26 February 2023 in Thin Solid Films
3 July 2023 in Applied Physics Letters
The outstanding electronic properties of graphene make this material a candidate for many applications, for instance, ultra-fast transistors. However, self-heating and especially the detrimental influence of available supporting substrates have impeded progress in this field. In this study, we fabricate graphene-diamond heterostructures by transferring graphene to an ultra-pure single-crystalline diamond substrate. Hall-effect measurements were conducted at 80 to 300 K on graphene Hall bars to investigate the charge transport properties in these devices. Enhanced hole mobility of 2750 cm2 V−1 s−1 could be observed at room-temperature when using diamond with reduced nitrogen (Ns0) impurity concentration. In addition, by electrostatically varying the carrier concentration, an upper limit for mobility is determined in the devices. The results are promising for enabling carbon–carbon (C-C) devices for room-temperature applications.
27 December 2024 in Physica Status Solidi (a)
Graphene on diamond has emerged as a promising platform for various electronic applications. This brief review article explores the recent advancements and the potential of graphene on diamond for electronic applications with a focus on single‐crystal (SC) chemically vapor‐deposited and high‐pressure and high‐temperature diamond. Device fabrication techniques, properties, and performance of single‐layer graphene on diamond in various electronic devices are discussed. This hybrid system's challenges and prospects are also analyzed. A particular emphasis is placed on the unique benefits of diamond as a substrate for graphene and its growth, including its high thermal conductivity, mechanical strength, high optical phonon energy, and the importance of achieving high‐quality single‐layer graphene on SC diamond.
19 March 2025 in IEEE Access
As the world transitions toward renewable electrification to reduce CO2 emissions, remote island electrification remains a challenge. While some islands are grid-connected, many still rely on fossil fuels for electricity generation. Several studies indicate that renewable energy sources, such as wave energy, have the potential to make these islands self-reliant due to their substantial power potential. However, research on the control of power electronics converters for these systems remains limited. This paper proposes isolated grid-forming control for island electrification to address this gap using a wave energy converter and an energy storage system. Resistive loading control is implemented to optimize the power absorption from the generator. The result illustrates the establishment of the required AC voltage and 50 Hz frequency in the island load, ensuring harmonics compliance with the recommended standards. Experiments were conducted to test and validate the operation of different converter controls. The results also demonstrate the converter’s ability to black-start the island load and automatically transition the load current with varying loads in a few milliseconds. Furthermore, the power quality produced by the wave energy converter presents one of its significant challenges. Therefore, the performances of two distinct converter technologies were compared. The performance of the IGBT converter was evaluated against that of the SiC-based converter in terms of power quality. The study demonstrates that the use of SiC enhances power quality across all the tested switching frequencies, achieving the greatest reduction of 78% in current THD and 92% in voltage THD at 25 kHz switching frequency, thereby validating its advantages for wave energy converter applications.
2 December 2025 in Carbon Trends
15 April 2025 in Journal of Applied Physics
Understanding the electrically active defects and impurities in semiconductors, especially in intrinsic or unintentionally doped wide bandgap materials, still remains a challenge. Here, time-of-flight (ToF) measurement using a solid state light source (355 and 213 nm) was performed on intrinsic silicon carbide and single-crystalline diamond. The charge transient spectroscopy (QTS) and the inverse Laplace (IL) QTS methods were applied to analyze the ToF results. Using these methods, we were able to trace the existing impurities in both materials. However, ILQTS proved to be more sensitive, with higher resolution for detection of existing multiple defects. The results suggest that this system can successfully be employed to investigate electrically active impurities at different energy states in highly resistive and undoped materials.