UTP University of Science and Technology in Bydgoszcz, Faculty of Chemical Technology and Engineering, Department of Polymer Technology and Protective Coatings, Seminaryjna 3, 85-326 Bydgoszcz, Poland
Auto-generated profile, based on publicly available information
Kazimierz Piszczek
UTP University of Science and Technology in Bydgoszcz, Faculty of Chemical Technology and Engineering, Department of Polymer Technology and Protective Coatings, Seminaryjna 3, 85-326 Bydgoszcz, Poland
Researches were carried out to determine the possibility of reusing polyols produced in the chemical recycling process of polyurethane (PUR) foam technological waste and post-consumer mattresses for the production of mattresses and thermal insulation panels. It was found that such PUR waste can be converted into repolyol by similar processes that are currently used at Dendro Poland LTD Sp. z o.o. The mixture containing repolyols was used to produce rigid and flexible polyurethane-polyisocyanurate (PUR-PIR) foams. It was found that a mixture of polyols containing up to 50 wt % of repolyols can be used in the production of flexible PUR-PIR foams. The most suitable application for recycled polyol from post-consumer foam waste was identified as rigid PUR-PIR foam for thermal insulation. The produced rigid foams showed good performance in the foaming process, foam structure and dimensional stability. The practical application of chemical recycling of post-consumer mattresses is of great environmental importance and, additionally, the obtained repolyol is cheaper than the standard polyol.
26 April 2004 in Journal of Applied Polymer Science
This paper presents the method of using glass fibre with carbon deposit (GFCD), derived from the recycling of wind turbine blades, for production of composite materials based on poly(vinyl chloride) (PVC). Composite materials containing from 1 to 15 wt% of GFCD were produced by plasticising with a plastographometer and then by pressing. The processability and performance were studied. Mechanical properties in static tension, impact strength, and thermal stability were determined. Glass transition temperature was also determined by means of the dynamic mechanical thermal analysis (DMTA). The GFCD percentage of up to 15 wt% was found not to slightly affect the change in the processability, thermal stability, and glass transition temperature. PVC/GFCD composite materials are characterised by a definitely greater elastic modulus with simultaneous decrease of tensile strength and impact strength. An analysis with scanning electron microscopy revealed good adhesion between the filler and the polymer matrix.