electron microscopy, field emission scanning electron microscopy, scanning transmission electron microscope, thermogravimetric analysis, and Brunauer–Emmett–Teller studies (BET). The BET surface area of the CeO2-CuCrO2 nanofibers was 15.06 m2/g. The CeO2-CuCrO2 nanofibers exhibited hydrogen generation rates of up to 1335.16 mL min−1 g-cat−1 at 773 K. Furthermore, the CeO2-CuCrO2 nanofibers produced more hydrogen at lower temperatures. The hydrogen generation performance of these CeO2-CuCrO2 nanofibers could be of great importance in industry and have an economic impact.
In this study, ZnFe2O4 and ZnO-ZnFe2O4 catalysts were prepared using the glycine–nitrate process (GNP). The prepared ZnFe2O4 and ZnO-ZnFe2O4 catalyst powders were characterized using a scanning electron microscope, transmission electron microscope, XRD diffraction studies, and selected area diffraction pattern studies. In addition, the specific surface area was measured using a Brunauer–Emmett–Teller specific surface area analysis. The hydrogen reduction in different temperature ranges was analyzed using the H2 temperature-programmed reduction technique. The specific surface area of the ZnFe2O4 was 5.66 m2/g, and the specific surface area of the ZnO-ZnFe2O4 was 8.20 m2/g at a G/N ratio of 1.5 and at a G/N ratio of 1.7, respectively. The specific surface area of the ZnFe2O4 was 6.03 m2/g, and the specific surface area of the ZnO-ZnFe2O4 was 11.67 m2/g. The ZnFe2O4 and ZnO-ZnFe2O4 were found to have the best catalytic effect at 500 °C. In particular, the highest H2 generation rate of the ZnO-ZnFe2O4 (GN = 1.7) at 500 °C was 7745 mL STP min−1 g-cat−1. Moreover, the ZnO-ZnFe2 O4 catalyst demonstrated good H2 selectivity and stability during the process of steam reforming methanol. Therefore, the ZnO-ZnFe2O4 catalyst powder exhibited high catalytic activity due to the good dispersibility of the ZnO, which increased the specific surface area of the catalyst. In the future, the catalyst can be applied to the steam reforming of methanol for industrial purposes.
9 May 2023 in International Journal of Hydrogen Energy