When fabricating battery electrodes, their properties are strongly determined by the adjusted drying parameters. This does not only affect their microstructure in terms of adhesion, but also influences cell performance. The reason is found to be the binder transported to the surface during drying. Herein, it is shown that when thicker electrodes are processed, new challenges arise. On the one hand, loss of adhesion associated with certain drying conditions becomes a more serious problem; on the other hand, cracking occurs at a certain drying rate and with increasing electrode thickness.
The use of thicker electrodes can contribute to a reduction in cell costs. However, the properties of the electrode must be kept in view to be able to meet the performance requirements. Herein, the possibility of simultaneous multilayer slot die coating is investigated to improve the electrode properties of medium‐ and high‐capacity anodes. The stable coating window of the two‐layer slot die coating process is investigated to produce property‐graded multilayer electrodes. Electrodes with different styrene–butadiene rubber (SBR) gradients are investigated with regard to adhesive force and electrochemical performance. An increase in the adhesive force of up to 43.5% and an increase in the discharge capacity is observed.
The extended process chain starting from slurry mixing up to the operative lithium‐ion battery requires a deep understanding of each individual process step and knowledge of the interaction of the different process steps with each other. In particular, the intertwining of slurry mixing and drying determines the microstructure of the electrode, which in turn affects the performance of the cell. Herein, a scalable multilayer approach is used to tailor electrodes with improved mechanical and electrochemical properties, which disclose their advantages especially at high drying rates. Cryogenic broad ion beam scanning electron microscopy (Cryo‐BIB‐SEM) micrographs are used to reveal the influences of different process parameters, like slurry formulation, mixing device, and properties of the active material on the intrinsic network between active particles and binders in graphite‐based anode slurries. By a chosen combination of these slurries in a multilayer electrode, a tenfold acceleration of the drying time with favorable mechanical and electrochemical properties for full cells derived from these anodes is demonstrated.
Herein, an experimental setup comprised of a stationary convection dryer (Comb Nozzle Dryer) supplemented by a measurement for gravimetric drying curves is introduced. The drying process of anodes for lithium‐ion batteries is experimentally investigated and compared to modeling results, showing very good agreement for the investigated films. Heat transfer coefficients of the issued impinging nozzles are characterized and measured quantitatively and are used for the drying simulation of the gravimetric drying experiments. In situ temperature changes in the films are measured and presented using an infrared camera setup.
In this work, a detailed study of the drying of battery electrodes of different thicknesses is presented. A mathematical model to calculate the solvent loading and film temperature over the drying time is experimentally validated. The model is based on a first study presenting a simulation model to predict the drying course when linear drying kinetics prevail and no resistance exists for solvent transport within the film. To shed some light on the drying behavior of electrode films with different thicknesses, the start of capillary pore emptying is observed using a digital microscope. In the experiments, an onset of capillary transport even before the end of film shrinkage is observed for the electrode films with thicknesses above state‐of‐the‐art‐thickness. A clusterwise drying behavior becomes more distinct for thicker electrodes, with large areas of dry and wet capillaries next to each other, compared to a more homogenous drying of the thin electrodes. Based on these findings, the linear model is extended to consider transport limitations within the porous electrode film in the form of a moving drying front. The experiments show an increasing deviation from the linear model with increasing electrode thickness and the extended simulation, which considers transport resistances within the film, shows good agreement.