7 February 2020 in Nature Communications
In tectonically active mountain belts, landslides contribute significantly to erosion. Statistical analysis of regional inventories of earthquake-triggered-landslides after large earthquakes (Mw > 5.5) reveal a complex interaction between seismic shaking, landslide material, and rainfall. However, the contributions of each component have never been quantified due to a lack of in-situ data for active landslides. We exploited a 3-year geodetic and seismic dataset for a slow-moving landslide in Peru affected by local earthquakes and seasonal rainfalls. Here we show that in combination, they cause greater landslide motion than either force alone. We also show the rigidity of the landslide’s bulk clearly decreasing during Ml ≥ 5 earthquakes. The recovery is affected by rainfall and small earthquakes (Ml < 3.6), which prevent the soil from healing, highlighting the importance of the timing between forcings. These new quantitative insights into the mechanics of landslides open new perspectives for the study of the mass balance of earthquakes.
16 November 2018 in Earth Surface Dynamics
The objective of this work is to propose a standard classification of seismic signals generated by gravitational processes and detected at close distances (1 Hz) where most of the seismic energy is recorded at the 1 km sensor to source distances. Several signal properties (duration, spectral content and spectrogram shape) are used to describe the sources. We observe that similar gravitational processes generate similar signals at different slopes. Three main classes can be differentiated mainly from the length of the signals, the number of peaks and the duration of the autocorrelation. The classes are the “slopequake” class, which corresponds to sources potentially occurring within the landslide body; the “rockfall” class, which corresponds to signals generated by rock block impacts; and the “granular flow” class, which corresponds to signals generated by wet or dry debris/rock flows. Subclasses are further proposed to differentiate specific signal properties (frequency content, resonance, precursory signal). The signal properties of each class and subclass are described and several signals of the same class recorded at different slopes are presented. Their potential origins are discussed. The typology aims to serve as a standard for further comparisons of the endogenous microseismicity recorded on landslides.
21 February 2017 in Structural Health Monitoring
Locadiff, an innovative imaging technique based on diffuse waves, has recently been developed in order to image mechanical changes in heterogeneous, geological, or man-made materials. This manuscript reports the on-site application of Locadiff to locate several pre-existing cracks on an aeronautical wind tunnel made of pre-stressed concrete. Using 32 transducers working at ultrasonic frequencies (80–220 kHz) where multiple scattering occurs, we monitor during 15 min an area of 2.5 m×2.5 m of a 35-cm-thick wall. With the wind tunnel in its routine operation, structural changes around the cracks are detected, thanks to their closing or opening due to slight pressure changes. By mapping the density of such microstructure changes in the bulk of the material, locating three pre-existing cracks is properly performed in three dimensions.
27 December 2017 in IEEE Journal of Radio Frequency Identification
This paper investigates meteorological factors that affect the phase of radio-frequency identification (RFID) passive tags at 868 MHz, in outdoor conditions. The study identifies the effect of water on the tag and base antennas, the effect of temperature on the cables, tags, and base antenna, the effect of the tag support moisture, and the effect of atmospheric conditions on wave velocity. Combined, these effects could lead to over 8.1 radians phase drift over a year, in a typical environment. In a tag location tracking application, that would correspond to an error of 22 cm. This paper proposes techniques to correct these effects and to increase the phase stability. These techniques are applied to a new RFID system, which is tested in outdoor conditions, for five months. The new system improves the phase stability for rainy days, dry days, and long-term drift by a factor of 3, 12, and 5, respectively. After corrections, the long-term drift was reduced to below 0.05 radians per month, which corresponds to 1.5 millimeter per month.
2 February 2021 in The Cryosphere
Among mountainous permafrost landforms, rock glaciers are mostly abundant in periglacial areas, as tongue-shaped heterogeneous bodies. Passive seismic monitoring systems have the potential to provide continuous recordings sensitive to hydro-mechanical parameters of the subsurface. Two active rock glaciers located in the Alps (Gugla, Switzerland, and Laurichard, France) have been instrumented with seismic networks. Here, we analyze the spectral content of ambient noise to study the modal sensitivity of rock glaciers, which is directly linked to the system's elastic properties. For both sites, we succeed in tracking and monitoring resonance frequencies of specific vibrating modes of the rock glaciers over several years. These frequencies show a seasonal pattern characterized by higher frequencies at the end of winters and lower frequencies in warm periods. We interpret these variations as the effect of the seasonal freeze–thawing cycle on elastic properties of the medium. To assess this assumption, we model both rock glaciers in summer, using seismic velocities constrained by active seismic acquisitions, while bedrock depth is constrained by ground-penetrating radar surveys. The variations in elastic properties occurring in winter due to freezing were taken into account thanks to a three-phase Biot–Gassmann poroelastic model, where the rock glacier is considered a mixture of a solid porous matrix and pores filled by water or ice. Assuming rock glaciers to be vibrating structures, we numerically compute the modal response of such mechanical models by a finite-element method. The resulting modeled resonance frequencies fit well the measured ones over seasons, reinforcing the validity of our poroelastic approach. This seismic monitoring allows then a better understanding of the location, intensity and timing of freeze–thawing cycles affecting rock glaciers.