1 August 2016 in AIP Advances
We report on the growth of an In0.30Ga0.70As channel high-electron mobility transistor (HEMT) on a 200 mm silicon wafer by metal organic vapor phase epitaxy. By using a 3 μm thick buffer comprising a Ge layer, a GaAs layer and an InAlAs compositionally graded strain relaxing buffer, we achieve threading dislocation density of (1.0 ± 0.3) × 107 cm−2 with a surface roughness of 10 nm RMS. No phase separation was observed during the InAlAs compositionally graded buffer layer growth. 1.4 μm long channel length transistors are fabricated from the wafer with IDS of 70 μA/μm and gm of above 60 μS/μm, demonstrating the high quality of the grown materials.
21 November 2017 in Journal of Applied Physics
Heterojunction bipolar transistors (HBTs) with GaAs0.825P0.175 bases and collectors and In0.40Ga0.60P emitters were integrated monolithically onto Si substrates. The HBT structures were grown epitaxially on Si via metalorganic chemical vapor deposition, using SiGe compositionally graded buffers to accommodate the lattice mismatch while maintaining threading dislocation density at an acceptable level (∼3 × 106 cm−2). GaAs0.825P0.175 is used as an active material instead of GaAs because of its higher bandgap (increased breakdown voltage) and closer lattice constant to Si. Misfit dislocation density in the active device layers, measured by electron-beam-induced current, was reduced by making iterative changes to the epitaxial structure. This optimized process culminated in a GaAs0.825P0.175/In0.40Ga0.60P HBT grown on Si with a DC current gain of 156. By considering the various GaAsP/InGaP HBTs grown on Si substrates alongside several control devices grown on GaAs substrates, a wide range of threading dislocation densities and misfit dislocation densities in the active layers could be correlated with HBT current gain. The effect of threading dislocations on current gain was moderated by the reduction in minority carrier lifetime in the base region, in agreement with existing models for GaAs light-emitting diodes and photovoltaic cells. Current gain was shown to be extremely sensitive to misfit dislocations in the active layers of the HBT—much more sensitive than to threading dislocations. We develop a model for this relationship where increased base current is mediated by Fermi level pinning near misfit dislocations.
6 April 2017 in IEEE Transactions on Electron Devices
This paper demonstrates InGaAs vertical nanowire (VNW) MOSFETs fabricated via an improved top-down approach, the performance of which is comparable to that of the best bottom-up devices in terms of the balance between transport and electrostatics. These devices, when contrasted with an earlier generation fabricated by a similar technology, have enabled the first experimental study of source/drain asymmetry in InGaAs VNWMOSFETs. The transconductance differs significantly when swapping source and drain due to inherently different top and bottom contact electrical resistance. This also results in distinct asymmetry in the saturation behavior of the output characteristics. On the other hand, diameter nonuniformity along the nanowire (NW) length is responsible for asymmetry in the subthreshold characteristics. A uniform NW cross section, enabled by our improved InGaAs dry etch technology in the present devices, eliminates the asymmetry of the electrostatics, which was observed in our previous work.
1 November 2017 in Journal of Applied Physics
Co-doping with fluorine is a potentially promising method for defect passivation to increase the donor electrical activation in highly doped n-type germanium. However, regular high dose donor-fluorine co-implants, followed by conventional thermal treatment of the germanium, typically result in a dramatic loss of the fluorine, as a result of the extremely large diffusivity at elevated temperatures, partly mediated by the solid phase epitaxial regrowth. To circumvent this problem, we propose and experimentally demonstrate two non-amorphizing co-implantation methods; one involving consecutive, low dose fluorine implants, intertwined with rapid thermal annealing and the second, involving heating of the target wafer during implantation. Our study confirms that the fluorine solubility in germanium is defect-mediated and we reveal the extent to which both of these strategies can be effective in retaining large fractions of both the implanted fluorine and, critically, phosphorus donors.