LeighAnn S. Larkin

LeighAnn S. Larkin

Auto-generated profile, based on publicly available information

LeighAnn S. Larkin

Army Research Laboratory, Adelphi, MD, USA

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 August 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
KKKyuhwe Kang
Kyuhwe Kang
APAbhishek Pathak
Abhishek Pathak
YSYiwen Song
Yiwen Song
HWHusam Walwil
Husam Walwil
TMTimothy Mirabito
Timothy Mirabito
SCSukwon Choi
Sukwon Choi
AlxGa1−xN with a high Al composition (x) presents significant potential for advancing next-generation high-power electronic devices. To support the thermal design of AlxGa1−xN-based electronics, the thermal conductivity of AlxGa1−xN thin films was measured as a function of Al composition, temperature, and film thickness using time-domain thermoreflectance and frequency-domain thermoreflectance techniques. The measurement results were interpreted by modeling phonon transport in AlxGa1−xN films using the phonon Boltzmann transport equation. Phonon properties, including frequencies, group velocities, and lifetimes, were calculated using a virtual crystal approximation, with the effects of mass-disorder scattering incorporated via the Tamura model. The measured thermal conductivity of Al0.7Ga0.3N is an order of magnitude lower than those for GaN and AlN, exhibits an increase followed by saturation with temperature, and shows a modest decrease with a reduction in the film thickness. The modeling results agree with the measurement results and reveal that mass-disorder scattering and phonon-boundary scattering are the dominant mechanisms that reduce the thermal conductivity of AlxGa1−xN thin films.

7 October 2024 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
LLL. S. Larkin
L. S. Larkin
MJM. Ji
M. Ji
GGG. A. Garrett
G. A. Garrett
VPV. Parameshwaran
V. Parameshwaran
JDJohn Derek Demaree
John Derek Demaree
MWM. Wraback
M. Wraback
Time-resolved cathodoluminescence using 30 keV ultrafast electron pulses has been used to perform direct measurements of the minority hole lifetime τh as a function of 3.7 MeV α-particle fluence in high-quality free-standing n-type GaN substrates. The lifetime damage factor K calculated from these measurements was found to monotonically decrease from 6.9 × 10−2 to 6.4 × 10−4 cm2 s−1 ion−1 with increasing α-fluence from 108 to 1012 cm−2, implying a reduction in trap cross section and/or an aggregation of α-induced traps. The small, ∼200–300 nm, hole diffusion length estimated from the minority hole lifetime for the highest α-fluence necessitates the deployment of α-voltaic device strategies and architectures that emphasize depletion and drift over diffusion for effective charge collection and optimal power conversion efficiency.


29 July 2026 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
DSD. F. Storm
D. F. Storm
YCY. Chen
Y. Chen
LLL. S. Larkin
L. S. Larkin
JGJ. K. Gustafson
J. K. Gustafson
MJM. Ji
M. Ji
MWM. Wraback
M. Wraback
We have grown two sets of 500-nm-thick n+-Al0.85Ga0.15N layers on AlN templates at various substrate temperatures between 700 and 875 °C by plasma-assisted molecular beam epitaxy, differing only in the detailed surface treatment prior to growth. In one set, Ga deposition and desorption (Ga D&D) on the template surface is performed at the substrate temperature used for growth prior to film deposition, while in the other set, the Ga D&D is performed at 875 °C for all the samples. These layers were doped with Si at a nominal concentration of 3 × 1019 cm−3. We observe significantly red-shifted (∼850 meV) photoluminescence for sub-bandgap optical pumping, the intensity of which increases as the growth temperature of the layer increases. We attribute this sub-bandgap emission to the presence of nanoscale compositional inhomogeneities in the layers and speculate that they contribute to the reduced Hall mobility. Reciprocal space mapping indicates that most of the AlGaN layers are under compressive strain and are pseudomorphic to the AlN template, while the samples with the highest Hall mobility and least intense sub-bandgap emission are under smaller tensile strain. We attribute the presence of tensile strain to layer growth on a Ga-rich compliant pseudosubstrate that presents for Ga D&D and growth at 700 and 750 °C, for which Ga desorption is incomplete prior to growth initiation.

21 August 2025 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
NSNusrat H. Sarwahrdy
Nusrat H. Sarwahrdy
GTG. Amalthea Trobare
G. Amalthea Trobare
JDJohn Derek Demaree
John Derek Demaree
NBNicholas P. Barbieri
Nicholas P. Barbieri
JSJeremy L. Smith
Jeremy L. Smith
MLMarc S. Litz
Marc S. Litz
Absolute light yield and radiation damage resilience were calculated and measured in ten scintillators suitable for use in alpha-photovoltaic energy conversion devices. The scintillators were exposed to alpha fluences of 1010 - 1015 ions/cm2 to experimentally measure long-term damage to these materials. Scintillator light yield was calculated from IV curves in a calibrated InGaP photovoltaic diode. CsI:Tl had the largest initial light yield (4.8 kph/MeV) of all scintillators evaluated. An alpha fluence of 8.6 × 1014 ions/cm2 reduced the light yield by 90% in CsI:Tl. The initial system efficiency of CsI:Tl on InGaP was measured to be 0.23%. Alpha-photovoltaic energy conversion devices with this initial system efficiency comprised of 1 mCi (3.7 × 107 alphas/s) of 241Am on CsI:Tl scintillators mounted on InGaP PIN photovoltaic diodes will produce 747.9 nW of electrical power. The power output from alpha stimulated CsI:Tl is 50% better than the conventional ZnS:Ag scintillator when used with an InGaP energy converter.