Phase composition of epitaxial/textured LiNbO3 films on sapphire substrates, grown by pulsed laser deposition, atmospheric pressure metal organic chemical vapor deposition and pulsed injection metal organic chemical vapor deposition was studied by conventional x-ray diffraction techniques. Raman spectroscopy, being highly sensitive to the symmetry of materials, was used as a countercheck in the compositional analysis. The wavenumbers of Raman modes of LiNb3O8 and Li3NbO4 phases were identified from Raman spectra of synthesized powders. Asymmetry of profiles of x-ray diffraction reflections of LiNbO3 films was studied. This asymmetry may have different origins which consequently may result in misleading conclusions about phase composition of textured LiNbO3 films.
2 March 2021 in Journal of Physics D: Applied Physics
Remote epitaxy via graphene has recently attracted significant attention, since it provides the possibility to lift-off the grown epitaxial layer, reuse the substrate, and produce flexible devices. However, extensive research is still necessary to fully understand the III-nitride formation on the van der Waals surface of a two-dimensional material and utilize remote epitaxy to its full potential. In this work, the growth of a GaN epilayer using a GaN/sapphire template covered with monolayer graphene is presented. Metalorganic vapor phase epitaxy is chosen to fabricate both the template and the nitride epilayer on top as a cost-effective approach toward GaN homoepitaxy. One-step and multi-step growth temperature protocols are demonstrated while paying particular attention to the graphene interface. GaN seed formation on graphene is analyzed to identify remote epitaxy. Crystalline quality improvement of the epilayer by adjusting the growth parameters is further discussed to provide useful insights into GaN growth on a GaN/sapphire template via monolayer graphene.
Growth of BGaN epitaxial layers by metalorganic chemical vapor deposition (MOCVD) using triethylboron (TEB) as a boron source was studied on 6H-SiC substrate and on GaN and AlN templates on sapphire. X-ray diffraction, atomic force microscopy and photoluminescence spectroscopy were exploited to characterize the structural quality, surface morphology, luminescence efficiency, and boron content. Silicon carbide was shown to be slightly superior to AlN/sapphire and considerably better than GaN/sapphire as the most favorable substrate to incorporate a possibly higher boron content. Increasing TEB flow rate at correspondingly optimized growth temperature and V/III ratio enabled us to achieve the boron content of up to 5.5%, though at the expense of structural quality. We showed that the band gap bowing parameter is similar for the epilayers deposited on all the three templates/substrates under study and is approximately equal to 4 eV, substantially lower than reported before.
1 November 2021 in Materials Science in Semiconductor Processing