A more realistic approach to evaluate the impact of polycrystalline metal gates on the MOSFET variability is presented. 2D experimental workfunction maps of a polycrystalline TiN layer were obtained by Kelvin Probe Force Microscopy with a nanometer resolution. These data were the input of a device simulator, which allowed us to evaluate the effect of the workfunction fluctuations on MOSFET performance variability. We have demonstrated that in the modelling of TiN workfunction variability not only the different workfunctions of the grains but also the grain boundaries should be included.
A microscopic study of electronic transport in suspended monolayer graphene is presented. The results have been obtained by means of an ensemble Monte Carlo simulator that takes into account the main physical properties of the graphene bandstructure and the most relevant scattering mechanisms for this type of material. The carrier velocity value is mainly set by the dominant influence of optical and acoustic intervalley phonons, particularly at high electric fields, where a negative differential conductance is observed. The average time between scatterings shows an asymptotic behavior with the applied electric field, with values in the order of tenths of ps. The influence of the electric field on the wavevector distribution is also analyzed, showing a saturation trend in the displacement of the charge centroid with a linear increase in the average energy. Finally, the instantaneous velocity and the correlation function of velocity fluctuations are also studied.
14 October 2014 in IEEE Transactions on Electron Devices
This paper presents a detailed Monte Carlo study of the optimization of the dopant segregation (DS) layer in n-type Schottky barrier (SB)-MOSFET. It is shown that with a careful control of the DS layer parameters, dopant concentration (N dop ), and length (L dop ), the performance of the devices is significantly enhanced. The presence of the DS layer induces crucial effects in the injection processes at the Schottky contacts. The benefits of increasing the length and the doping level of the DS layer are studied from the microscopic point of view (transit times, average number of scatterings). The effect of varying these parameters is also analyzed through the nonquasi-static parameters of the small signal equivalent circuit, which can be useful for designers to improve the reliability of the SB-MOSFET technology.
The stacks of III-V materials, grown on the Si substrate, that are considered for the fabrication of highly scaled devices tend to develop structural defects, in particular threading dislocations (TDs), which affect device electrical properties. We demonstrate that the characteristics of the TD sites can be analyzed by using the conductive atomic force microscopy technique with nanoscale spatial resolution within a wide temperature range. In the studied InGaAs/Si stacks, electrical conductance through the TD sites was found to be governed by the Poole-Frenkel emission, while the off-TDs conductivity is dominated by the thermionic emission process.
9 November 2017 in IEEE Journal of the Electron Devices Society
Power consumption and I on /I off ratio of an ultra-thin body and buried oxide fully depleted silicon on insulator CMOS inverter circuit has been calculated at near-threshold voltage operation from TCAD simulations. TCAD outputs (current, voltage, and capacitance) were used as parameters to solve the inverter circuit. Besides, a bias operation point (V OP ) has been proposed, which provides a good trade-off between the I on /I off ratio and the energy consumption. Variations of this operation point, due to the presence of interface traps, have been also analyzed.
A methodology to determine with nanometer resolution the defect density in polycrystalline HfO2 layers has been developed. This methodology is based on experimental data measured with conductive atomic force microscopy and the obtained results have been validated using Kelvin prove force microscopy measurements. The local defect density ( ρox ) and thickness (t ox ) of the gate dielectric have been included into a device simulator to evaluate their impact on the I D V G curves of MOSFETs.