Paweł Jakóbczyk

Paweł Jakóbczyk

Auto-generated profile, based on publicly available information

Paweł Jakóbczyk

Faculty of Electronics, Telecommunications and Informatics, Gdansk University of Technology, Gdansk, Poland

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 March 2013 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
ALAndrzej Lewandowski
Andrzej Lewandowski
PJPawel Jakobczyk
Pawel Jakobczyk
MGMaciej Galiński
Maciej Galiński
MBMarcin Biegun
Marcin Biegun
Spontaneous voltage drop between EDLC electrodes, when it is kept under the open-circuit condition, is commonly called ‘self-discharge’ and is interpreted as a result of energy loss by the device. Three mechanisms of self-discharge were proposed: due to a leakage-current, faradaic reactions and charge redistribution. According to the law of energy preservation, if the voltage drop is associated with the energy loss, the energy would more likely be exchanged with the environment. While heat generation was measured during EDLC charging and discharging, the corresponding effect during storage under open-circuit conditions has not been reported. This may support the conclusion that voltage changes during ‘self-discharge’ are not related to a considerable energy loss. Moreover, it has been shown that a two-stage charging process, i.e. first galvanostatic charging followed by a potentiostatic charge redistribution, resulted in considerably slower potential changes when the device was switched to the open circuit. All discussed models were based on the assumption that the energy accumulated by EDLCs is proportional to the voltage in the second power, with capacitance (C/2) as the proportionality constant. However, it has been shown that during EDLC charging or discharging through a resistance R, equations valid for ‘dielectric’ and electrolytic capacitors, do not hold in the case of EDLCs. Consequently, the assumption that the energetic state of the EDLC is proportional at any time to the voltage in the second power may not be valid due to considerable variability of the ‘constant’ C. Therefore, voltage changes may not reflect the energetic state of the device.

1 April 2020 in Journal of Hazardous Materials
Verified
Journal Article
Open access
ADAnna Dettlaff
Anna Dettlaff
PJP. Jakóbczyk
P. Jakóbczyk
MFM. Ficek
M. Ficek
BWB. Wilk
B. Wilk
MSM. Szala
M. Szala
RBRobert Bogdanowicz
Robert Bogdanowicz
The study is devoted to the electrochemical detection of trace explosives on boron-doped diamond/graphene nanowall electrodes (B:DGNW). The electrodes were fabricated in a one-step growth process using chemical vapour deposition without any additional modifications. The electrochemical investigations were focused on the determination of the important nitroaromatic explosive compounds, 2,4,6-trinitrotoluene (TNT) and 2,4,6-trinitroanisole (TNA). The distinct reduction peaks of both studied compounds were observed regardless of the pH value of the solution. The reduction peak currents were linearly related to the concentration of TNT and TNA in the range from 0.05-15 ppm. Nevertheless, two various linear trends were observed, attributed respectively to the adsorption processes at low concentrations up to the diffusional character of detection for larger contamination levels. The limit of detection of TNT and TNA is equal to 73 ppb and 270 ppb, respectively. Moreover, the proposed detection strategy has been applied under real conditions with a significant concentration of interfering compounds - in landfill leachates. The proposed bare B:DGNW electrodes were revealed to have a high electroactive area towards the voltammetric determination of various nitroaromatic compounds with a high rate of repeatability, thus appearing to be an attractive nanocarbon surface for further applications.

1 November 2020 in Journal of Molecular Liquids
Verified
Journal Article
Closed access
ASA. Swiderska-Mocek
A. Swiderska-Mocek
PJP. Jakobczyk
P. Jakobczyk
ERE. Rudnicka
E. Rudnicka
ALA. Lewandowski
A. Lewandowski

1 January 2021 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
Mattia PierpaoliMattia Pierpaoli
Mattia Pierpaoli
PJPaweł Jakobczyk
Paweł Jakobczyk
MSMirosław Sawczak
Mirosław Sawczak
AŁAneta Łuczkiewicz
Aneta Łuczkiewicz
SFSylwia Fudala-Książek
Sylwia Fudala-Książek
RBRobert Bogdanowicz
Robert Bogdanowicz

1 August 2021 in Acta Materialia
Verified
Journal Article
Closed access
Mattia PierpaoliMattia Pierpaoli
Mattia Pierpaoli
Mateusz FicekMateusz Ficek
Mateusz Ficek
PJPaweł Jakóbczyk
Paweł Jakóbczyk
JKJakub Karczewski
Jakub Karczewski
RBRobert Bogdanowicz
Robert Bogdanowicz

30 September 2021 in npj 2D Materials and Applications
Verified
Journal Article
Open access
PDF file
Maciej MolasMaciej Molas
Maciej Molas
ŁMŁukasz Macewicz
Łukasz Macewicz
AWAleksandra Wieloszyńska
Aleksandra Wieloszyńska
PJPaweł Jakóbczyk
Paweł Jakóbczyk
AWAndrzej Wysmołek
Andrzej Wysmołek
Jacek JasinskiJacek Jasinski
Jacek Jasinski
Here, we provide a detailed evaluation of photoluminescence (PL) as a comprehensive tool for phosphorene characterization with the emphasis on a prominent quantitative role of PL in providing fingerprint-like features due to its extreme sensitivity to the band structure details, anisotropy, disorder, external fields, etc. Factors such as number of layers, dimensionality, structural and chemical disorder, and environmental factors and their effect on phosphorene’s PL signal are reviewed and discussed. Applications of PL in monitoring phosphorene and its modifications, as well as potential impacts on the fields of chemical and biosensing, nanomedicine, and solar energy harvesting, are also elaborated.