Subin Kim

Subin Kim

Auto-generated profile, based on publicly available information

Subin Kim

PHYCHIPS Inc., Daejeon 34025, South Korea

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 August 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
KKKeun-Mok Kim
Keun-Mok Kim
SKSubin Kim
Subin Kim
KCKyung-Sik Choi
Kyung-Sik Choi
HJHyunki Jung
Hyunki Jung
JKJinho Ko
Jinho Ko
SLSang-Gug Lee
Sang-Gug Lee
An extremely low-power 32-kHz crystal oscillator (XO) based on a sub-harmonic pulse injection technique is presented. By injecting current pulses into the crystal at the sub-harmonic of the oscillation frequency, the power consumption of the proposed XO reduces with an increase in the order of sub-harmonic (N). For the generation of sub-harmonic pulses with accurate timing, a 50%-duty-cycle-locked loop and a sub-harmonic peak-detection delay-locked loop are employed. A clock divider is also utilized to generate the sub-harmonic clock, which is required for the real-time clock as well. Implemented in a 55-nm CMOS technology with a triple well, the proposed XO, including a clock divider, dissipates 0.74 nW from a single 0.3-V supply for N = 16 and the chip occupies only 0.019 mm².

7 April 2021 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
KKKeun-Mok Kim
Keun-Mok Kim
HSHyun-Gi Seok
Hyun-Gi Seok
OJOh-Yong Jung
Oh-Yong Jung
KCKyung-Sik Choi
Kyung-Sik Choi
BYByeonghun Yun
Byeonghun Yun
SLSang-Gug Lee
Sang-Gug Lee
A 900-MHz high-sensitivity split-channel binary frequency-shift keying (SC-BFSK) reconfigurable data/wake-up receiver (RX) for low-power wide-area networks (LPWANs) is presented. In the data mode, the proposed RX demodulates data through the RF/analog front end (RXFE), the analog-to-digital converter (ADC), and the modulator-demodulator (MODEM). The MODEM implemented in the external microcontroller unit (MCU) applies additional digital signal processing to improve about 17-dB sensitivity. In the wake-up mode, the proposed RX saves the power dissipation by turning off all blocks except for the RXFE and wake-up preamble detector (WuPD). The WuPD following the RXFE provides a 17-dB sensitivity improvement in place of the MODEM of the data RX. Adopting the proposed SC-BFSK, in which other channels are inter-allocated between the BFSK tones of one channel, increases the number of channels while taking advantage of wide tone spacing, which improves the bit error rate (BER) in a multipath fading channel. To implement the ultra-low-power (ULP) SC-BFSK RX, the RXFE employs the 2:1 LO sliding-IF architecture and a band-pass filter (BPF)-based frequency-to-energy detection baseband demodulator. Implemented in 55-nm CMOS, the proposed RX, including both data and wake-up RXs, exhibits -123-dBm sensitivity with 0.39-kbps data rate and 81.92-ms wake-up latency, while the RX chip dissipates 0.88 mW.

17 March 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
SKSubin Kim
Subin Kim
KCKyung-Sik Choi
Kyung-Sik Choi
KKKeun-Mok Kim
Keun-Mok Kim
JKJinho Ko
Jinho Ko
Jusung KimJusung Kim
Jusung Kim
SLSang-Gug Lee
Sang-Gug Lee
UHF RFID reader suffers from a strong transmitter (Tx) leakage signal coupled to a receiver (Rx), especially for an area-compact single-antenna implementation. Then, several Tx leakage cancellation schemes have been developed not to saturate the Rx and to minimize the performance degradation. This brief proposes a UHF RFID reader Rx with a low noise performance and a fast settling time by employing a digitally controlled leakage cancellation method in both passive and active realizations. A digitally-controlled passive vector reflector enhances the Tx to Rx isolation ratio by providing the optimum load impedance. An active anti-leakage feedback loop adaptively tracks the time-varying leakage and generate the phase-inverted leakage replica to suppress the leakage. The prototype chip is fabricated in a CMOS 55 nm process and the area of the chip is 2.1 mm × 1.8 mm. The passive leakage cancellation (PLC) with a vector reflector endures the 1 dBm leakage with a low Rx noise figure of 12.5 dB and 35.7 mW power consumption. The active leakage cancellation (ALC) with an anti-leakage feedback loop covers 6 dBm leakage with a fast settling time of 4.6μs and 58 mW power consumption.

5 April 2021 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
KCKyung-Sik Choi
Kyung-Sik Choi
SKSubin Kim
Subin Kim
JKJinho Ko
Jinho Ko
SLSang-Gug Lee
Sang-Gug Lee
A low-noise active leakage canceller (ALC) for radio frequency identification (RFID) transceiver is reported. The proposed ALC suppresses the strong transmitter (TX) leakage at the receiver (RX) input through continuous leakage tracking by employing an I/Q harmonic rejection switched-capacitor digital power amplifier (I/Q HR SC DPA). Compared to the analog feedback loop-based ALC, the proposed ALC minimizes the noise figure (NF) degradation in the RX and eliminates the large-size passive components in the analog low pass filter, which leads to high RX sensitivity and small chip area. Implemented in a 55-nm CMOS, the proposed ALC suppresses -10 dBm TX leakage down to -47.2 dBm while degrading the RX NF by 0.4 dB at the offset frequency of 640 kHz.