Tianji Liu

Tianji Liu

Auto-generated profile, based on publicly available information

Tianji Liu

College of Electrical Engineering, Zhejiang University, Hangzhou, China

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 November 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
TLTianji Liu
Tianji Liu
XWXinke Wu
Xinke Wu
SYShu Yang
Shu Yang
In this paper, a 1-MHz-regulated DCX (RDCX) with single transformer is proposed for high-power-density highefficiency 48V-12V dc-dc conversion. In the proposed converter, a dc transformer (DCX) works at fixed switching frequency to realize isolation and output power conversion; and an auxiliary PWM converter is applied to realize voltage regulation. The auxiliary dc-dc is fed from the auxiliary winding of the transformer; and its output is in series with the input dc source. The output regulation is achieved by regulating the output voltage of auxiliary dc-dc converter. Furthermore, only a small portion of power is dealt by the auxiliary PWM dc-dc converter. Thus, the total efficiency is a little bit lower than the DCX and higher than that of conventional two-stage solution. The operation principle and the design guidelines of the proposed RDCX are presented in this paper. A 360W 40V-60V/12V dc-dc prototype is built to verify the theoretical analysis and design guidelines. In the prototype, 9.1% of load power is dealt by the auxiliary dc-dc at nominal 55V input voltage; and, at worst case, which happens rarely and the duration is short, 50% of load power is dealt by the auxiliary dc-dc stage. Finally, 97.3% peak efficiency is achieved.

27 July 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
GFGao Fan
Gao Fan
XWXinke Wu
Xinke Wu
TLTianji Liu
Tianji Liu
YXYuhao Xu
Yuhao Xu
In this article, a high efficiency and high power density Regulated dc Transformer (RDCX) is proposed for on-board charger (OBC). In this circuit, high input and output voltages are undertaken by series connected low-voltage devices. Owing to the low new figure of merit (NFoM, R dson × C oss )(Il-Jung et al., 1995), (Wu and Shi, 2020) characteristic of low-voltage devices, the conduction loss of switches can be reduced. Mathematical modeling and verification are also carried out. In addition, by applying cascaded buck as the regulation part of RDCX, the volt-second of buck inductor can be reduced compared with the traditional two-level buck circuit. As a result, the size of the inductor can be reduced. Furthermore, since all dc buses of the cascaded buck converter are from the rectifiers whose windings are coupled to the same transformer, those bus voltages can be naturally balanced. A 2.3 kW prototype based on 60V device with 388–412 V input and 250–450 V output voltage range is built up to verify the analysis, achieving 98% peak efficiency and 910 W/in 3 power density.

18 July 2023 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
FMFaheem Muhammad
Faheem Muhammad
XWXinke Wu
Xinke Wu
Jinxu YangJinxu Yang
Jinxu Yang
LTLin Tian
Lin Tian
TLTianji Liu
Tianji Liu
A resonant four-switch inverting buck-boost converter is a good choice for DC/DC applications that require an inverting voltage solution. A soft switching control scheme with four segments of resonance current has been examined using duty ratio and phase shift as control variables. As a result, the RMS value of the resonance current is low compared to DCM, which is directly proportional to the conduction loss. This control scheme allows the converter to regulate its output voltages more efficiently with soft switching operations. Thus, it contributes to an increment in efficiency improvement and board size reduction. At the same time, a simple close-loop is designed to meet the requirement of a wide voltage range with the corresponding simplified real-time PI control algorithm. For the verification of the proposed control scheme, a resonant four-switch inverting buck-boost DC/DC converter is designed and experimentally tested, which has recorded over 98.5% peak efficiency at a 1:1 inverting case (-48Vdc to 48Vdc). The converter's wide operating range is from -48Vdc to 28ni Vdc ∼ 60Vdc output voltage with a power density of 500W/in3.

10 November 2023
Verified
Conference Paper
Closed access
TLTianji Liu
Tianji Liu
WZWending Zhao
Wending Zhao
XWXinke Wu
Xinke Wu
Regulated DC transformer (RDCX) achieves high-efficiency, high-power-density power conversion due to fully soft switching, transformer optimization, and partial-power regulation. However, the load-independent losses, especially the core loss at high switching frequency, make it difficult for RDCX to meet the increasing light-load efficiency requirements. Burst mode operation is an effective way to reduce the load-independent losses of the resonant DC transformer (DCX) in RDCX. However, when applying the conventional burst mode strategies in DCX, soft switching will be lost during the burst-on time, or the implementation have high requirements on the hardware or software. In this paper, a simple burst-mode strategy is proposed. Pulse sequence with fixed pulse widths in DCX maintains soft switching and simplifies the DSP calculation. To improve the efficiency in burst-mode operation, average output current during the burst-on time is controlled, and extra losses in the burst mode operation is minimized. Cooperating with the auxiliary DC-DC, automatic adjustment of average output current during the burst-on time is realized. Finally, a 1-MHz 66V/48V 500W prototype based on silicon devices is established for verification. The efficiency at 10% load is improved from 92.6% to 95.3%, which means a 37% loss reduction.

10 November 2023
Verified
Conference Paper
Closed access
TLTianji Liu
Tianji Liu
THTianlin Huang
Tianlin Huang
XWXinke Wu
Xinke Wu
Compared to AC-DC converters based on high-voltage devices, it is easier for the multi-cell AC-DC converter to achieve high efficiency and power density, due to better switching properties of low-voltage devices. To maintain normal operation in multi-cell converters, dc-bus voltage balance and power balance among AC-DC cells should be achieved. Usually, complex voltage balance and power balance control with additional sensing circuits are required to achieve the balances. In some cases, although the balances can also be achieved by employing pulse-width modulation (PWM) DC-DC converters with common-duty-cycle control as the 2 nd stage, their low switching frequency for high efficiency will lead to decrease in power density. In this paper, regulated dc transformer (RDCX) with simple common-duty-cycle control is introduced for high-efficiency high-density power conversion and simple control. Since the RDCX operates at a fixed frequency neighboring the resonant frequency, fully soft switching and transformer optimization can be easily achieved for high efficiency and power density. Moreover, due to its voltage regulation principle, dc-bus voltage balance and power balance can be realized by employing the common-duty-cycle control. A 6-cell 3kW/220Vac-48Vdc AC-DC converter prototype with MHz RDCXs as the 2nd stage is established to verify the analysis.