This work aims to synthesize a photocatalyst with high photocatalytic performances and explore the possibility of using it for antibiotic removal from wastewater. For that, the spinel ZnBi₂O₄ (ZBO) was produced with the co-precipitation method and its optical, dielectric, and electrochemical characteristics were studied. The phase has been determined and characterized by X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FT-IR). For the ZBO morphology, a Scanning Electron Microscopy (SEM) has been used. Then, the optical and dielectric properties of ZBO have been evaluated by calculating refractive index n (λ), extinction coefficient (k), dissipation factor (tan δ), relaxation time (τ), and optical conductivity (σopt) using the spectral distribution of T(λ) and R(λ). An optical gap band of 2.8 eV was determined and confirmed. The electrochemical performance of ZBO was investigated and an n-type semiconductor with a flat band potential of 0.54 V_SCE was found. The photocatalytic efficiency of ZBO was investigated in order to degrade the antibiotic Cefixime (CFX) under different light source irradiations to exploit the optical properties. A high CFX degradation of approximately 89% was obtained under solar light (98 mW cm⁻²) only after 30 min, while 88% of CFX degradation efficiency has been reached after 2 h under UV irradiation (20 mW cm⁻²); this is in line with the finding of the optical characterizations. According to the obtained data, solar light assisted nanoparticle ZBO can be used successfully in wastewater to remove pharmaceutical products.

In many nations, particularly those experiencing water scarcity, novel approaches are being applied to clean wastewater. Heterogeneous photocatalysis is the most widely used of these approaches because it entails the decomposition of organic molecules into water and carbon dioxide, which is a more ecologically benign process. In our study, we studied the photocatalytic degradation process on the effluent flumequine. This treatment is made through a solar pilot reactor in the presence of immobilized titanium dioxide with three light intensities and two types of water as solvents. A variety of factors that might influence the rate of deterioration, such as flow rate, light intensity, and initial concentration, have been investigated. The maximal degradation of flumequine was achieved at more than 90% after 2.5 h under optimal conditions (an initial concentration of 5 mg/L, three lamp light intensities, and a flow rate of 29 L/h). By combining the oxidized agent H₂O₂ with this process, the photocatalytic activity was improved further to 97% under the same conditions. The mineralization of this product has also been tested using total organic carbon (TOC) analysis. A high mineralization rate has been recorded at around 50% for a high initial concentration (20 mg/L) at a flow rate of 126 L/h. The results demonstrated the highly effective removal of flumequine and the efficacy of this photocatalytic system.

Obtaining clean and high-quality water free of pathogenic microorganisms is a worldwide challenge. Various techniques have been investigated for achieving an effective removal or inactivation of these pathogenic microorganisms. One of those promising techniques is photocatalysis. In recent years, photocatalytic processes used semiconductors as photocatalysts. They were widely studied as a green and safe technology for water disinfection due to their high efficiency, being non-toxic and inexpensive, and their ability to disinfect a wide range of microorganisms under UV or visible light. In this review, we summarized the inactivation mechanisms of different waterborne pathogenic microorganisms by semiconductor photocatalysts. However, the photocatalytic efficiency of semiconductors photocatalysts, especially titanium dioxide, under visible light is limited and hence needs further improvements. Several strategies have been studied to improve their efficiencies which are briefly discussed in this review. With the developing of nanotechnology, doping with nanomaterials can increase and promote the semiconductor’s photocatalytic efficiency, which can enhance the deactivation or damage of a large number of waterborne pathogenic microorganisms. Here, we present an overview of antimicrobial effects for a wide range of nano-photocatalysts, including titanium dioxide-based, other metal-containing, and metal-free photocatalysts. Promising future directions and challenges for materials research in photocatalytic water disinfection are also concluded in this review.