1 January 2021 in Materials Research
This work aims to evaluate the influence of laser power and reinforcement feeding rate on the microstructure, hardness, and wear behavior of NbC-reinforced Hastelloy C276TM alloy composite coatings. From a dual feeding system, one-step metal-matrix composite coatings were deposited with 10, 30, and 50% mass feeding of NbC powder with laser powers of 1.5 and 3.0 kW. Coatings deposited with 1.5 kW and 30% NbC showed some degree of porosity due to a combination of NbC feeding rate and melting pool temperature. Laser power and NbC feeding rate altered the melting efficiency and substrate burn-in shape, remarkably influencing the dilution. The composite microstructure was comprised of Ni-γ (FCC) dendrites with interdendritic network carbide which, in turn, ranged from lamellar-like M6C to blocky-like conjugated MC-M23C6 carbide. Primary petaloid-like MC [Nb] carbide was formed from a 30% reinforcement rate on, whilst a considerable number of unmelted particles was observed for 50%. The higher the reinforcement feeding rate, the higher the carbide fraction and better wear performance of low heat-input specimens. Synthesis with high heat-input sheds a light on the deleterious effect of the dilution and is not an option to enhance the wear performance.
31 December 2025 in Steel Research International
Duplex stainless steels (DSSs) have outstanding mechanical properties and corrosion resistance. However, operating conditions and/or inadequate heat treatments can induce precipitation of deleterious phases or change the proportion of ferrite (α) and austenite (γ) phases. This study evaluates the impact of ageing at 850 and 950 °C and solubilization at 1000 and 1150 °C treatments on pitting and crevice corrosion of DSS UNS S32205. Cyclic polarization tests revealed that samples with a more balanced α/γ ratio (≈50/50), that is, the base material (BM) and that solubilized at 1000 °C, exhibited the lowest corrosion rate (0.044–0.074 μm/year) and better repassivation capacity (E R ≈ 0.96 V). Conversely, the 1150 °C treatment led to reduced corrosion resistance (0.158 ± 0.009 μm/year) and is associated with a reduction in the %Cr in α. Pitting is present in the aged conditions only. Moreover, the BM and 1000 °C samples showed the lowest crevice corrosion susceptibility, presenting the lowest volume loss (1 × 10 6 μm 3 cm −2 ) and current densities (≈1000 μA cm −2 ), followed by samples treated at 1150, 950, and 850 °C. Therefore, the results show that ageing treatments make UNS S32205 susceptible to pitting and crevice corrosion, which is related to the deleterious phase fraction and the α/γ ratio imbalance.