Germanium-tin (GeSn) p-channel fin field-effect transistor (p-FinFET) was realized on a novel GeSn-on-insulator (GeSnOI) substrate. The high-quality GeSnOI substrate was formed using direct wafer bonding technique and was layer-transferred from a 300-mm GeSn/Ge/Si donor wafer. Material quality was examined using atomic force microscopy, high-resolution transmission electron microscopy, Raman spectroscopy, and high-resolution X-ray diffraction. The fabricated GeSn p-FinFETs exhibit a small subthreshold swing (S) of 79 mV/decade at V DS of -0.05 V (by a device with L CH of 200 nm and W Fin of 30 nm), good control of short channel effects, and high intrinsic transconductance (G m,int = 702 μS/μm at V DS of -0.5 V for L CH of 80 nm). Low-temperature mobility analysis was performed on the GeSn p-FinFETs. High effective hole mobility (μ eff ) (210 cm 2 /V·s at 290 K and 398 cm 2 /V·s at 5 K) is achieved. The GeSn p-FinFETs presented in this paper exhibit the highest G m,int /S sat at V DS of -0.5 V for all the reported GeSn p-FETs to date.
GeSn-on-insulator (GeSnOI) on Silicon (Si) substrate was realized using direct wafer bonding technique. This process involves the growth of Ge1-xSnx layer on a first Si (001) substrate (donor wafer) followed by the deposition of SiO2 on Ge1-xSnx, the bonding of the donor wafer to a second Si (001) substrate (handle wafer), and removal of the Si donor wafer. The GeSnOI material quality is investigated using high-resolution transmission electron microscopy, high-resolution X-ray diffraction (HRXRD), atomic-force microscopy, Raman spectroscopy, and spectroscopic ellipsometry. The Ge1-xSnx layer on GeSnOI substrate has a surface roughness of 1.90 nm, which is higher than that of the original Ge1-xSnx epilayer before transfer (surface roughness is 0.528 nm). The compressive strain of the Ge1-xSnx film in the GeSnOI is as low as 0.10% as confirmed using HRXRD and Raman spectroscopy.
The effect of room temperature sulfur passivation of the surface of Ge0.83Sn0.17 prior to high-k dielectric (HfO2) deposition is investigated. X-ray photoelectron spectroscopy (XPS) was used to examine the chemical bonding at the interface of HfO2 and Ge0.83Sn0.17. Sulfur passivation is found to be effective in suppressing the formation of both Ge oxides and Sn oxides. A comparison of XPS results for sulfur-passivated and non-passivated Ge0.83Sn0.17 samples shows that sulfur passivation of the GeSn surface could also suppress the surface segregation of Sn atoms. In addition, sulfur passivation reduces the interface trap density Dit at the high-k dielectric/Ge0.83Sn0.17 interface from the valence band edge to the midgap of Ge0.83Sn0.17, as compared with a non-passivated control. The impact of the improved Dit is demonstrated in Ge0.83Sn0.17 p-channel metal-oxide-semiconductor field-effect transistors (p-MOSFETs). Ge0.83Sn0.17 p-MOSFETs with sulfur passivation show improved subthreshold swing S, intrinsic transconductance Gm,int, and effective hole mobility μeff as compared with the non-passivated control. At a high inversion carrier density Ninv of 1 × 1013 cm−2, sulfur passivation increases μeff by 25% in Ge0.83Sn0.17 p-MOSFETs.
7 May 2019 in IEEE Journal of the Electron Devices Society
We propose and demonstrate Ga2O3 MOSFETs on a high thermal conductivity AlN/Si substrate to improve the heat dissipation capability and keep their cost-effectiveness. Owing to the optimized S/D contact and Al2O3/Ga2O3 interface, a drain current of 580 mA/mm and peak intrinsic transconductance Gm,int of 35.5 mS/mm were achieved, which are among the highest for all the reported top-gate Ga2O3 MOSFETs. A peak mobility of 82.9 cm2/V.s, a high saturation velocity vsat of 1.1 × 107 cm/s, and a low interface trap density of 1.1 × 1012 cm-2eV-1 are also obtained. Pulse measurement reveals the good heat dissipation capability of the AlN/Si substrate. A three terminal off-state breakdown voltage Vbr of 118 V, a small specific on resistance Ron,sp of 1.44 mΩ.cm2, and power figure-of-merit of 9.7 MW/cm2 are achieved in a device with LGD of 1.14 μm. These excellent results indicate the great potential of Ga2O3 MOSFETs on AlN/Si substrate for future power electronics applications.
A heavily Ga-doped Ge0.95Sn0.05 layer was grown on the Ge (100) substrate by molecular beam epitaxy (MBE), achieving an active doping concentration of 1.6 × 1020 cm−3 without the use of ion implantation and high temperature annealing that could cause Sn precipitation or surface segregation. An advanced nano-scale transfer length method was used to extract the specific contact resistivity ρc between the metal and the heavily doped p-Ge0.95Sn0.05 layer. By incorporating Sn into Ge and in-situ Ga doping during the MBE growth, an ultra-low ρc of 1.4 × 10−9 Ω·cm2 was achieved, which is 50% lower than the ρc of p+-Ge control and is also the lowest value obtained for metal/p-type semiconductor contacts.