21 May 2019 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
This paper presents a 28-GHz low phase noise voltage-controlled oscillator (VCO) in a 65-nm CMOS process for 5G communication applications. With the capacitive splitting and transformer feedback techniques, theoretical analysis and simulations are undertaken for the proposed oscillator, proving that its negative Gm can be enhanced over the interested frequency range and reduced at the harmonic frequencies. Moreover, the proposed oscillator startup performance is analyzed, and its tank quality factor, transient and phase noise performance are simulated. With 4-bit switch capacitors and varactors, the proposed VCO achieves a tuning range from 25.7 to 29.7 GHz, consuming 10.8 mW from a 0.9-V supply voltage. With a wideband common-source buffer, the output signal power is around 1 dBm. At 26.5 GHz, the proposed VCO achieves low phase noise of -105.8 dBc/Hz at 1-MHz offset and -130 dBc/Hz at the 10-MHz offset, respectively.
27 May 2020 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
This article presents a 32-GHz frequency-modulated continuous wave (FMCW) modulator based on the phase-locked loop (PLL) with nested sub-PLL structure in a 65-nm CMOS process. With the sub-PLL, the low-pass effect in phase domain is realized, reducing the noise folding effect, quantization noise, and spurs due to the delta sigma modulator (DSM). To achieve good stability and phase noise performance, both the phase-domain model and the phase noise model are analyzed and simulated. Based on these models, the chirp linearity is discussed and simulated, which helps to determine the design parameters and verifies the linearity improvement. The measurement results illustrate that in fractional-N mode, the nested-PLL achieves the phase noise of -91 dBc/Hz at 1-MHz offset frequency and the fractional spurs of less than -54 dBc at 30.78-GHz output frequency. In FMCW mode, the proposed modulator achieves a triangular chirp with 1.08-2.16-GHz bandwidth at about 32-GHz center frequency. In addition, the measured root mean square (rms) frequency errors of 400 and 770 kHz are achieved with the ramp slopes of 1.08 GHz/93 μs and 2.16 GHz/93 μs, respectively. Measurement results prove the improvements of the phase noise and chirp linearity with the sub-PLL. Including all pads, the chip occupies a silicon area of 1.5 mm², and consumes 62-mW dc power.