This article presents a 26–30 GHz gallium nitride (GaN) high electron mobility transistor (HEMT) low-noise amplifier (LNA) for fifth-generation base station applications. In the proposed design, a series inductor-based stability enhancement technique was utilized to improve the reverse isolation and stability performance of the amplifier and to mitigate the effect of the parasitic capacitance of the GaN HEMT device. To validate the concept of the design, a three-stage GaN HEMT LNA was designed and fabricated in a 0.15-um GaN on silicon carbide technology. The demonstrated design achieved a gain of 20.2 dB, a noise figure of 2.4–2.5 dB, an output 1-dB compression point of 17.2 dBm, and an output third-order intercept point of 32.2 dBm. The design also attained stability (μ criterion) up to 7.7 at the operating frequency. The implemented design consumed power of 320 mW with a nominal supply of 10 V.
We report on the fabrication of an AlGaAs/InGaAs/GaAs pseudomorphic high electron mobility transistor (PHEMT) using a dielectric-defined process. This process was utilized to fabricate 0.12 μm × 100 µm T-gate PHEMTs. A two-step etch process was performed to define the gate footprint in the SiNx. The SiNx was etched either by dry etching alone or using a combination of wet and dry etching. The gate recessing was done in three steps: a wet etching for removal of the damaged surface layer, a dry etching for the narrow recess, and wet etching. A structure for the top of the T-gate consisting of a wide head part and a narrow lower layer part has been employed, taking advantage of the large cross-sectional area of the gate and its mechanically stable structure. From s-parameter data of up to 50 GHz, an extrapolated cut-off frequency of as high as 104 GHz was obtained. When comparing sample C (combination of wet and dry etching for the SiNx) with sample A (dry etching for the SiNx), we observed an 62.5% increase of the cut-off frequency. This is believed to be due to considerable decreases of the gate-source and gate-drain capacitances. This improvement in RF performance can be understood in terms of the decrease in parasitic capacitances, which is due to the use of the dielectric and the gate recess etching method.
30 June 2023 in The Journal of Korean Institute of Electromagnetic Engineering and Science
Gallium Nitride (GaN) high-electron mobility transistors (HEMTs) are highly promising for high-frequency and high-power applications due to their superior properties, such as a wide energy bandgap and high carrier density. The performance of GaN HEMTs is significantly influenced by the interfacial states of the AlGaN barrier, and gate annealing has emerged as a key process for reducing leakage currents and enhancing DC/RF characteristics. This research investigates the impact of gate annealing on AlGaN/GaN HEMTs, focusing on two main aspects: leakage current reduction and improvements in DC and RF efficiency. Through comprehensive electrical analysis, including DC and RF measurements, the effects of gate annealing were experimentally evaluated. The results show a significant reduction in gate leakage current and noticeable improvements in DC/RF performance for the devices that underwent gate annealing. The study confirms that the annealing process can effectively enhance device performance by modifying the material properties at the gate interface.