22 November 2016 in International Journal of Antennas and Propagation
A novel dual-band, single element multiple input multiple output (MIMO) dielectric resonator antenna (DRA) with a modest frequency tuning ability is presented in this communication. The proposed antenna operates at GPS L1/Bluetooth/Wi-Fi/LTE2500/WLAN2400 frequency bands. A single dielectric resonator element is fed by two coaxial probes to excite the orthogonal modes. A couple of slots are introduced on the ground plane to improve the isolation between antenna ports. The slots also serve the purpose of reconfiguration in the lower band on placement of switches at optimized locations. The measured impedance bandwidth is 5.16% (1.41–1.49 GHz) in the lower band and 26% (2.2–2.85 GHz) in the higher band. The lower band reconfigures with an impedance bandwidth of 6.5% (1.55–1.65 GHz) when PIN diodes are switched ON. The gain, efficiency, correlation coefficient, and diversity gain of the MIMO DRA are presented with a close agreement between simulated and measured results.
31 August 2020 in Microwave and Optical Technology Letters
25 September 2017 in International Journal of Antennas and Propagation
A compact hybrid antenna structure with frequency reconfiguration capabilities is presented in this article. The proposed design employs a combination of a rectangular DR element and a coupling slot on the structure’s ground plane (GP). The slot shifts the fundamental DRA mode by introducing a slow wave effect and its resonant behavior helps to achieve an omnidirectional pattern at low frequencies. The slot is loaded with a series of PIN diode switches whose ON/OFF combinations alter the effective slot length. Slot loading with PIN diodes results in frequency reconfiguration of the proposed structure with a large tuning range of 76.2% (between 1.73 and 3.86 GHz). A parametric analysis was performed to investigate the effects of slot length, width, and position on the reflection coefficients of the proposed structure. A prototype of the proposed design was fabricated and results were measured. The measured results show a close agreement with the simulated ones. The proposed design is suitable for DCS 1800 MHz, PCS 1900 MHZ, UMTS, LTE 2500–2700 MHz, and Wimax 3.5 GHz.
9 August 2018 in International Journal of Antennas and Propagation