Surajo Musa

Dr. Surajo Musa

Jigawa State Institute of Information Technology Kazaure

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 July 2019 in Sensors
Verified
Journal Article
Open access
PDF file
Surajo MusaSurajo Musa
Surajo Musa
RARaja Syamsul Azmir Raja Abdullah
Raja Syamsul Azmir Raja Abdullah
ASADUWATI SALI
ADUWATI SALI
Alyani IsmailAlyani Ismail
Alyani Ismail
NRNur Emileen Abdul Rashid
Nur Emileen Abdul Rashid
The increase in drone misuse by civilian apart from military applications is alarming and need to be addressed. This drone is characterized as a low altitude, slow speed, and small radar cross-section (RCS) (LSS) target and is considered difficult to be detected and classified among other biological targets, such as insects and birds existing in the same surveillance volume. Although several attempts reported the successful drone detection on radio frequency-based (RF), thermal, acoustic, video imaging, and other non-technical methods, however, there are also many limitations. Thus, this paper investigated a micro-Doppler analysis from drone rotating blades for detection in a special Forward Scattering Radar (FSR) geometry. The paper leveraged the identified benefits of FSR mode over conventional radars, such as improved radar cross-section (RCS) value irrespective of radar absorbing material (RAM), direct signal perturbation, and high resolutions. To prove the concept, a received signal model for micro-Doppler analysis, a simulation work, and experimental validation are elaborated and explained in the paper. Two rotating blades aspect angle scenarios were considered, which are (i) when drone makes a turn, the blade cross-sectional area faces the receiver and (ii) when drone maneuvers normally, the cross-sectional blade faces up. The FSR system successfully detected a commercial drone and extracted the micro features of a rotating blade. It further verified the feasibility of using a parabolic dish antenna as a receiver in FSR geometry; this marked an appreciable achievement towards the FSR system performance, which in future could be implemented as either active or passive FSR system.

19 September 2020 in Remote Sensing
Verified
Journal Article
Open access
PDF file
RARaja Syamsul Azmir Raja Abdullah
Raja Syamsul Azmir Raja Abdullah
Surajo MusaSurajo Musa
Surajo Musa
NRNUR EMILEEN RASHID
NUR EMILEEN RASHID
ASADUWATI SALI
ADUWATI SALI
ASAsem Ahmad Salah
Asem Ahmad Salah
Alyani IsmailAlyani Ismail
Alyani Ismail
This paper presents a passive radar system using a signal of opportunity from Digital Video Broadcasting Satellite (DVB-S). The ultimate purpose of the system is to be used as an air traffic monitoring and surveillance system. However, the work focuses on drone detection as a proof of the concept. Detecting a drone by using satellite-based passive radar possess inherent challenges, such as the small radar cross section and low speed. Therefore, this paper proposes a unique method by leveraging the advantage of forward-scattering radar (FSR) topology and characteristics to detect a drone; in other words, the system is known as a passive FSR (p-FSR) system. In the signal-processing algorithm, the empirical mode decomposition (EMD) is applied to the received signal to extract the unique feature vector of the micro-Doppler frequency from the drone’s rotating blades. The paper highlights the p-FSR experimental setup and experiment campaign to detect drones. The experimental results show the feasibility of the p-FSR using a signal transmitted from a satellite to detect flying drone crossing the forward-scatter baseline between the satellite and ground station.

1 June 2019
Verified
Conference Paper
Closed access
Surajo MusaSurajo Musa
Surajo Musa
RARaja Syamsul Azmir Raja Abdullah
Raja Syamsul Azmir Raja Abdullah
ASADUWATI SALI
ADUWATI SALI
Alyani IsmailAlyani Ismail
Alyani Ismail
NRNur Emileen Abd Rashid
Nur Emileen Abd Rashid

26 September 2019 in The Journal of Engineering
Verified
Journal Article
Open access
PDF file
Surajo MusaSurajo Musa
Surajo Musa
RARaja Syamsul Azmir Raja Abdullah
Raja Syamsul Azmir Raja Abdullah
ASAduwati Sali
Aduwati Sali
AIAlyani Ismail
Alyani Ismail
NRNur Emileen Abd Rashid
Nur Emileen Abd Rashid
Drone inexpensive and operational flexibility contributed to its exponential increase by civil users, apart from military applications. This resulted in posing threats due to drone misuses, such as smuggling, unlawful imaging and other significant vulnerability that makes its detection necessary. The study demonstrated a theoretical model of extracting the m ‐Doppler signature due to rotating blades of a quadcopter drone, in forward scattering radar (FSR) geometry. The model was further validated experimentally by using a parabolic dish antenna in the receiver system of the FSR geometry. Before these, some reported efforts made to detect the drone by using different methodologies such as acoustic, video, audio‐visual, radio frequency, radar systems and other non‐technical approaches like netting were briefly presented. The result of the authors’ investigation revealed that the drone could be detected from the signature generated due to rotating blades based on the blade orientation. This signature can further be used to identify the drone from other flying targets existing within the same surveillance area.

22 December 2025 in IEEE Sensors Journal
Verified
Journal Article
Closed access
SGSaad Hayatu Girei
Saad Hayatu Girei
Norita Mohd YusoffNorita Mohd Yusoff
Norita Mohd Yusoff
Mohammed AlkhabetMohammed Alkhabet
Mohammed Alkhabet
Surajo MusaSurajo Musa
Surajo Musa
MAMohammed Thamer Alresheedi
Mohammed Thamer Alresheedi
MYMohd Yaacob
Mohd Yaacob
In this study, a high-performance ammonia (NH3) gas sensor has been successfully developed using an optical microfiber fiber as a sensing platform and hydrothermally grown zinc oxide (ZnO) nanorods as sensitive material. The nanostructure and properties of the ZnO nanorods wre inspected using various material characterization techniques. The influence of growth duration on the formation of ZnO nanorods and its response to NH3 was studied. The obtained result reveals that growth duration is proportional to the length of nanorods, with length increased by 256% from 2 hours to 8 hours of growth time. The NH3 sensing response was studied by varying gas concentrations from 0.04 to 1.0% at an optimum operating temperature of 150°C. The ZnO nanorods with a growth duration of 6 hours corresponding to sensor ZNR6 with a thickness of 750 nm show a higher sensing response than other sensors. The properties of a high surface-to-volume ratio of the ZnO nanorods and light coupling capability into the nanorods arrays provide an enhanced interaction between the sensor and NH3 molecules. This work shows that hydrothermally grown ZnO nanorod is a promising candidate for the fabrication of high-performance and cost-effective optical fiber sensors for NH3 gas. Furthermore, this result may contribute to the optimal growth duration of ZnO nanorods for NH3 gas sensing applications.