1 May 2017 in BioResources
Plywood can be used in the furniture industry and in civil construction due to its structural strength. However, for long useful life in construction, especially in tropical countries, it needs to undergo treatments against xylophagous organisms. The most common preservative treatment is the chemical chromated copper arsenate (CCA); there are alternatives, such as heat treatment, that do not use chemicals. The objective of this work was to evaluate the mechanical resistance of CCA and heat-treated plywood prepared at three different temperatures (160 °C, 180 °C, and 200 °C). Pinus taeda plywood with seven veneers and phenol-formaldehyde adhesive was produced and subjected to the preservative treatments. The results showed that the CCA treatment reduced the mechanical strength of the panels, while the heat treatment did not. Heat treatment also decreased panel hygroscopicity, indicating a better dimensional stability.
7 February 2019 in BioResources
COCarolina A. B. Oliveira
ASAlexandre J. D. de Souza
+1
Cement-based composites with lignocellulosic residues (e.g. wheat straw, rice husk, and bagasse) as fillers have reduced density and cost. Pretreatments have been applied in these raw materials to improve their compatibility with cement. This work aimed to characterize composites made from cement and wheat straw particles that had been chemically treated (2% NaOH solution) at two different temperatures (30 °C and 60 °C). Values of bulk density (209 kg·m-3) and specific density (679 kg·m-3) were determined for wheat straw at 12% moisture content. Straw yield was 71.9% and the particle size distribution showed large concentrations of wheat straw particulate material between 5- to 10-mesh. Composites made with wheat straw particles, in comparison to the control treatment, showed half the density, i.e., from 1800 to 900 kg·m-3. Also, the stress x strain curve presented a higher deformation before failure. NaOH pretreatment did not affect the mechanical properties of wheat straw composites.
2 May 2019 in Acta Scientiarum. Technology
20 February 2025 in European Journal of Wood and Wood Products
3 October 2016 in Scientia Forestalis
FLFrancisco Antonio Rocco Lahr
Francisco Antonio Rocco Lahr
3 August 2023 in Maderas. Ciencia y Tecnología
KOKarina Aparecida De Oliveira
Karina Aparecida De Oliveira
COCarolina Aparecida Barros Oliveira
Carolina Aparecida Barros Oliveira
MSMaria Fernanda Felippe Silva
Maria Fernanda Felippe Silva
The proper choice of raw materials and manufacturing parameters for Cross Laminated Timber is essential to promote the proper bonding of the lamellas, aiming at their application in construction. However, few Brazilian species are currently used in the production of Cross Laminated Timber. The aim of this work was to characterize the bonding quality of four Brazilian reforestation species (Pinus elliottii, Eucalyptus grandis, Toona ciliata and Acrocarpus fraxinifolius) in the manufacture of Cross Laminated Timber with two-component polyurethane adhesive and five different pressure levels (from 0,1 MPa to 1,3 MPa). Bonding quality was evaluated through delamination and glue line shear tests based on the standard EN 14080 (2013). Delamination was affected by the wood species, and the best adhesion occurred for the Cross Laminated Timber manufactured with Pinus elliottii and Acrocarpus fraxinifolius at the bonding pressure of 0,7 MPa. Cross Laminated Timber bonding pressure did not affect the percentage of wood in the shear test fractured surface, whereas higher density Cross Laminated Timber showed higher percentages.