27 July 2022 in IEEE Transactions on Power Electronics
In this article, a high efficiency and high power density Regulated dc Transformer (RDCX) is proposed for on-board charger (OBC). In this circuit, high input and output voltages are undertaken by series connected low-voltage devices. Owing to the low new figure of merit (NFoM, R dson × C oss )(Il-Jung et al., 1995), (Wu and Shi, 2020) characteristic of low-voltage devices, the conduction loss of switches can be reduced. Mathematical modeling and verification are also carried out. In addition, by applying cascaded buck as the regulation part of RDCX, the volt-second of buck inductor can be reduced compared with the traditional two-level buck circuit. As a result, the size of the inductor can be reduced. Furthermore, since all dc buses of the cascaded buck converter are from the rectifiers whose windings are coupled to the same transformer, those bus voltages can be naturally balanced. A 2.3 kW prototype based on 60V device with 388–412 V input and 250–450 V output voltage range is built up to verify the analysis, achieving 98% peak efficiency and 910 W/in 3 power density.
23 October 2023 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Magnetic integration effectively reduces the total magnetic volume for a converter with multiple magnetic components. However, the existing integrated inductor and transformer still face some problems, such as a large core cross-sectional area due to the small effective inductor winding number or low PCB utilization due to unreasonable winding structure design. A new inductor and transformer integrated magnetic structure with high PCB utilization and a small core volume for the resonant converter is proposed in this paper. The integrated resonant inductor is constructed by both the primary and secondary side windings, which increases not only the effective inductor turn number but also the utilization of the PCB. What’s more, the core plates of the inductor and the transformer are integrated to furtherly increase the utilization of the core. The design methodology for the proposed integrated magnetics (IM) is also given in this paper. Finally, the proposed integrated magnetics and design methodology are verified on a 2kW CLLC prototype. Compared with the discrete magnetic components, the integrated magnetics volume is reduced by about 25% with a similar loss.
22 July 2025 in IEEE Transactions on Power Electronics
Three-port transformer attracts widely attention in the fields of electric vehicle and energy storage due to its potential for integration. Low-profile planar transformer is also able to achieve high power density as it helps switching frequency increases to MHz. Thus, three-port megahertz (MHz) transformer with PCB windings was adopted in the Regulated DC Transformer (RDCX) converter for high density on-board chargers (OBC). However, the transformer in RDCX suffers from decreased efficiency when the power distribution becomes imbalanced between different output ports. With the power distribution varies between two secondary windings in the three-port transformer, the winding loss increases during imbalanced power transfer, which is caused by the increase of the PCB winding magnetomotive force (MMF). Hence, a PCB arrangement method of minimizing MMF to reduce three-port high-frequency transformer winding loss is proposed and verified by experiment. The winding loss is reduced within the whole output voltage range, with a maximum reduction of 23%.