1 January 2016 in Physics Procedia
Alloying of refractory high entropy alloys (HEAs) such as MoNbTaW is usually done by vacuum arc melting (VAM) or powder metallurgy (PM) due to the high melting points of the elements. Machining to produce the final shape of parts is often needed after the PM process. Casting processes, which are often used for aerospace components (turbine blades, vanes), are not possible. Direct metal deposition (DMD) is an additive manufacturing technique used for the refurbishment of superalloy components, but generating these components from the bottom up is also of current research interest. MoNbTaW possesses high yield strength at high temperatures and could be an alternative to state-of-the-art materials. In this study, DMD of an equimolar mixture of elemental powders was performed with a pulsed Nd:YAG laser. Single wall structures were built, deposition strategies developed and the microstructure of MoNbTaW was analyzed by back scattered electrons (BSE) and energy dispersive X-ray (EDX) spectroscopy in a scanning electron microscope. DMD enables the generation of composition gradients by using dynamic powder mixing instead of pre-alloyed powders. However, the simultaneous handling of several elemental or pre-alloyed powders brings new challenges to the deposition process. The influence of thermal properties, melting point and vapor pressure on the deposition process and chemical composition will be discussed
1 January 2019 in Additive Manufacturing
30 December 2020 in International Journal of Extreme Manufacturing
Progress in materials development is often paced by the time required to produce and evaluate a large number of alloys with different chemical compositions. This applies especially to refractory high-entropy alloys (RHEAs), which are difficult to synthesize and process by conventional methods. To evaluate a possible way to accelerate the process, high-throughput laser metal deposition was used in this work to prepare a quinary RHEA, TiZrNbHfTa, as well as its quaternary and ternary subsystems by in-situ alloying of elemental powders. Compositionally graded variants of the quinary RHEA were also analyzed. Our results show that the influence of various parameters such as powder shape and purity, alloy composition, and especially the solidification range, on the processability, microstructure, porosity, and mechanical properties can be investigated rapidly. The strength of these alloys was mainly affected by the oxygen and nitrogen contents of the starting powders, while substitutional solid solution strengthening played a minor role.
1 December 2018 in Additive Manufacturing
1 March 2021 in Journal of Laser Applications
Additive manufacturing with polymers is typically performed using techniques such as stereolithography, selective laser sintering (SLS), or fused deposition modeling. SLS of unmodified powders with CO2 lasers represents the state of the art in powder-based polymer additive manufacturing. In the presented work, thermoplastic polyurethane was successfully processed for the first time with a powder feed technique, which is similar to the well-known laser metal deposition. The powder material was doped with carbon black in order to increase the absorptivity of the powder material for laser radiation in the near-infrared range. Various geometries were produced using a standard laser cladding setup with a modified powder feeding system and an Nd:YAG laser. The powder material and the generated structures were characterized by scanning electron microscopy. Structural properties, e.g., porosity, were controlled by different fabrication strategies and process parameters. Furthermore, hybrid structures consisting of metal and polymer parts were successfully produced in the same experimental setup by using two different powder feeders.
1 January 2018 in Procedia CIRP