Ondřej Michal

Dr. Ondřej Michal

University of West Bohemia, Pilsen, Czech Republic
orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 May 2018 in Nanomaterials
Verified
Journal Article
Open access
PDF file
Jaroslav HornakJaroslav Hornak
Jaroslav Hornak
Pavel TrnkaPavel Trnka
Pavel Trnka
Petr KadlecPetr Kadlec
Petr Kadlec
Ondřej MichalOndřej Michal
Ondřej Michal
VMVáclav Mentlík
Václav Mentlík
Zoltan Adam TamusZoltan Adam Tamus
Zoltan Adam Tamus
Composite insulation materials are an inseparable part of numerous electrical devices because of synergy effect between their individual parts. One of the main aims of the presented study is an introduction of the dielectric properties of nanoscale magnesium oxide powder via Broadband Dielectric Spectroscopy (BDS). These unique results present the behavior of relative permittivity and loss factor in frequency and temperature range. Following the current trends in the application of inorganic nanofillers, this article is complemented by the study of dielectric properties (dielectric strength, volume resistivity, dissipation factor and relative permittivity) of epoxy-based composites depending on the filler amount (0, 0.5, 0.75, 1 and 1.25 weight percent). These parameters are the most important for the design and development of the insulation systems. The X-ray diffraction patterns are presented for pure resin and resin with optimal filler amount (1 wt %), which was estimated according to measurement results. Magnesium oxide nanoparticles were also treated by addition of silane coupling agent ( γ -Glycidoxypropyltrimethoxysilane), in the case of optimal filler loading (1 wt %) as well. Besides previously mentioned parameters, the effects of surface functionalization have been observed by two unique measurement and evaluation techniques which have never been used for this evaluation, i.e., reduced resorption curves (RRCs) and voltage response method (VR). These methods (developed in our departments), extend the possibilities of measurement of composite dielectric responses related to DC voltage application, allow the facile comparability of different materials and could be used for dispersion level evaluation. This fact has been confirmed by X-ray diffraction analyses.

26 January 2021 in Polymers
Verified
Journal Article
Open access
PDF file
Jozef KúdelčíkJozef Kúdelčík
Jozef Kúdelčík
SHStefan Hardon
Stefan Hardon
Pavel TrnkaPavel Trnka
Pavel Trnka
Ondřej MichalOndřej Michal
Ondřej Michal
Jaroslav HornakJaroslav Hornak
Jaroslav Hornak
The influence of different concentrations (0.5, 1.0, and 2.0 wt.%) of Zinc Oxide (ZnO) filler on the dielectric properties of the cold-curing polyurethane (PU) resin is presented in this study. For this purpose, the direct DC conductivity and the broadband dielectric spectroscopy measurements were used to describe the changes in dielectric responses of PU/ZnO nanocomposites over the frequency and temperature range, respectively. It can be stated that, the 1.0 wt.% nanoparticles and lower caused a decrease in the real relative permittivity compared to the pure PU resin, while the higher concentration of nanoparticles for frequencies above 1 Hz had the opposite effect. The presence of nanoparticles in the polyurethane resin affected the segmental dynamics of the polymer chain and changed a charge distribution in the given system. These changes caused a shift of local relaxation peaks in the spectra of imaginary permittivity and dissipation factor of nanocomposites. It is suggested that the temperature-dependent transition of the electric properties in the nano-composite is closely associated with the α-relaxation and intermediate dipolar effects (IDE).

28 May 2022 in Polymers
Verified
Journal Article
Open access
PDF file
SHStefan Hardon
Stefan Hardon
Jozef KúdelčíkJozef Kúdelčík
Jozef Kúdelčík
ABAnton Baran
Anton Baran
Ondřej MichalOndřej Michal
Ondřej Michal
Pavel TrnkaPavel Trnka
Pavel Trnka
Jaroslav HornakJaroslav Hornak
Jaroslav Hornak
The influence of various types of nanoparticle fillers with the same diameter of 20 nm were separately incorporated into a single component impregnating resin based on a polyesterimide (PEI) matrix and its subsequent changes in complex relative permittivity were studied. In this paper, nanoparticles of Al2O3 and ZnO were dispersed into PEI (with 0.5 and 1 wt.%) to prepare nanocomposite polymer. Dielectric frequency spectroscopy was used to measure the dependence of the real and imaginary parts of complex relative permittivity within the frequency range of 1 mHz to 1 MHz at a temperature range from +20 °C to +120 °C. The presence of weight concentration of nanoparticles in the PEI resin has an impact on the segmental dynamics of the polymer chain and changed the charge distribution in the given system. The changes detected in the 1H NMR spectra confirm that dispersed nanoparticles in PEI lead to the formation of loose structures, which results in higher polymer chain mobility. A shift of the local relaxation peaks, corresponding to the α-relaxation process, and higher mobility of the polymer chains in the spectra of imaginary permittivity of the investigated nanocomposites was observed.

14 August 2024 in IEEE Access
Verified
Journal Article
Open access
SHStefan Hardon
Stefan Hardon
Jozef KúdelčíkJozef Kúdelčík
Jozef Kúdelčík
ABAnton Baran
Anton Baran
PTPavel Trnka
Pavel Trnka
Ondřej MichalOndřej Michal
Ondřej Michal
JHJaroslav Hornak
Jaroslav Hornak
The aim of study is addressing the influence of nanoparticles (NPs) on the dielectric properties of polyurethane. In this research, only investigated the effect of Al2O3, MgO and ZnO NPs for concentrations up to 2 wt.% with the temperature range from 25 to 120 oC. During the preparation of nanocomposites, polymer chains bind to NPs, which then limits their mobility. This effect results in a decrease in real permittivity and the course of polarization mechanisms. An increase in permittivity over the entire temperature range only for a 2 wt.% MgO concentration was observed. The decrease in the mobility of polymer chains was confirmed by dynamic-mechanical analysis. This method also results in an increase in the glass transition temperature depending on the type and concentration of NPs. The presence of NPs and the limited mobility of the polymer chains results in a shift of the low-frequency local maximum to lower frequencies.

5 July 2020
Verified
Conference Paper
Closed access
Jaroslav HornakJaroslav Hornak
Jaroslav Hornak
Ondřej MichalOndřej Michal
Ondřej Michal
Pavel TrnkaPavel Trnka
Pavel Trnka
VMV. Mentlik
V. Mentlik
GVG. Vuity
G. Vuity
Zoltan Adam TamusZoltan Adam Tamus
Zoltan Adam Tamus
Dielectric materials are an essential part of all electrical devices. One of the reasons, their properties are studied, is that they are most impacted by internal and external influences during the lifetime of the electrical device. Composite materials are commonly used as a dielectric part, because of the synergy effect, when combining various components that have a positive impact to combat various these negative influences. In opposition to this, the composite material is commonly layered into thick tapes to meet device nominal voltage usage. This layering has a negative impact on some important material properties, such as dissipation factor or thermal conductivity. In recent years, using nanocomposites becomes an interesting way to improve composite materials and their reliability in electrical devices. This paper deals with the current and resorption characteristics of nanocomposite materials. These characteristics are important for understanding the influence of nanocomponent on the overall composite properties. Nanocomposite material used in this experiment was prepared by the Department of Technologies and Measurements and was consisted of epoxy resin and magnesium oxide nanoparticles. For the experiment, different values of filled nanocomposites were prepared (0, 1, 3, 5, 10, 20, 30 wt.% of MgO). Nanocomposites have been investigated by two research institutions. By this experiment, we confirmed our initial hypothesis that MgO positively influences the absorption and resorption characteristics to a certain level of filling.

4 April 2025 in Energies
Verified
Journal Article
Open access
PDF file
Pavel TrnkaPavel Trnka
Pavel Trnka
Jaroslav HornakJaroslav Hornak
Jaroslav Hornak
MTMagdalena Trnkova
Magdalena Trnkova
Ondřej MichalOndřej Michal
Ondřej Michal
ZMZdislava Mokrá
Zdislava Mokrá
ZFZdeněk Frána
Zdeněk Frána
The introduction of a new insulating oil or, for instance, a new type of insulation or sealing into a transformer necessitates tests for material compatibility. Compatibility tests of liquids with the structural internal materials of transformers are conducted to prevent undesired interactions between insulating fluids and the formation of products that could lead to the generation of undesirable ions, sediments, or chemical compounds that result in a reduction in the dielectric property performance of the fluid. This includes chemical reactions (hydrolysis, hydrogenation, oxidation, formation of sulfates or sulfides, etc.) and degradation, the formation of conductive suspensions, the generation of undesirable condensation, and alterations in other fluid properties, such as interfacial tension between oil and water, viscosity, flashpoint, etc. Changes must also not occur in the strength and hardness of gasket material, which could result in undesirable fluid leakage. This paper describes the novel methodology and results of several proposed tests, including the impact on oil viscosity, material hardness, FT-IR analysis of oils, partial discharges in different oils, dielectric properties, and more, conducted during compatibility and aging tests at 120 °C and 140 °C performed on materials used in particular distribution transformers being prepared for natural ester use. The results show notable differences in the behavior of insulating fluids and aged submerged materials. While mineral oils exhibit lower dissipation factors compared to natural esters, the latter demonstrate slower and less severe hardening effects on gaskets during high-temperature aging (e.g., Shore 35.25 in mineral oil vs. 21–22.5 in natural esters). The tensile strength of the tested cable ties decreased significantly (from 260 to approx. 60 N) in mineral oil but increased in natural ester (320 N/120 °C exposition). This study also highlights a novel insight into partial discharge mechanisms, where differences in viscosity, conductivity phenomena, and dielectric constants result in presented differences in inception voltages and prebreakdown activity.