Claudia Cristina Castellano

Claudia Cristina Castellano

Auto-generated profile, based on publicly available information

Claudia Cristina Castellano

Facultad de Ingeniería, CIFICEN (UNCPBA-CICPBA-CONICET), Universidad Nacional del Centro de la Provincia de Buenos Aires, Olavarría B7400JWI, Argentina

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 May 2019 in Materials
Verified
Journal Article
Open access
PDF file
VRViviana Fátima Rahhal
Viviana Fátima Rahhal
MTMonica Adriana Trezza
Monica Adriana Trezza
ATAlejandra Tironi
Alejandra Tironi
CCClaudia Cristina Castellano
Claudia Cristina Castellano
Milena PavlíkováMilena Pavlíková
Milena Pavlíková
Zbysek PavlikZbysek Pavlik
Zbysek Pavlik
Two waste fired brick powders coming from brick factories located in Argentine and Czech Republic were examined as alternative mineral admixtures for the production of blended cements. In pastes composition, local Portland cements (Argentine and Czech) were substituted with 8–40%, by mass, with powdered ceramic waste. For the ceramic waste-Portland cement system, workability, the heat released, pozzolanity, specific density, compressive strength, hydrated phases, porosity, and pore size distribution were tested. The relevance of the dilution effect, filler effect, and pozzolanic activity was analyzed to describe the general behavior of the pozzolan/cement system. The properties and performance of cement blends made with finely ground brick powder depended on the composition of ceramic waste and its reactivity, the plain cement used, and the replacement level. Results showed that the initial mini-slump was not affected by a low ceramic waste replacement (8% and 16%), and then it was decreased with an increase in the ceramic waste content. Brick powder behaved as a filler at early ages, but when the hydration proceeded, its pozzolanic activity consumed partially the calcium hydroxide and promoted the formation of hydrated calcium aluminates depending on the age and present carbonates. Finally, blended cements with fired brick powder had low compressive strength at early ages but comparable strength-class at later age.

8 February 2023 in Minerals
Verified
Journal Article
Open access
PDF file
EIEdgardo Fabian Irassar
Edgardo Fabian Irassar
VBViviana L. Bonavetti
Viviana L. Bonavetti
GCGisela Paola Cordoba
Gisela Paola Cordoba
VRViviana F. Rahhal
Viviana F. Rahhal
CCClaudia Cristina Castellano
Claudia Cristina Castellano
HDHoracio A. Donza
Horacio A. Donza
The performance of five composite Portland cements (CPCs) with limestone filler (LF = 10%–25% by mass) and calcined illite clay (CIC = 10%–25% by mass) elaborated by intergrinding was analyzed in paste, mortar, and concrete. Hydration was studied by isothermal calorimetry, bound water, and XRD. Flow and compressive strength (2 to 90 days) were determined in standard mortar. Concretes (w/b = 0.45; binder content = 350 kg/m3; slump = 15 ± 3 cm) were elaborated to determine compressive and flexural strength, water penetration, and chloride migration. Intergrinding CPCs have a large specific surface area when LF + CIC increases, with a similar size range of clinker particles. Supplementary cementing material replacements decreased the heat rate, prolonged the dormant period, and decreased the acceleration rate at early ages. According to the Fratini test, all CPCs had positive pozzolanicity after 28 days, but XRD analysis showed Ca(OH)2 associated with monocarboaluminate phases. Mortar flow was slightly reduced when the proportion of CIC was increased. Mortar strength decreased when the sum of LF + CIC increased. CPC strength class was limited by compressive strength after 28 days. Concretes were workable, and the compressive strength after 28 days depended on the LF + CIC, and CIC contributed after 90 days. After 28 days, the water penetration depended mainly on the LF + CIC content. The chloride migration coefficient was also reduced when CPC contained more CIC and less LF.

10 April 2026 in Discover Civil Engineering
Verified
Journal Article
Open access
SZSilvina V Zito
Silvina V Zito
LSLaura Silvestro
Laura Silvestro
RLRoxana Lemma
Roxana Lemma
CCCristina Castellano
Cristina Castellano
PGPhilippe Gleize
Philippe Gleize
VRViviana F. Rahhal
Viviana F. Rahhal

1 January 2010 in Matéria (Rio de Janeiro)
Verified
Journal Article
Closed access
PDF file
CCC. C. Castellano
C. C. Castellano
VBV. L. Bonavetti
V. L. Bonavetti
EIEdgardo Fabian Irassar
Edgardo Fabian Irassar
Actualmente son muy conocidos los beneficios tecnológicos, económicos y el menor impacto medioambiental que produce el empleo de adiciones minerales como reemplazo del cemento portland. Estas razones, han consolidado el uso de muchas adiciones como: escoria granulada de alto horno, ceniza volante, material calcáreo, humo de sílice, etc. En los últimos años, los cementos presentan un importante aumento en el contenido de las adiciones; el cual influye sobre la distribución de partículas, sobre la velocidad y naturaleza de las reacciones de hidratación y en consecuencia en su ganancia de resistencia. El presente trabajo evalúa la influencia de la temperatura en el curado (20, 40 y 60 ºC) de pastas con contenido variable de escoria granulada de alto horno (0 a 80 %) elaboradas con relación agua/material cementante de 0,40, sobre la resistencia mecánica. La evolución de la hidratación se estudió a través del análisis de los compuestos de hidratación por DRX y el contenido de agua no evaporable. La resistencia mecánica se evaluó empleando un diseño de experimentos central compuesto centrado. Los resultados obtenidos indican que a medida que la temperatura de curado aumenta con el incremento del contenido de escoria en el cemento mezcla, se aumentan la resistencia y el contenido de agua no evaporable, y disminuye la cantidad de hidróxido de calcio de la pasta.

1 April 2012 in Revista de la construcción
Verified
Journal Article
Open access
PDF file
CCC Castellano
C Castellano
VBV Bonavetti
V Bonavetti
EIE Irassar
E Irassar