7 September 2023 in Smart Materials and Structures
In this study, a new flexible hybrid shape memory alloy composites (SMAHCs) with a polydimethylsiloxane (PDMS) matrix containing a shape memory alloy (SMA) of a hybrid Basalt/Kevlar fiber 3D woven composite is developed. The SMAHC is implanted into a glass fiber/PDMS composite laminate in a modular manner to study the stiffness of composite plates in response to temperature. The variable stiffness theory of the SMAHC is derived, and the influence of SMA parameters on the stiffness of the SMAHC is analyzed. A three-point bending test is performed to determine the stiffness of the composite plates at multiple temperature points in the form of Joule heat driving the composite plates. The stress and temperature distributions of the composite plate are analyzed in Abaqus under a temperature-displacement coupling setting. The results shows that the SMAHC stiffness is negatively correlated with SMA fiber diameter and positively correlated with SMA fiber volume fraction. With an increase in driving temperature, the stiffness of the composite plates tends to decrease. When the end temperature of the austenitic phase transformation is reached, the high-modulus austenitic SMA slightly increase the stiffness of the composite plate. The stiffness improvement is more significant when the SMAHC is placed in the middle area of the laminate and the SMA is located in the tension area. This study may provide a reference for the design of variable stiffness SMAHC for plate composite structures.
22 June 2020 in Shock and Vibration
The isolation of the body from engine vibration is the most challenging and disruptive vibrational problem. Active engine mounts (AEMs), especially electromagnetic AEMs, achieve a significant performance improvement in decreasing the wide frequency band vibration. Increasing research interest is necessary to provide the academic community with a guideline for electromagnetic AEMs. Therefore, the current review aims to comprehensively supplement the review of AEMs. The key reviews of electromagnetic AEMs focus on (1) general considerations of electromagnetic AEMs, (2) models, and (3) control strategies. This paper presents a review of the current status and developmental progress of AEMs. A theoretical model, a finite-element model, and the identification (or experimental modelling) of electromagnetic AEMs during the last 2 decades are then studied. Finally, control strategies, such as classical control, adaptive control, and two degree of freedom (2DOF) control, are discussed and compared. The main purpose of this paper is to meet the needs of researchers and engineers engaged in electromagnetic AEM analysis and control.
18 March 2022 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
21 February 2024 in Smart Materials and Structures
Shape memory alloy hybrid composite (SMAHC) tubes have the potential to actively control the torsional stiffness of structures. In this work, shape memory alloy (SMA) wires orthogonally braided with basalt fiber were heated by electricity to generate the torsional torque of the SMAHC tube, and then the torsional stiffness of the tube was measured. The macroscopic finite element model of the SMAHC tube was established to assist in the analysis of the torsional stiffness variation before and after heating. According to the experimental results, the actuating torsional ability was affected by the phase transformation recovery force of SMA. The active control of torsional stiffness depends on the change of SMA modulus, the magnitude and direction of SMA wires’ recovery force, and the thermodynamic properties of matrix at different temperatures. Then an evaluation model for the torsional stiffness control effect was proposed. These research results can be used for the adaptive control of the stiffness and vibration characteristics of rotating composite structures, and provide a novel and effective method for the control of structural torsional characteristics with lightweight effects.
6 March 2025 in Polymer Composites
7 January 2026 in Applied Composite Materials