Luigi Melchiorre

Dr. Luigi Melchiorre

Dept. of Electrical and Information Engineering, Polytechnic University of Bari, Bari, Puglia, Italy
orcid
Information Engineer || PhD Candidate in Industry 4.0 at the...

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 December 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Luigi MelchiorreLuigi Melchiorre
Luigi Melchiorre
Ilaria MarascoIlaria Marasco
Ilaria Marasco
GNGiovanni Niro
Giovanni Niro
Vito BasileVito Basile
Vito Basile
Valeria MarroccoValeria Marrocco
Valeria Marrocco
Marco GrandeMarco Grande
Marco Grande
Through the years, inspiration from nature has taken the lead for technological development and improvement. This concept firmly applies to the design of the antennas, whose performances receive a relevant boost due to the implementation of bio-inspired geometries. In particular, this idea holds in the present scenario, where antennas working in the higher frequency range (5G and mm-wave), require wide bandwidth and high gain; nonetheless, ease of fabrication and rapid production still have their importance. To this aim, polymer-based 3D antennas, such as Dielectric Resonator Antennas (DRAs) have been considered as suitable for fulfilling antenna performance and fabrication requirements. Differently from numerous works related to planar-metal-based antenna development, bio-inspired DRAs for 5G and mm-wave applications are at their beginning. In this scenario, the present paper proposes the analysis and optimization of a bio-inspired Spiral shell DRA (SsDRA) implemented by means of Gielis’ superformula, with the goal of boosting the antenna bandwidth. The optimized SsDRA geometrical parameters were also determined and discussed based on its fabrication feasibility exploiting Additive Manufacturing technologies. The results proved that the SsDRA provides relevant bandwidth, about 2 GHz wide, and satisfactory gain (3.7 dBi and 5 dBi, respectively) at two different frequencies, 3.5 GHz and 5.5 GHz.

29 August 2021 in Micromachines
Verified
Journal Article
Open access
PDF file
Valeria MarroccoValeria Marrocco
Valeria Marrocco
Vito BasileVito Basile
Vito Basile
Ilaria MarascoIlaria Marasco
Ilaria Marasco
GNGiovanni Niro
Giovanni Niro
Luigi MelchiorreLuigi Melchiorre
Luigi Melchiorre
IFIrene Fassi
Irene Fassi
Bio-inspired Dielectric Resonator Antennas (DRAs) are engaging more and more attention from the scientific community due to their exceptional wideband characteristic, which is especially desirable for the implementation of 5G communications. Nonetheless, since these antennas exhibit peculiar geometries in their micro-features, high dimensional accuracy must be accomplished via the selection of the most suitable fabrication process. In this study, the challenges to the manufacturing process presented by the wideband Spiral shell Dielectric Resonator Antenna (SsDRA), based on the Gielis superformula, are addressed. Three prototypes, made of three different photopolymer resins, were manufactured by bottom-up micro-Stereolithography (SLA). This process allows to cope with SsDRA’s fabrication criticalities, especially concerning the wavy features characterizing the thin spiral surface and the micro-features located in close proximity to the spiral origin. The assembly of the SsDRAs with a ground plane and feed probe was also accurately managed in order to guarantee reliable and repeatable measurements. The scattering parameter S11 trends were then measured by means of a Vector Network Analyzer, while the realized gains and 3D radiation diagrams were measured in the anechoic chamber. The experimental results show that all SsDRAs display relevant wideband behavior of 2 GHz at −10 dB in the sub-6 GHz range.

11 June 2025 in Sensors
Verified
Journal Article
Open access
PDF file
Luigi MelchiorreLuigi Melchiorre
Luigi Melchiorre
ATAjmal Thottoli
Ajmal Thottoli
Artem S. VorobevArtem S. Vorobev
Artem S. Vorobev
GMGiansergio Menduni
Giansergio Menduni
Angelo SampaoloAngelo Sampaolo
Angelo Sampaolo
Vincenzo SpagnoloVincenzo Spagnolo
Vincenzo Spagnolo
This work demonstrates an ultra-compact optical gas-sensing system, consisting of a pigtailed laser diode emitting at 1392.5 nm for water vapor (H2O) detection, a silicon nitride (Si3N4) optical waveguide to guide the laser light, and a custom-designed, low-frequency, and T-shaped Quartz Tuning Fork (QTF) as the sensitive element. The system employs both Quartz-Enhanced Photoacoustic Spectroscopy (QEPAS) and Light-Induced Thermoelastic Spectroscopy (LITES) techniques for trace gas sensing. A 3.8 mm-wide, S-shaped waveguide path was designed to prevent scattered laser light from directly illuminating the QTF. Both QEPAS and LITES demonstrated comparably low signal-to-noise ratios (SNRs), ranging from 1.6 to 3.2 for a 1.6% indoor H2O concentration, primarily owing to the reduced optical power (~300 μW) delivered to the QTF excitation point. These results demonstrate the feasibility of integrating photonic devices and piezoelectric components into portable gas-sensing systems for challenging environments.

31 January 2026 in Optics & Laser Technology
Verified
Journal Article
Open access
Luigi MelchiorreLuigi Melchiorre
Luigi Melchiorre
GMGiansergio Menduni
Giansergio Menduni
GMGiovanni Magno
Giovanni Magno
LOLiam O'Faolain
Liam O'Faolain
PPPietro Patimisco
Pietro Patimisco
Angelo SampaoloAngelo Sampaolo
Angelo Sampaolo

8 March 2024
Verified
Conference Paper
Closed access
PDF file
Luigi MelchiorreLuigi Melchiorre
Luigi Melchiorre
AEArianna Elefante
Arianna Elefante
MGMarilena Giglio
Marilena Giglio
AZAndrea Zifarelli
Andrea Zifarelli
VVValeria Villada
Valeria Villada
VSVincenzo Spagnolo
Vincenzo Spagnolo
Simultaneous detection of different gas species represents an indispensable asset for several applications, such as instantaneous quantification of isotope concentration ratios, self-calibrating sensors, and monitoring of the temporal evolution of a chemical reaction. In this research work, a dual-gas quartz-enhanced photoacoustic spectroscopy (QEPAS) sensor for a real-time analysis and in a continuous flow monitoring of one reactant and one product of a gas-phase chemical reaction involving nitrogen dioxide (NO2) and water vapor (i.e., H2O) – as reaction reactants – and nitrogen monoxide (NO) – as one of the reaction products – was realized. The QEPAS sensor implemented a spectrophone composed of a pair of metallic acoustic resonator tubes applied at both antinode points of a custom quartz tuning fork (QTF). In this configuration, two different quantum cascade lasers (QCLs) were used, having an emission wavelength centered at 5.26 μm – resonant with a nitrogen monoxide absorption feature located at 1,900.075 cm-1 – and at 6.25 μm – resonant with a nitrogen dioxide absorption feature located at 1,601.77 cm-1 –, respectively. The chemical reaction was studied by injecting in the gas line a certified concentration of 5,000 parts-per-million (ppm) of NO2:N2 and monitoring the QEPAS signals at four different total gas flow values, i.e., 10, 20, 30 and 50 standard cubic centimeters per minute (SCCM), respectively.