Mansoor Dashti Ardakani

Dr. Mansoor Dashti Ardakani

University of Quebec, Québec, Canada

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 January 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
HSHoma Arab Salmanabadi
Homa Arab Salmanabadi
Lydia ChioukhLydia Chioukh
Lydia Chioukh
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
SDSteven Dufour
Steven Dufour
Serioja Ovidiu TatuSerioja Ovidiu Tatu
Serioja Ovidiu Tatu
Studies show that the early (stage I) diagnosis of cancer increases the survival rate of patients, and significantly reduces treatment costs. Millimeter-wave radars can detect skin tumors based on the difference between the electrical properties of melanomas and healthy skin tissues. This paper proposes a low-power multitone continuous-wave radar design at 77 GHz for biomedical imaging applications, to be used for skin cancer detection. The sensor implementation is based on a low-cost Miniature Hybrid Microwave Integrated Circuit (MHMIC) design. The entire sensor was integrated on a 0.127mm thin ceramic substrate. Two 16-element patch antenna arrays are implemented in the transmitter and receiver modules. The receiver is a six-port homodyne quadrature down-converter. The integrated power detectors are fabricated using HSCH-9161 Schottky diodes. The sensor was encapsulated in a metallic fixture with dimensions 35 by 45 mm. Two cascaded amplifier circuits are designed and implemented for amplifying baseband voltages at the output of each power detector. The proposed radar design has the ability to detect the dielectic properties of tissues, making it suitable for the detection of melanomas with an accuracy on the order of tens of microns.

7 May 2021 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
RKReza Karimian
Reza Karimian
STSajjad Taravati
Sajjad Taravati
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
SAShahrokh Ahmadi
Shahrokh Ahmadi
MZMona Zaghloul
Mona Zaghloul
This study presents a nonreciprocal-beam phased-array antenna constituted of phase-gradient patch radiators integrated with transistor-based nonreciprocal phase shifters. Such an antenna exhibits different beams for transmission and reception states. The proposed phased-array antenna provides power amplification for both transmission and reception states, which is of paramount importance in most practical applications. In addition, in contrast to the recently proposed time-modulated antennas, the proposed nonreciprocal-beam phased-array antenna introduces no undesired time harmonics and unwanted frequency conversion, which requires no radio frequency bias signal. Furthermore, the nonreciprocal phased-array antenna is lightweight and is amenable to integrated circuit fabrication. The transmission and reception beam angles, the beam shapes, and the power amplification level may be easily tuned by changing the direct current (dc) bias of the transistors and phase of the passive phase shifters. Such a nonreciprocal-beam phased-array antenna is expected to find military and commercial applications.

18 March 2020 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
MAMohammad Akbari
Mohammad Akbari
MFMohammadmahdi Farahani
Mohammadmahdi Farahani
SZSaman Zarbakhsh
Saman Zarbakhsh
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
ASAbdel Sebak
Abdel Sebak
Omar RamahiOmar Ramahi
Omar Ramahi
This manuscript introduces a low loss beamformer with a capability of two-dimensional scanning in elevation and azimuth directions at 30 GHz for 5G applications. The proposed beamformer is based on the broadband and highly-efficient rectangular air-filled coaxial line. The beamformer is fed by four standard waveguides (WR-28) as the input ports. Correspondingly, each of the input ports using specific transitions is connected to the coaxial beamformer network. Ultimately, the coaxial transmission lines, in the radiating part of the beamformer, feed a 2×2 waveguide antenna array. The structure is aptly called a waveguide-coaxial-waveguide beamformer. The total dimensions of the fabricated prototype are 60 mm × 60 mm ( corresponding to 6λ × 6λ). The beamformer is able to generate four fixed beams, one in each quadrant at an elevation angle of 25° from the broadside to the array axis. The results demonstrate that the proposed passive beamformer has a radiation efficiency greater than 90% over the frequency bandwidth of interest. Good stability of the radiation pattern and maximum gain over the desired bandwidth were achieved while maintaining sidelobes level of less than 20 dB.

3 December 2021 in IEEE Access
Verified
Journal Article
Open access
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
Serioja Ovidiu TatuSerioja Ovidiu Tatu
Serioja Ovidiu Tatu
The realization and analysis of an implemented V-band six-port demodulator, operating over 60 GHz band, are presented in this paper. The performance of the design in real-time high-data-rate wireless data transmission is strongly proved using different modulated signals. The valid high data-rate demodulation results achieved over a 7 GHz band (from 57 to 64 GHz), provide a confirmation that this six-port interferometer receiver is an attractive proposition for homodyne or heterodyne transceivers designed for high-speed short-range wireless communication systems, such as future wireless small cell backhaul for 5G. The performance of the proposed direct conversion receiver is characterized in terms of the bit error rate (BER) and error vector magnitude (EVM) for various M-PSK/M-QAM demodulated signals. To verify the resulting data, the relation between the error vector magnitude and the bit error rate is also analyzed. Theoretical results are matched to measured values and validate that the EVM and BER are appropriate metrics for mm-wave channels limited by additive white Gaussian noise. In the last section, the proposed six-port interferometer is introduced for precise estimation of carrier frequency offset (CFO) and Doppler shift in V-band wireless systems. The final results, which include various modulation configurations at mega or Giga symbol rates generated by the implemented transmitter, are supported by laboratory measurements.

15 June 2021 in IEEE Access
Verified
Journal Article
Open access
MAMohammad Akbari
Mohammad Akbari
MFMohammadmahdi Farahani
Mohammadmahdi Farahani
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
Ali lalbakhshAli lalbakhsh
Ali lalbakhsh
SZSaman Zarbakhsh
Saman Zarbakhsh
TDTayeb Denidani
Tayeb Denidani
The manuscript presents the design and characterization of a wideband front-end receiver, based on hollow waveguide technology, for the wireless access point (WAP) applications. The Ka-band receiver is comprised of a low-loss beam-switching antenna network (BSAN) with two-dimensional (2D) scanning property. For demodulation, the receiver uses an efficient six-port network (SPN) that is composed of four 90° hybrid couplers and a 90° phase shifter. To suppress the phase imbalance on the entire band of interest, 27 GHz to 33 GHz, a frequency-independent phase shifter with a minimum phase error is suggested. The SPN receiver is integrated with antenna-in-package in waveguide technology to decrease the insertion losses and noise levels at the first stages. To determine the SPN phase errors, a theoretical and experimental analysis of real-time wireless data transmission utilizing phase-shift keying (PSK) and quadrature amplitude modulated (QAM) signal is conducted. Besides, channel capacity along with beamformer influence on channel performance improvement are determined.

4 November 2021 in Eng
Verified
Journal Article
Open access
PDF file
RKReza Karimian
Reza Karimian
Mansoor Dashti ArdakaniMansoor Dashti Ardakani
Mansoor Dashti Ardakani
SAShahrokh Ahmadi
Shahrokh Ahmadi
MZMona Zaghloul
Mona Zaghloul
A compact artificial magnetic conductor (AMC) structure for the application of specific absorption rate (SAR) reduction is presented in this paper. A magneto-dielectric (MD) structure as a host of AMC substrate is used to miniaturize the AMC size. The magneto-dielectric has been designed with a low-profile spiral loop in a way to have a high permittivity and permeability for the desired center frequency of 3.5 GHz. Simulation results confirm the zero-degree reflection phase of the proposed AMC unit cell. Moreover, a 70% reduction has been achieved in comparison to the conventional AMC. To validate the simulation results, a prototype of the board is fabricated and measured with a coplanar waveguide (CPW) antenna for the reflection coefficient. The measurement results display an excellent agreement with the simulation ones. A VOXEL model of a human body is utilized to determine the SAR value of the proposed structure. Considering the maximum SAR value for an average of 10 g human tissue, more than 70% SAR reduction is verified for the CPW antenna with the recommended MD-AMC structure compared to a conventional single CPW antenna.