In the propulsion system of cryogenic liquid rockets, low-frequency pressure oscillation is a long-standing issue occurring in its feeding pipe, and is not conducive to the normal operation of the rocket. Its mechanism and excitation process are not very clear due to the limitation of the existing numerical method and the difficulty of the real dynamic experiment. Inspired by the periodic suck-back flow phenomenon of steam condensation, the fluctuation of the two-phase interface might be the crucial factor to initiate the low-frequency pressure oscillation. To simulate this interfacial characteristic of cryogenic propellant, a novel numerical model is proposed to predict the mass transfer rate weighted by the interfacial curvature. Aiming at the oxygen jet condensation simulation, the low-frequency pressure oscillation phenomenon is obtained successfully with the excitation frequency of 10.6 Hz, consistent with the natural frequency of the engine test run. It is conducted so the low-frequency pressure oscillation is caused by the periodic condensation of the continuous oxygen vapour plume, along with an oxygen suck-back flow phenomenon. In addition, the results indicate that both the oxygen and liquid oxygen mass flux promote the rise in the frequency of pressure oscillation. These conclusions provide theoretical instructions for the design and operation of the propulsion system of a cryogenic liquid rocket.
In pursuit of high efficiency of energy conveying system, a new high temperature superconducting electric power transmission system cooled by LNG (liquefied natural gas) is investigated. LNG is used to contribute a low temperature environment for the superconducting cable operated in the temperature range of 85-95K. On the basis of previous research, the new structure of the combined transmission system consists of a flowing channel for sub-cooled LN2 (liquid nitrogen) as a kind of protective medium. In this paper, the remarkable advantages of the combined transmission system are demonstrated through the analysis. Comparison of efficiencies in different operation condition has been conducted. The results showed that the new system is of great significance for the high efficient transmission of energy.
Oxygen jet condensation always occurs with intense unstable oscillation in the cryogenic delivery pipe of a space launch vehicle. This phenomenon threatens the safety of the propulsion pipeline. It is essential to explore the transient physical features of oxygen jet condensation precisely, including the spectrum of pressure oscillation. Aiming at a deeper understanding of the thermal hydraulic characteristic of oxygen jet condensation, abundant simulations are carried out using a modified phase change method. In this model, the height function method is introduced to capture the interfacial curvature to reveal the mechanism of periodic fluctuation. The simulation proves that three typical flow patterns are found at variant operating conditions in oxygen jet condensation: chugging, oscillation, and swinging. The condensation regime diagram is summarized according to the flow pattern distribution. The chugging flow, along with the phenomenon of liquid oxygen sucked-back flow, shows the most intense pressure oscillation with a maximum amplitude of 133 kPa. In the oscillation flow, the oxygen vapor plume shrinks periodically with a low frequency of about 10 Hz. The swinging flow is a stable flow pattern with a slight pulsation of oxygen vapor plume wake. Its amplitude of pressure oscillation is approximately 1–3 kPa. The influence of liquid oxygen mass flow rate and subcooling on the unstable characteristic is also obtained. These findings offer ample theoretical direction for the development of the space launch vehicle.
9 August 2023 in Asia-Pacific Journal of Chemical Engineering
Low-frequency oscillatory flow is a long-standing instability in cryogenic jet condensation systems and is closely associated with abnormal pressure fluctuations in propulsion pipelines. While previous studies mainly focused on operating conditions, the role of injector orifice layout in triggering low-frequency oscillations remains unclear. In this work, a three-dimensional numerical investigation was conducted to examine the effect of orifice layout on condensation-induced oscillatory flow in an oxygen jet condensation system. A curvature-coupled mass transfer model is employed, in which the interfacial mass transfer rate is dynamically linked to local vapor–liquid interfacial curvature, enabling accurate representation of interfacial evolution. A series of numerical cases are designed by varying the number, arrangement, and diameter of orifices under different combinations of mass rate, mass flux, and total injection area. Two distinct condensation patterns are identified: suck-back chugging and weak pulsation. Pronounced low-frequency oscillations are observed only for specific orifice layouts. When the total injection area and gaseous oxygen mass rate are maintained, chugging persists under different layouts, producing dominant frequencies of approximately 10~11 Hz and pressure amplitudes of about 80~120 kPa. Once either the total area or mass rate is altered, the system transitions to weak pulsation with pressure fluctuations below 3 kPa. These results demonstrate that low-frequency oscillatory flow is a layout-enabled instability rather than a mass-flux-controlled phenomenon, highlighting the importance of injector geometric design in regulating condensation-induced oscillations.
About Me
Welcome to our team's website (http://cryost.cn) for the follow-up cooperation!
Welcome to our team's website (http://cryost.cn) for the follow-up cooperation!