This article presents a fuzzy simple additive weighting multi-objective micro-genetic algorithm (FSAW-MO-MGA) for high-power microwave (HPM) sources optimization. The FSAW-MO-MGA and a single-objective genetic algorithm are independently used to optimize the same Ka -band relativistic backward-wave oscillator (RBWO) device. The use of the FSAW-MO-MGA allowed us to obtain an optimized device structure of RBWO with comprehensively improved performance. Particle-in-cell (PIC) simulation results show that the optimized RBWO can generate microwave pulses with an output power of 616.0 MW and an operating frequency of 30.33 GHz under a diode voltage of 625.6 kV, and the diode current is 6.59 kA at a guiding magnetic field of 0.8 T. Compared with the original RBWO, the output power of the optimized RBWO has been increased by 197.6%, the beam-to-microwave conversion efficiency has increased from 5.0% to 14.9%, and the beam-current transmission has increased from 70.13% to 87.72%. The reasons for these improvements in device performance are analyzed in detail.
26 June 2017 in Japanese Journal of Applied Physics
Surface morphology is one of the main factor affecting the secondary electron (SE) emission from a rough metal surface. To overcome the limitation of only using the roughness to reveal the SE emission properties of a rough surface morphology, the fluctuation correlation length, which represents the spatial frequency of surface fluctuation, is thus introduced. In addition, the effects of the rough surface morphology on SE emission properties from the metal surface, which considers both the surface roughness and the fluctuation correlation length, are examined in this work. On the basis of the mechanism of electron interaction with morphology including the shading, multigeneration, and oblique effects, the SE emission properties versus the rough surface morphology, primary electron energy, and incident angle can be reasonably explained. The results further reveal the effect of surface morphology on SE emission, which gives a comprehensive insight into the control of SE emission properties using surface morphology.
This article introduced a multipactor threshold criterion based on collision and emission currents, and the simulation results were compared using a traditional method. The impact of macroparticle weight on multipactor saturation was studied using electromagnetic particle-in-cell (EM-PIC) simulations of CST Particle Studio. It was found that the simulation results converged when the macroparticle weight was less than 106. A model calculating accumulated charge on the dielectric surface was proposed and validated against theoretical calculations. The dynamic evolution of multipactor in dielectric-loaded parallel-plate waveguide was analyzed, and predictions were validated against results from the existing model. Finally, the effect of surface charge fields and space charge effect on the multipactor mechanism was studied. The results showed that the multipactor could be suppressed when the ratio of the number of accumulated electrons on the dielectric surface to the saturation electron population was greater than 3.96.
π modes are unique topological edge states appearing in Floquet systems with periodic modulations of the underlying lattice structure in the evolution variable, such as dynamically modulated Su–Schrieffer–Heeger (SSH) lattices. These edge states are anomalous states usually appearing between Floquet replicas of the same band, even if the standard topological index remains zero for this band. While linear and nonlinear π modes were observed in conservative systems, they have never been studied in the nonlinear regime in the non-Hermitian systems with structured gain and losses. Here, we show that the SSH waveguide array with periodically oscillating waveguide positions in the propagation direction and with the parity-time symmetric refractive index landscape can support π modes that are damped or amplified at different ends of the array. By including nonlinearity and nonlinear absorption into our continuous system, we achieve stable lasing in the π mode at one end of the array. The representative feature of this system is that lasing in it is thresholdless and occurs even at low gain–loss amplitudes. The degree of localization of lasing π modes can be flexibly controlled by the amplitude of transverse waveguide oscillations. This work therefore introduces a new type of topological Floquet laser and a route to manipulate π modes by structured gain and losses.