8 June 2021 in IEEE Transactions on Electron Devices
ScAlN/GaN dielectric superjunction high-electron-mobility transistors (HEMTs) with high- ${k}$ passivation layer Bi 1.5 Zn 1.0 Nb 1.5 O 7 (BZN) are demonstrated for enhancement of breakdown voltage. The BZN thin film deposited by RF magnetron sputtering has a dielectric constant of 192 after postdeposition annealing at 400 °C for 10 min. The HEMT with ${L}_{g} =200$ nm and ${L}_{\text {sd}} = 2.0\,\,\mu \text{m}$ has a maximum current density of 1.98 A/mm, a maximum transconductance of 0.52 S/mm, and a threshold voltage of ${V}_{\text {th}} = -3$ V. With the use of SiN/BZN/SiN sandwiched passivation layer, the average value of breakdown voltage is improved from 68.9 to 121.5 V, due to the reduction of the peak electrical field between the gate and the drain. The device has a cutoff frequency ( ${f}_{T}{)}$ and maximum oscillation frequency ( ${f}_{\text {max}}{)}$ of 59 and 69 GHz, respectively. Overall, the devices exhibit a significantly higher breakdown voltage with essentially the same ${f}_{T}$ and ${f}_{\text {max}}$ values. Pulse measurements suggest that SiN/BZN/SiN has a similar passivation effect in comparison with devices passivated by a SiN-only layer. This work demonstrates that high current and high breakdown voltage can be achieved simultaneously on semiconductor heterostructures with a high sheet charge density by integration of high- ${k}$ dielectrics.
2 October 2023 in Applied Physics Letters
VVVijay Gopal Thirupakuzi Vangipuram
Vijay Gopal Thirupakuzi Vangipuram
+4
Devices based on gallium nitride (GaN) have great potential for high power switching applications due to the high breakdown field and high electron mobility. In this work, we present a vertical GaN-on-GaN PN power diode using high dielectric constant material, BaTiO3, for electrical field management and high breakdown voltages, in together with an optimized guard-ring and field plate design. Numerical simulation shows that with high-k dielectrics implemented, the peak electrical field at the PN interface is mitigated from 3.5 to 3.1 MV/cm under a reverse bias of −9.05 kV. The device design with BaTiO3 shows a breakdown voltage of 9.65 kV or about 600 V improvement. The fabricated diodes with a 57 μm thick drift layer demonstrate a breakdown voltage of 7.86 kV on a bulk GaN substrate. The device has an on-resistance of 2.8 mΩ cm2 and a Baliga figure of merit of 22 GW/cm2.
1 April 2020 in IEEE Electron Device Letters
High-current molecular beam epitaxial perovskite oxide semiconductor BaTiO3/BaSnO3 heterostructure field effect transistors on SrTiO3 substrates were developed. Record high current density of Imax = 406.7 mA/mm, maximum transconductance gm = 72.3 mS/mm were achieved in a field effect transistor with gate length Lg = 0.64 μm, and source-drain spacing Lsd = 3.5 μm. The device has a low threshold voltage of Vth = -4.5 V and the capability to modulate 5.7×1013 cm-2 electron density in the BaSnO3 channel. The high channel current and gate modulation efficiency are attributed to the high mobility and charge density in the BaSnO3 channel and the utilization of high-k BaTiO3 (ε is in the range of 425 and 387 as the electric field increases from 46 to 85 kV/cm ) layer as the gate dielectric for charge modulation. Though the device suffers from low current on/off ratio and a large subthreshold swing due to the gate leakage resulted from threading dislocations, this work demonstrates the great potential of perovskite semiconductors for electronic device applications.
16 February 2022 in Journal of Physics D: Applied Physics
Understanding the carrier transport mechanisms is critical for electronic devices based on 2D semiconductors. Here, using a two-terminal device configuration, we show that the carrier transport behaviours in chemical vapour deposited few-layer MoS2 transition from resonant tunnelling to hopping, and eventually to band transport as the temperature increases from 5 K to 370 K. Specifically, the transport in the channel is dominated by resonant tunnelling when T < 30 K is reflected in the temperature-independent conductance. At 50 K < T < 110 K, the channel conductance exhibits a dependence of exp(T 1/2), a signature of Efros–Shklovskii type variable range hopping (VRH). At 110 K < T < 160 K, carrier transport behaves in a transition region with potential attribution to Mott-type VRH. At 160 K < T < 210 K, the nearest neighbour hopping mechanism is confirmed by the linear dependence from the resistance curve derivative analysis. For VRH, the localization length, hopping distance and energy, Coulomb gap energy and density of states are extracted. At T > 210 K, the carrier transport is dominated by thermally activated band transport based on AC conductance and mobility analysis. These findings are significant for revealing the material properties for future 2D semiconductor device applications.
28 July 2025 in IEEE Electron Device Letters
MRMohammad Wahidur Rahman
AlN/GaN high electron mobility transistors (HEMTs) with BaTiO3 and in-situ SiN passivation layers under the gate are reported for suppressed current dispersion, enhanced breakdown voltage, and output power density. The BTO AlN/GaN HEMT with gate length Lg = 113 nm, exhibited a maximum current density of 2.21 A/mm, a maximum transconductance of 0.27 S/mm. The gate to drain breakdown voltage of BTO AlN/GaN HEMTs is improved from 35 V to 82 V in comparison with HEMTs with SiN passivation only. Pulsed IV measurements show that the BaTiO3 passivation layer significantly reduces the current dispersion. Large signal load-pull measurements at 10 GHz demonstrated a maximum output power density of 14.1 W/mm, with a peak power added efficiency (PAE) of 62.4 %.