Valentina Iacono

Ms. Valentina Iacono

University of Catania, Catania, Sicilia, Italy
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 January 2022 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
MCMaria Censabella
Maria Censabella
Valentina IaconoValentina Iacono
Valentina Iacono
Antonino ScandurraAntonino Scandurra
Antonino Scandurra
KMKaveh Moulaee
Kaveh Moulaee
GNGiovanni Neri
Giovanni Neri
SMSalvatore Mirabella
Salvatore Mirabella

13 March 2023 in Physica Status Solidi (b)
Verified
Journal Article
Open access
Valentina IaconoValentina Iacono
Valentina Iacono
SMSalvo Mirabella
Salvo Mirabella
Francesco RuffinoFrancesco Ruffino
Francesco Ruffino
Electrochemical water‐splitting, sustained by renewable energy, is aimed at green H2 production. Efficient and sustainable electrocatalysts are required for a proper energy transition. Oxygen evolution reaction (OER) in alkaline electrolyte can be pursued by using earth‐abundant elements‐based catalysts, such as Ni oxyhydroxides. A proper optimization of intrinsic properties and synthesis procedure is still needed. Herein, the synthesis of Ni/NiO nanoparticles (NPs) through a physical and green technique, pulsed laser ablation in liquid (PLAL), is presented. Ablating a Ni target in deionized water, at different ablation times, leads to NP dispersions used for realization of OER electrode onto graphene paper. Ion‐beam analysis of catalysts amount and homogeneity of NP‐based electrode is performed for the electrode optimization in terms of electrochemical performances. An overpotential at 10 mA cm−2 of 306 mV is achieved for 40 μg cm−2 of catalyst, while lowering the catalyst amount to 8 μg cm−2, unprecedented turnover frequency of 0.20 s−1 and mass activity of ≈1.3 A mg−1 are reached. These data show that Ni/NiO NPs produced by PLAL are highly effective for OER in alkaline media and encourage the use of PLAL as a green and efficient technique for electrocatalyst production.

Verified
Journal Article
Open access
PDF file
SBStefano Boscarino
Stefano Boscarino
Valentina IaconoValentina Iacono
Valentina Iacono
AMAndrea Lo Mastro
Andrea Lo Mastro
FTFiorella Tringali
Fiorella Tringali
Antonio TerrasiAntonio Terrasi
Antonio Terrasi
Francesco RuffinoFrancesco Ruffino
Francesco Ruffino
Cu nanoparticles were produced by using solid-state dewetting (dry) of a 1.3 nm Cu layer or laser ablation of a Cu solid target (wet) in acetone and methanol. The morphology and chemical composition of the nanoparticles were investigated as a function of the synthesis methods and their key parameters of the annealing temperature (200–500 °C) and the liquid environment during the ablation. Cu nanoparticles were then embedded in transparent conductive oxide (TCO) films as aluminum-doped zinc oxide (AZO) or zirconium-doped indium oxide (IZrO); the TCObott/Cu nanoparticle/TCOtop structures were synthesized with all combinations of AZO and IZrO as the top and bottom layers. The goal was to achieve a plasmonic and conductive structure for photovoltaic applications via a comparison of the involved methods and all fabricated structures. In particular, solid-state dewetting produced faceted or spherical (depending on the annealing temperature) nanoparticles with an average size below 150 nm while laser ablation produced spherical nanoparticles below 250 nm. Dry and wet plasmonic conductive structures as a function of the TCOs employed and the temperature of annealing could reach a sheet resistance of 86 Ω/sq. The energy band-gap Egap, absorbance, transmittance, and reflectance of the plasmonic conductive structures were investigated in the UV–vis–NIR range. They showed a dependence on the sequence of the top and bottom TCO, with best transmittances of 89.4% for the dry plasmonic conductive structure and 84.7% for the wet plasmonic conductive structure. The latter showed a higher diffused transmittance of between 10–20% in the visible range.

1 November 2023 in APL Materials
Verified
Journal Article
Open access
PDF file
Valentina IaconoValentina Iacono
Valentina Iacono
CPCristiano Lo Pò
Cristiano Lo Pò
Silvia ScaleseSilvia Scalese
Silvia Scalese
SBS. Boninelli
S. Boninelli
GCGuglielmo Condorelli
Guglielmo Condorelli
Francesco RuffinoFrancesco Ruffino
Francesco Ruffino
In the field of sustainability, hydrogen (H2) is considered a clean fuel and a renewable energy source with no pollutant emissions. The production of H2 by water electrolysis is well-known among the scientific community. Still, alkaline electrolysis represents a challenging process and requires expensive materials have to be avoided in order to lower the impact of H2 production. This work deals with the production of copper (Cu) and nickel (Ni) nanoparticles (NPs) as catalysts for alkaline water splitting reactions. These NPs are synthesized using the pulsed laser ablation in liquid involving the ablation of Cu and Ni targets in methanol and ethanol. The morphological, structural, and compositional properties of the obtained NPs are studied. Then, a low amount of NPs-based catalyst (∼1μg/cm2) was loaded onto a nickel foam substrate and tested for both alkaline Hydrogen Evolution Reaction (HER) and Oxygen Evolution Reaction (OER). The best performance at 10 mA cm−2, in terms of overpotential (η), for OER was shown by Ni NPs, η = 327 mV, while for the HER, Cu NPs reached η = 211 mV at 10 mA cm−2 in aqueous 1M KOH. The ultra-low amount of the catalyst material makes these electrodes challenging in terms of mass activity [up to 14 A/mg at 10 mA cm−2] compared to the state of the art. In addition, the correlation between overpotential and the availability of electrons at the surface of the catalyst for H2 production was studied by using Mott–Schottky analysis.

6 December 2023 in Micromachines
Verified
Journal Article
Open access
PDF file
CPCristiano Lo Pò
Cristiano Lo Pò
Valentina IaconoValentina Iacono
Valentina Iacono
SBStefano Boscarino
Stefano Boscarino
Maria Grazia GrimaldiMaria Grazia Grimaldi
Maria Grazia Grimaldi
Francesco RuffinoFrancesco Ruffino
Francesco Ruffino
How nice would it be to obtain the size distribution of a nanoparticle dispersion fast and without electron microscope measurements? UV-Vis-NIR spectrophotometry offers a very rapid solution; however, the spectra interpretation can be very challenging and needs to take into account the size distribution of the nanoparticles and agglomeration. This work suggests a Monte Carlo method for rapid fitting UV-Vis-NIR spectra using one or two size distributions starting from a dataset of precomputed spectra based on Mie theory. The proposed algorithm is tested on copper nanoparticles produced with Pulsed Laser Ablation in Liquid and on gold nanoparticles from the literature. The fitted distribution results are comparable with Transmission Electron Microscope results and, in some cases, reflect the presence of agglomeration.

24 April 2023 in APL Energy
Verified
Journal Article
Open access
PDF file
Valentina IaconoValentina Iacono
Valentina Iacono
mario scuderimario scuderi
mario scuderi
MAMaria Laura Amoruso
Maria Laura Amoruso
Antonino GulinoAntonino Gulino
Antonino Gulino
Francesco RuffinoFrancesco Ruffino
Francesco Ruffino
SMSalvo Mirabella
Salvo Mirabella
Efficient and sustainable materials are requested to overcome the actual major issues related to green energy production. Ni/NiO nanoparticles (NPs, 2–4 nm in size) produced by Pulsed Laser Ablation in Liquid (PLAL) are reported as highly efficient and stable electrocatalysts for oxygen evolution reaction (OER) in water splitting applications. Ni/NiO NPs dispersions are obtained by ablating a Ni target immersed in deionized water with an Nd:YAG nanosecond pulsed laser. NPs size and density were driven by laser energy fluence (ranging from 8 to 10 J cm−2) and shown to have an impact on OER performance. Ni/NiO NPs were characterized by scanning and transmission electron microscopy, x-ray diffraction, photoemission spectroscopy, and Rutherford back-scattering spectrometry. By drop-casting onto graphene paper, anode electrodes were fabricated for electrochemical water splitting in alkaline electrolytes. The extrinsic and intrinsic catalytic performances for OER have been quantified, achieving an overpotential of 308 mV (at a current density of 10 mA cm−2) and unprecedented mass activity of more than 16 A mg−1, using NPs synthesized with the highest and lowest laser energy fluence, respectively. The impact of NPs’ size and density on OER performances has been clarified, opening the way for PLAL synthesis as a promising technique for highly efficient nano-electrocatalysts production.