In this work, we report the RF/DC performance of novel AlN/GaN/Graded-AlGaN/GaN double-channel HEMT (AlN-GDC-HEMT) on SiC wafer for the first time. The study compares the performance between conventional AlGaN/GaN/Graded-AlGaN/GaN double-channel HEMT (AlGaN-GDC-HEMT) and the AlN-GDC-HEMT. Two quantum wells are formed in both devices, leading to distinct double peak features in transconductance and cut-off frequency plots, highlighting efficient interchannel connection behavior. The study investigates the relative performance of AlN-GDC-HEMT and AlGaN-GDC-HEMT, exploring the influence of gate recess length (L R ) and top barrier thickness. Additionally, the scaling behavior of the HEMTs is examined with varying gate lengths (L G ). Furthermore, the impact of gate engineering and lateral scaling on both devices’ DC/RF behavior is explored. Extensive comparative analysis shows that the AlN-GDC-HEMT outperforms the conventional AlGaN-GDC-HEMT, mainly attributed to AlN’s higher polarization (spontaneous) density and its wider bandgap. The optimized AlN-GDC-HEMT with L G = 40 nm, L GS = 250 nm, and L GD = 400nm exhibits superior performance resulting in transconductance (G M ) values of 203.1 and 787.5 mS/mm at two peaks, an I DS_peak of 1.97 A/mm, I DS_sat of 3.18 A/mm, and the highest f T derived from the left and right peaks was 285.1 and 416.8 GHz, respectively. The promising results from this first investigation indicate the potential and applicability of AlN-GDC-HEMTs in future RF power amplifiers.
12 August 2025 in IEEE Transactions on Electron Devices
The silicon (Si) fin-field-effect-transistor (FinFET) technology revolutionized the semiconductor industry by enabling scaling down to the advanced 4-nm node. Even FinFET has limitations, though, as it is difficult to scale down to the sub-3-nm node due to the short channel effects (SCEs) and the higher fin aspect ratio brought on by fin depopulation. These challenges can be alleviated by a nanosheet FET (NSFET), a next-generation technology that can replace FinFET due to its vertically stacked horizontal channels and superior gate controllability. However, NSFETs still face key hurdles—most notably, the spacing between p-type and n-type FETs, which limits further scaling. Reducing the spacing between nFET and pFET necessitates a gate cut with a high aspect ratio, which can also introduce challenges, such as mask undercutting during work-function metal (WFM) patterning. A fork-shaped FET (FSFET) addresses these challenges by introducing a dielectric wall (DW) between the nFET and pFET, enabling a significant reduction in logic cell height. This article provides a comprehensive exploration of FSFET technology, beginning with the challenges in FET scaling and also covers the performance analysis of FSFETs, challenges and advances in fabrication, and exciting prospects in integrated circuit (IC) design and reliability issues.
22 June 2026 in ECS Journal of Solid State Science and Technology
This work presents the first comprehensive investigation of spacer engineering in a novel E-shaped Gate-All-Around Nanosheet FET at sub- 5nm node, where the novelty lies in introduction of the E-shaped channel to enhance electrostatic control and effective channel width. Analysis of both single-κ and dual-κ spacers is provided for digital, analog/RF, and circuit designs. The single-κ spacers exhibit substantial benefits from higher κ value ranging from 1 to 39 in achieving better ION/IOFF ratio and reduced subthreshold swing (~9%), along with enhanced gain (~42%), even though it leads to 3× higher gate capacitance and 2.1× more delay penalty in the CMOS inverter circuit. This drawback is addressed using the dual-κ spacers, where high-κ materials are used closer to the gate, while low-κ is near the source/drain junction. Therefore, the value of CGG is lowered by nearly 29%, in comparison with high-k single spacers, while keeping good electrostatic properties. The dual- κ spacer structures using TiO2 (D2, D4, D6) show a decrease of about 64% for IOFF, as well as better analog performance. Additionally, circuit-level CMOS inverter simulation results for the dual- κ configuration reveal a higher noise margin and gain with controllable delay in comparison with the single-κ spacer structures.
1 October 2026 in IEEE Transactions on Electron Devices