A large amount of tobacco straw residues is produced around the world every year. These tobacco straw residues are usually incinerated or landfilled directly, which cause environmental pollution and waste of resources. Therefore, it is necessary to find a green way to recycle these tobacco straw residues. Converting tobacco straw residues into biomass carbon materials for supercapacitor electrode materials is an appropriate way. In this study, tobacco straw core carbon (TSC) was obtained from tobacco straw core waste, which was carbonized directly in the tube furnace without N2. The tobacco straw core carbon had a higher specific surface area because of the self-activation of the H2O and CO2 in the carbonization. A variety of analytical instruments were used to characterize the prepared porous carbon. Herein, this work can provide new ideas for energy materials, and solve the problem of the disposal of tobacco straw residues. What’s more, it also can provide a sustainable development opportunity for tobacco farmers to alleviate poverty, dig potential and transform.
Amplitude-noise squeezing due to saturation in parametric multicasting is investigated. The improved receiver sensitivity of 10 copies by 2-dB over a phase-insensitive device has been obtained as a result of signal-gain elevation, and noise-quenching in a four-mode phase-sensitive parametric multicaster.
1 September 2019 in IOP Conference Series: Earth and Environmental Science
The hole formation is the most important link in the construction of bored piles. The quality of the hole formation plays a decisive role in the bearing capacity of cast-in-place piles. Combined with the field measurement data of hole formation in Changzhou Science And Technology Financial Center, combined with the time factor and the buried depth factor, the pore diameter change was analyzed. At the same time, the monitoring data was compared and analyzed by means of numerical simulation. The results show that the stress releases and the pore diameter decreases with the change of depth. With the increase of time, the pore size decreases. Due to the influence of soil structure, the pore diameter shrinkage of silty sand layer is up to 12.5%, while the silty clay layer is generally relatively small, with the maximum value not exceeding 6.25%.